Zenith LST 3510A Diagram

11

INTRODUCTION

Connection Panel Overview

Do not touch the inner pins of the jacks on the rear panel.
Electrostatic discharge may cause permanent damage to the unit.

AC Power Cord

Plug into the power source.

ANT LOOP OUT

RF output to TV’s “Antenna In” jack or other devices.

DIGITAL AUDIO OUT (OPTICAL)

Connect to digital (optical) audio equipment.

DIGITAL AUDIO OUT (COAXIAL)

Connect to digital (coaxial) audio equipment.

VIDEO OUT

Connect to a TV with video inputs.

COMPONENT VIDEO OUT

Connect to a TV with YPbPr inputs.

AUTHORIZED SERVICE ONLY

Is used only for authorized service purposes.

ANT IN

Connect to HDTV signal source; external/internal antenna.

S-VIDEO OUT

Connect to a TV with S-Video inputs.

DVI-HDTV OUT

Connect to a TV with DVI connector.

Variable “volume” AUDIO OUT (Left/Right)

Connect to a TV, amplifier, receiver or stereo system.
You can adjust the volume of this audio out on DVD/HDTV Receiver.

Fixed “volume” AUDIO OUT (Left/Right)

Connect to a TV, amplifier, receiver or stereo system.
You can not adjust the volume of this audio out on DVD/HDTV Receiver.

RGB OUT

Connect to a TV with RGB inputs.