Zeeva Electronics Private MA 1600 User Manual

IMPULSE 2.PRO Headphones
Padded Protective Soft Case
Micro USB Charging Cable
Audio Cable
User Manual & Warranty

User Manual and Warranty

FEATURES STORY

VOL. UP

ON / OFF

PAIRING

VOL. DOWN

3.5 MM AUDIO JACK

CHARGING PORT

VINTAGE TREATED HEADBAND WITH
EXTENSION BAR

DETACHABLE CABLE WITH
IN-LINE MICROPHONE AND
QUICK RESPONSE BUTTON

IN-LINE MICROPHONE

QUICK RESPONSE BUTTON

Functions vary depending on your phone, tablet
or application.

PRODUCT SPECIFICATIONS

Bluetooth
Bluetooth transmitter
frequency range
Bluetooth transmitter
modulation
Bluetooth profiles
Bluetooth
transmission power
Connectivity class

High performance
driver

4.2

2.402-2.480 GHz

GFSK π/4 DQPSK

A2DP, AVCTP, AVDTP,
HFP, AVRCP
4 dBm maximum
Bluetooth Class 2
(10 meter)
2 x Ø40 mm

Amplifier power
Frequency response
Sensitivity
input power
Standard input power
Impedance
Signal to noise ratio
Charging method
Battery type

Battery capacity
Play time
Recharge time
Dimensions

2*20 mW
20 Hz-20 kHz
105 +/- 3 dB at 1kHz
50 mW
30 mW
32 Ω
> 94 dB
Micro USB charging
Lithium-ion polymer
battery
300 mAh
15 hours, volume at 70%
2 hours
174 x 174 x 75 mm

OPERATE YOUR HEADPHONES

Bluetooth Connection

Devices with Bluetooth 4.2 wireless technology
equipped computers, smartphones, and MP3 players.

To use Bluetooth for your audio connection, first
pair IMPULSE 2.PRO with your audio source
(music player, smartphone, laptop or other
Bluetooth equipped device that can act as audio
source). Make sure IMPULSE 2.PRO is fully
charged and turn it on by press and hold the
Power button for 3 seconds. Once the power is
turned on, IMPULSE 2.PRO is in Bluetooth pairing
mode. You can hear a voice notification – “Power
on, pairing” and the LED indicator is blinking in
red / blue quickly. Make sure Bluetooth is enabled

on your audio source and in a few moments
“MUVEACOUSTICS: IMPULSE 2.PRO” will appear
on your list of possible Bluetooth connections.
Press “pair” or “connect” on your device and after
the connection is made, the LED indicator will
turn to steady blue and you can hear “Connected”.
Then your device is paired.

From now on, when you turn on IMPULSE 2.PRO,
it will automatically search for the last Bluetooth
device it was paired with.

While there is no pairing with Bluetooth device
within 5 minutes, IMPULSE 2.PRO will turn off
automatically with a voice notification – “Power off”
and you need to switch on again for further use.

Battery Charging

Please use the cable provided to recharge the
headphones. It will take 2-2.5 hours to fully charged.

Wired Connection

IMPULSE 2.PRO has a 3.5mm audio in jack. If there
is no Bluetooth source available or if you simply
prefer a wired connection, you can connect your
IMPULSE 2.PRO directly to your audio source
using a stereo male 3.5mm connection.

IMPULSE 2.PRO headphones comes with audio
cable included. Control and talk functions vary
depending on your phone, tablet or application.

OPERATIONAL GUIDANCE

Function Button Audio
Power on
the
headphone
Standby
(not
connected
with
smartphone)
Standby
(connected
with
smartphone)
Playing

Press and hold
the Power button
for 3 seconds
N/A

N/A

N/A

Power
On

Pairing

N/A

N/A

LED
Blue light goes
on for 1 second

Red / blue
light flashing

Steady blue
light

Blue light
flashing once
every 5 seconds

Function Button Audio
Phone call
in progress

Redialling

Incoming
call

End a call

Refuse
incoming
call
Battery
level is low

N/A

Press the Power
button twice
Press the Power
button once

Press the Power
button once
Press and hold
the Power button
for 2 seconds
N/A

N/A

Last Number
Redial
with tone

with tone

with tone

Battery Low

LED
Blue light
flashing
thrice every 3
seconds
N/A

Blue light
flashing
thrice every 3
seconds
N/A

N/A

N/A

Function Button Audio
Increase
volume

Decrease
volume

Play / pause

Previous
song

Next song

Press and
release the "+"
button quickly
Press and
release the "-"
button quickly
Press the
Play/Pause
button once
Press and hold
"-" button to
skip to
previous song
Press and hold
"+" button to
skip to
next song

with
maximum
volume alert
N/A

N/A

N/A

N/A

LED
N/A

N/A

Blue light
steady when
paused
N/A

N/A

JOIN THE COMMUNITY

Sign up now for

• special offers

• events

• access to new products launch

www.muveacoustics.com/community

• contests

TBC

Thank you for trusting MuveAcoustics with

delivering you excellence in sound. We
encourage you to connect with us and

become a part of our community!

SCAN THE QR CODE YOU WILL FIND

INSIDE. SHARE WITH US YOUR

PRODUCT EXPERIENCE.

www.muveacoustics.com

SAFETY INSTRUCTIONS

Warnings
∙

Contains small parts which may be a choking
hazard. Not suitable for children under age three.

∙

Set a low volume setting before using the
headphones.

∙

Long-term exposure to loud music or sounds
may cause hearing damage. It is best to avoid high
volume levels when using these headphones,
especially for extended periods.

∙

Do not use these headphones when operating
a motor vehicle, a bicycle, machinery or where
your inability to hear outside sounds may
present a danger to you or others.

Cautions
∙

Using these headphones limits your ability to hear

noises around you, regardless of listening volume.
Please use caution when using these headphones.
Do not drop, sit on, or allow the headphones to

∙

be immersed in water.

This symbol indicates that this product
shall not be treated as household waste.
Instead it shall be handed over to the
applicable collection point for the recycling
of electrical and electronic equipment.

Unsuitable for children under three years
because it might, for instance, contain
small parts.

To prevent possible hearing damage, do not
listen at high volume levels for long periods.

The input voltage to the product is 5V 1A.
In order to charge the product in safe
manner and reliable conditions, please
only adopt certified appropriate charger /
adapter for charging the product.
Only charge the product at ambient
temperatures between 10 deg °C / 50
deg °F and 40 deg °C / 104 deg °F.
Do not heat above 70 deg °C / 158 deg °F,
eg. Do not expose to sunlight or throw
into fire.
Switch off the product after use.
Please note that we won’t take any
responsibility for any wrong operation
(eg. Voltage higher than 5V) as this may
result in severe injury or loss of property,
and we cannot control the operating
process during the time the user using

this product.
In extreme cases, abuse or misuse of
Lithium battery pack can lead to explosion,
heat generation, fire development or
smoke development.

FCC Statement

NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference

will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

­Increase the separation between the

­equipment and receiver.
Connect the equipment into an outlet on a

­circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV

­technician for help.

Changes or modifications not expressly approved

by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.

This device has been tested and complies with
part 15 of the FCC rules.
FCC ID: 2ANVW-MA-1600

ONE-YEAR LIMITED WARRANTY

MUVEACOUSTICS IMPULSE 2.PRO headphones
have been subjected to a thorough series of tests
to ensure the highest level of dependability. It is
unlikely that you will experience any problem,
but if a defect should become apparent during
the use of this product, MUVEACOUSTICS
warrants to the original purchaser that this
product will be free from defects in material and
workmanship for a period of 12 months from the
date of your original purchase from an
authorized dealer. If a defect covered by this
warranty occurs, MUVEACOUSTICS, at its option,
will repair or replace the product purchase at no
repair charge (postage charges will apply). If a

replacement is necessary and your product is
no longer available, a comparable product
may be substituted at the sole discretion of
MUVEACOUSTICS.

This warranty does not cover normal wear and
tear, abusive use or misuse, modification,
tampering or by any other cause not related to
either materials or workmanship. This warranty
does not apply to product used for any industrial,
professional or commercial purposes.

CUSTOMER SERVICES

For service on any defective under 12
months warranty policy, please contact
Consumer Support.

Email: [e-mail]

Keep all relevant information for future reference

Distributed by
Zeeva International Limited.
All Rights Reserved.

Suite 1006C-8, 10th Floor,
Exchange Tower, 33 Wang Chiu Road,
Kowloon Bay, Hong Kong

www.zeeva.com

1804103