Zeeva Electronics Private MA 1020 User Manual

INCLUDES:

DC IN

EDGE Wireless In-Ear Earphones
Padded Protective Soft Pouch
Micro USB Charging Cable
Extra Ear Cushions & Ear Hooks
Cable Clip
User Manual & Warranty

User Manual and Warranty

FEATURES

ERGONOMIC
DESIGN

IN-LINE
MICROPHONE
AND
CHARGING
PORT

Functions vary depending on
your phone, tablet or application.

PRODUCT SPECIFICATIONS

Bluetooth
Bluetooth profiles
Connectivity class
High performance driver
Frequency response
Sensitivity
Impedance
Signal to noise ratio
Charging method
Battery type
Battery capacity
Play time

Recharge time
Water proof standard
Dimensions

4.2
HFP, HSP, A2DP, AVRCP
Bluetooth Class 2 (10 meter)
2 x Ø6 mm
20 Hz - 20 kHz
99 +/- 3 dB at 1kHz
16 Ω
≥ 57 dB
Micro USB charging
Lithium-ion polymer battery
110 mAh
up to 7 hours

level and audio content)

2 hours
IPX-4
25 x 580 x 32 mm

(varies by volume

OPERATIONAL GUIDANCE

Function Button Audio

Power on
the
earphone

Standby
(not
connected
with
smartphone)
Standby
(connected
with
smartphone)
Pairing

Press and hold
the Power
button for 3
seconds
N/A

N/A

Press and hold
the Power
button for 6
seconds (when
earphones is off)

Power On

N/A

N/A

Pairing

LED

Blue light
goes on for
1 second

Blue light
flashing
twice every
1 second

Blue light
flashing
once every
5 seconds
Blue and
red light
flashing
alternatively

OPERATIONAL GUIDANCE

Function Button Audio

Pairing
success

Phone call
in progress

Voice
Dialing

Redialling

Incoming
call

N/A

N/A

Press the Power
button for 1
second and
then release
Press the Power
button twice
Press the Power
button once

Your
device is
connected

N/A

with tone

with tone

with tone

LED

Blue light
flashing
once
every
5 seconds
Blue light
flashing
once every
3 seconds
N/A

N/A

Blue light
flashing
quickly

OPERATIONAL GUIDANCE

Function Button Audio

Refuse
incoming
call

End a call

Mute the
microphone
during a
phone call
Play / pause

Listening
music

Press and hold
the Power
button for 2
seconds
Press the
Power button
once
Press
"+" and "-" key
simultaneously
once
Press the
Play/Pause
button once
N/A

with tone

with tone

with tone
for every 10
seconds

N/A

N/A

LED

N/A

N/A

N/A

N/A

Blue light
flashing
once every
5 seconds

OPERATIONAL GUIDANCE

Function Button Audio

Increase
volume

Decrease
volume
Previous
song

Next song

Disconnect
Bluetooth
connection
Battery
level is low

Press "+" button
repeatedly

Press "-" button
repeatedly
Press and hold
the "-" button
for 1 second
Press and hold
the "+" button
for 1 second
N/A

N/A

with
maximum
volume alert
N/A

N/A

N/A

Your device is
disconnected

Battery Low

LED

N/A

N/A

N/A

N/A

N/A

Red light
flashing
once every
5 seconds

OPERATIONAL GUIDANCE

Function Button Audio

Battery
charging
mode
Battery has
been fully
charged
Power off
the
earphone
Reset

N/A

N/A

Press and hold
the Power button
for 3 seconds
Press "+" and "-"
button for 5
seconds when
earphones is in
standby mode
or not connected
with smartphone

N/A

N/A

Power Off

with tone

LED

Red light
goes on
constantly
Blue light
goes on
constantly
Red light
goes on for
1 second
N/A

CUSTOMER SERVICE

For any service or technical queries,
please contact our service team on the
below email.

Email: [e-mail]

Keep all relevant information for future reference

Imported and distributed by
Zeeva Electronics Private Limited.
All rights reserved

901-902, Trade World C wing
Kamla Mill Compound,
Senapati Bapat Marg,
Lower Parel West,
Mumbai-400013

1832023

JOIN THE COMMUNITY

SIGN UP to receive

∙ Special Offers!

∙ Access to Events!

∙ Contests!

∙ News on new products launched

www.muveacoustics.com/community

Thank you for trusting MuveAcoustics

with delivering you excellence in sound.

We encourage you to connect with us

and become a part of our community!

SCAN THE QR CODE YOU WILL FIND INSIDE.
SHARE WITH US YOUR PRODUCT EXPERIENCE.

www.muveacoustics.com

Bluetooth Connection

Devices with Bluetooth 4.2 wireless technology or
above, such as Bluetooth wireless technology
equipped computers, smartphones, tablets and
MP3 players. To use Bluetooth for your audio
connection pair EDGE with your audio source
(music player, smartphone, laptop, or other
Bluetooth equipped device that can act as a source
of music). First turn on your Bluetooth connection
on your device, then press and hold the Power
button for 4 seconds until you hear ‘Pairing’. The
EDGE is in pairing mode. The blue and red Sync
LED will blink. Make sure Bluetooth is enabled
on your audio source and in a few moments
“MUVEACOUSTICS:EDGE” will appear on your list of
possible Bluetooth connections. Press “pair” or
“connect” on your device and when the connection
is made you will hear “Your device is connected”.
You are paired. From now on, when you turn on
EDGE, it will automatically search for the last
Bluetooth device it was paired with.

Battery Level and Charging

EDGE comes with lithium-ion polymer battery.
For best results, fully charge EDGE before use. It will
take 2 hours to fully charged. When the battery
voltage is low, red light replaces blue light with
voice notification “Battery Low” every 2 minutes.
EDGE will automatically shut off, after disconnected
or no pairing with Bluetooth enabled device for 10
minutes or when the battery power level is very low.
Please use the cable provided to recharge the
earphones. Red LED light up during charging and it
will turn blue once fully charged.

SAFETY INSTRUCTIONS

Warnings
∙

Contains small parts which may be a choking
hazard. Not suitable for children under age three.

∙

Set a low volume setting before using the earphones.

∙

Long-term exposure to loud music or sounds may
cause hearing damage. It is best to avoid high
volume levels when using these earphones,
especially for extended periods.

∙

Do not use these earphones when operating a
motor vehicle, a bicycle, machinery or where your

inability to hear outside sounds may present a
danger to you or others.

Cautions
∙

Using these earphones limits your ability to hear
noises around you, regardless of listening volume.
Please use caution when using these earphones.

∙

Do not drop, sit on, or allow the earphones to be
immersed in water.

This product shall not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment.

Unsuitable for children under three years because
it might, for instance, contain small parts.

To prevent possible hearing damage, do not listen
at high volume levels for long periods.

The input voltage to the product is 5V 1A.
In order to charge the product in safe manner and
reliable conditions, please only adopt certified
appropriate charger / adapter for charging the product.
Only charge the product at ambient temperatures
between 10 deg °C / 50 deg °F and 40 deg °C / 104 deg °F.

Do not heat above 70 deg °C / 158 deg °F, eg. Do not
expose to sunlight or throw into fire.
Switch off the product after use.
Please note that we won’t take any responsibility
for any wrong operation (eg. Voltage higher than
5V) as this may result in severe injury or loss of
property, and we cannot control the operating
process during the time the user using this product.
In extreme cases, abuse or misuse of Lithium
battery pack can lead to explosion, heat
generation, fire development or smoke development.

FCC Statement

NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-

Reorient or relocate the receiving antenna.

-

Increase the separation between the equipment
and receiver.

-

Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.

-

Consult the dealer or an experienced radio / TV
technician for help.

Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

FCC ID: 2ANVW-MA-1020

ONE-YEAR LIMITED WARRANTY

MUVEACOUSTICS EDGE earphones have
been subjected to a thorough series of
tests to ensure the highest level of
dependability. It is unlikely that you will
experience any problem, but if a defect
should become apparent during the
use of this product, MUVEACOUSTICS
warrants to the original purchaser that
this product will be free from defects in
material and workmanship for a period
of 12 months from the date of your
original purchase from an authorized
dealer. If a defect covered by this occurs,
MUVEACOUSTICS, at its option, will repair

or replace the product purchase at no
repair charge (postage charges will
apply). If a replacement is necessary and
your product is no longer available, a
comparable product may be substituted
at the sole discretion of MUVEACOUSTICS.

This warranty does not cover normal
wear and tear, abusive use or misuse,
modification, tampering or by any other
cause not related to either materials or
workmanship. This warranty does not
apply to product used for any industrial,
professional or commercial purposes.