Zeeva SP0272 User Manual

WOODEN

WIRELESS SPEAKER

Instruction Manual

Congratulations, and thank you for choosing
the Wooden Wireless Speaker. This manual
will help you operate the Wooden Wireless
Speaker, but you should first familiarize
yourself with the Bluetooth functionality of
your mobile phone or other devices before
using the Wooden Wireless Speaker.

wireless speaker,

1X Wooden Wireless Speaker

1X 3.5mm Audio Cable

1X Mini USB Cable

1X Instruction Manual

devices

Plug the Mini USB to the
port.

SP-0272

FCC ID:2ADM5-SP0272

To use your wireless speaker, you must
first p ai r yo ur s peaker with a phone o r a
compute r. Once y our wireless speake r is
paired to a specif ic mobile phone, t hey will
remain paired and automati cally recogni ze
each other w henever the

• Turn on your phone and ensure i ts
Bluet ooth functio n is acti vated.

• Turn on th e speaker go to the pairin g
mode.

• Search your B luetoot h device on your
phone by following the phone’s instructions.

Refer t o your phone's user m anual for
more inf ormation.

• Afte r a few sec ond the phone will list

the “ MERKURY SPB97” as a discoved
device. Sel ect it an d follow your
phone instruct ion to se lect this pai ring.

• Your phone will conf irm the pairi ng, and

then press Yes/Ok.

• Fi nally, sel ec t to connect w ith

wireless speaker from your phone.

y are wit hi n range.

Use the Mini USB cable accessory provided
with this speaker. Connect the Mini USB plug
to the Mini USB charging port on the speaker
positioned at in speaker diagram on page 2.
Connect the USB plug to a USB port on a
computer or wall adapter to activate
charging.

Mini USB Plug

wireless speaker.

wireless speaker.

wireless speaker,

wireless speaker

72mm*2

Li-ion battery

1200 mAh

4.1

POWER INPUT OUTPUTDC IN 5V

OFF ON

LED indicator

LED indicator

3.5mm output port

Mini USB port

3.5mm input port
On/O switch

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.