
CORE
WIRELESS EARBUD
INSTRUCTION MANUAL
Thank you for purchasing the Core Wireless Earbud.
This manual provides more information about the wireless earbud,
please read the instructions before using.
Product Overview
Earbud
1
Charging Case
8
2
3
5
1. Microphone
2. On/Off Button/
Play/Pause Music
Answer/End Call
3. Earbud LED Indicator
4. Magnetic Charging Port
5. Charging Case Cover
6. Charging LED Indicator
7. Charging Port
9
8. Charging Output LED Indicator
9. Charging On/Off Button
Package Contents
Core Wireless Earbud x 1
Portable Charging Case x 1
Micro USB Cable x 1
Instruction Manual x 1
Technical Specification
4
6
7
• WIRELESS EARBUD
Driver Diameter: 8 mm
Impedance: 16 Ohms
Frequency Response: 20Hz-20KHz
Sensitivity: 96 dB +/-3 dB
Power Supply: Li-ion Battery 3.7V 45 mAh
Playing Time: 1 - 1.5 hours
Charging Time: 1.5 hours
Bluetooth Range: 32.8 Feet
Micro USB Cable Included
Power On/Off
Power On
Press and hold down the On/Off Button for 3 seconds and the earbud LED
will flash with Red/Blue.
Power Off
Press and hold down the On/Off Button for 4 seconds and the earbud LED will
turn off.
• PORTABLE CHARGING CASE
Power Supply: Li-ion Battery 3.7V 200 mAh
Pair the wireless earbud with your mobile device
1. Keep the distance between your wireless earbud and mobile phone
(or other devices) within 32.8 Feet.
2. Power on the wireless earbud.
3. Activate the Bluetooth function on your phone within range and select
“BT CORE EARBUD” from the list shown.
4. The earbud LED blinks in blue when paired successfully.
Attention: If the pairing is not successful within 3 minutes, the earbud will
power off, please repeat the pairing procedures to try again.
Reconnect the wireless earbud to your mobile device
When powered on, the wireless earbud will automatically connect with the last
successfully paired device.
Disconnect the wireless earbud from your mobile device
Power off the wireless earbud; or
Switch off the Bluetooth on your mobile phone; or
Leave the earbud 60ft away from your mobile phone or further.
Answer / Reject a call
When you receive a call, press the earbud On/Off Button once to accept the call,
or answer the call normally via your mobile phone.
Long press earbud On/Off Button to reject a call.
End a call
Press the earbud On/Off Button once to end the call or hang up your mobile phone.
Charging your Earbud with Charging case
Put earbud to charging case and press the charging On/Off button to start charging.
Earbud LED indicator light turns red when charging your earbud
Earbud LED indicator light turns off when your earbud are fully charged
FAQ
If the wireless earbud cannot be paired with your device,
please try the following:
Ensure that your earbud are in pairing mode or reconnection mode
Ensure that Bluetooth search function of your mobile device is activated.
If the wireless earbud will not turn on:
Make sure the earbud are fully charged.
Can I change the battery for the earbud and charging case?
The wireless earbud and charging case use a built-in non-detachable battery which
cannot be removed.
If the wireless earbud and charging case cannot be recharged:
1. The earbud is put in the charging case properly.
2. The charging On/Off button is pressed and charging output LED indicator is on.
If you use a power outlet, ensure that the power supply is connected securely
and the outlet works. If you use a computer, ensure that it is connected and the
USB port is powered.
Safety instructions for the lithium battery and charging the product
- The input voltage to the charging case is 5V 1A.
- In order to charge the product in safe manner and reliable conditions, please
only adopt certified appropriate charger/ adapter for charging the product.
- Only charge the product at ambient temperatures between 10 deg °C/ 50 deg °F
and 40 deg °C/104 deg °F.
- Do not heat above 70 deg °C/158 deg °F, eg.
Do not expose to sunlight or throw into fire.
- Switch off the product after use.
- Please note that we won’t take any responsibility for any wrong operation (eg.
Voltage higher than 5V) as this may result in severe injury or loss of property, and
we cannot control the operating process during the time the user using this product.
- In extreme cases, abuse or misuse of Lithium battery pack can lead to
explosion, heat generation, fire development or smoke development.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Item# EP-0608
FCC ID: 2ADM5-EP-0608
Made Exclusively for Five Below
Distributed by Zeeva International Limited
Suite 1006C-8, 10th Floor, Exchange Tower,
33 Wang Chiu Road, Kowloon Bay,
Hong Kong, China
Keep All Relevant Information for Future Reference
Made in China