Zeeva EP0424 User Manual

SWIFT EARBUDS

WIRELESS EARBUDS WITH MICROPHONE

Thank you for purchasing the SWIFT Wireless Earbuds.

This manual provides more information about the wireless earbuds,

Earbuds Overview

USER MANUAL

please read the instructions before using.

Microphone

Vol+/Next Song

On/Off Button
Play / Pause Music
Answer / End Call

Vol-/Previous Song

Pair SWIFT Wireless Earbuds with your mobile device

1. Keep the distance between your wireless earbuds and mobile phone
(or other devices) within 32.8 Feet.

2. Power on the SWIFT Wireless Earbuds

Activate the Bluetooth function on your phone within range and select

3.
“Swift BT Earbud” from the list shown.

4. The LED blinks in blue when paired successfully.

Attention: If the pairing is not successful within 2 minutes, the earbuds will
power off, please repeat the pairing procedures to try again.

Reconnect SWIFT Wireless Earbuds to your mobile device

When powered on, the earbuds will automatically connect with the last
successfully paired device.

Disconnect the earbuds from your mobile device

Power off the earbuds; or
Switch off the Bluetooth on your mobile phone; or
Leave the earbuds 60ft away from your mobile phone or further.

Answer a call

When you receive a call, press the On/Off Button once to accept the call,
or answer the call normally via your mobile phone.

End a call

Press the On/Off Button once to end the call or hang up your mobile phone.

Technical specification

Bluetooth version: 3.0
Bluetooth operating range: 32.8 Feet
Frequency response: 20Hz - 20KHz
Playing time: 2-2.5hrs
Standby time: 50hrs
Fully charged time: 2hrs
Battery Capacity: 55mAh
Rechargeable Li-Ion Battery 3.7V

FAQ

If the SWIFT Wireless Earbuds cannot be paired with your device,
please try the following:

Ensure that your earbuds are in pairing mode or reconnection
mode. Ensure that Bluetooth search function of your mobile device is activated.

If the SWIFT Wireless Earbuds will not turn on:

Make sure the earbuds are fully charged.

Can I change the battery for the earbuds?

SWIFT Wireless Earbuds use a built-in non-detachable battery which
cannot be removed.

If the SWIFT Wireless Earbuds cannot be recharged:

If you use a power outlet, ensure that the power supply is connected securely
and the outlet works. If you use a computer, ensure that it is connected and the
USB port is powered.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.

FCC ID: 2ADM5-EP0424

Distributed by Five Below Merchandising, Inc.
1818 Market Street, Suite 2000
Philadelphia, PA. 19103
Visit us at www.fivebelow.com

Keep All Relevant Information for Future Reference