Zebra Technologies 21121559 User Manual

WA9901 - RFID MODULE UHF LINEAR (NA) ENDCAP H/W INSTALLATION SHEET

Important: All Approval and safety information is outlined in the ‘WORKABOUTPRO4 Regulatory & Warranty Guide – part number 8000296 provided with each WORKABOUTPRO4.

Warning: The WORKABOUTPRO4 with the RFID option must not be held closer than 20 cm from the rest of the body. This product must not be used in a holster or on a belt-clip. RFID cannot be

used in co-transmission with WAN module.

Sept 10, 2014

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark

Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

8073681 C

1. Product Description

Easily installable expansion modules for the WORKABOUT PRO4 allow you to customise this hand-held to meet your specific mobile computing requirements. This chapter outlines how to install the NA UHF Linear RFID Module.

The RFID MODULE UHF LINEAR (WA9901) kit is based on the Sailfish UHF module from

MOTOROLA Inc. (Model: 21-121559). It is made of 4 parts:

 ASSY MODULE UHF WAP4 NA  ASSY ANTENNA LINEAR NA WAP4  INSTRUCTION SHEET WAP4 UHF LINEAR NA  LABELS FCC WAP4 UHF LINEAR VARIANT

Figure 1-1 ASSY MODULE UHF WAP4 NA Figure 1-2 ASSY ANTENNA LINEAR NA WAP4

Figure 1-4 LABELS FCC WAP4

UHF LINEAR VARIANT

Figure 1-3 INSTRUCTION SHEET WAP4 UHF LINEAR NA

Sept 10, 2014

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark

Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

8073681 C

2. Product Installation

Before installing a module in the WORKABOUT PRO4, all power sources must be turned off.

 Remove the battery. If your unit is using AC power, disconnect it.

Figure 2-1 Battery location

With the power shut down, you can now install the NA RFID Module UHF Linear.

 Remove the existing endcap and pod or backplate

Figure 2-2 WAP4 Disassembled

Sept 10, 2014

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark

Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..

8073681 C

 Slide the RFID Module inside the back opening

Figure 2-3 RFID Module Assembly

 Drive the 4 screws that fix the RFID module on WAP4 frame

Figure 2-4 RFID Module Assembly

Sept 10, 2014

8073681 C

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark

Holdings, LLC and are used under license. All other trademarks are the property of their respective owners..