The following regulatory agency information is for model WLM54AG, which includes ZES
part number 26998.
RF Notice
Any changes or modifications to Zebra Enterprise Solutions (ZES) equipment not
expressly approved by ZES could void the user’s authority to operate the equipment.
FCC Compliance Statement
This device complies with Part 15 rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference; (2) this device mu st
accept any interference which may cause undesired operation.
FCC ID:
XWX-05WLM54AG
This equipment has been tested and found to comply with the limits for Class A devices,
pursuant to Part 15 of the FCC Rules & Regulations.
Canadian DOC Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 d u Canada.
IC:
8701A-05WLM54AG
Labeling
If the FCC and IC identification numbers are not visible when the module is installed
inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior lab el can use the
wording such as “Contains FCC ID: XWX-05WLM54AG” and “Contains IC: 8701A05WLM54AG”. Any similar wording that expresses the same meaning may be used.
This mini PCI adapter, P/N 26998, will be only installed in devices produced by Zebra
Enterprise Solutions Corp.
RF EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minim um distance
20cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
This mini PCI adapter is manufactured by Compex Systems. It contains a dual-mode single chip
MAC/BB/Radio for IEEE 802.11a, 11g, and 11b Wireless LAN. It can support high-speed data
transmission of up to 54 Mbps in the 2.4 GHz and 5 GHz frequency bands based on 802.11b/g and
802.11a mode respectively. Only 802.11b/g mode is used when the device is installed in ZES
products. This PCI adapter has been originally certified with 2-dBi dipole antenna by Compex. ZES
has re-certified this card with FCC and IC for use with higher gain antennas, which are listed in
section 3.
2 INSTALLATION
ATTENTION: The mini PCI card is sensitive to ESD. Perform the
following steps in ESD controlled areas and use applicable procedures
for handling ESD sensitive devices.
2.1 Ensure that the power to the host equipment is turned off. Connect the antenna
cable to connector marked MAIN on the card.