WA6003 SLIM POD IMAGER PISTOL GRIP WITH
TRIGGER INSTALLATION GUIDE
Introduction
WARNING! Installation of any components must be performed using appropriate anti-static devices. If unavailable, discharge
body static by touching a grounded metallic object before opening any covers on the hand-held.
The pistol grip carrying accessory helps operators work safely and comfortably with the Workabout Pro4.
IMPORTANT Do not use adhesives such as Loctite to secure the screws on carrying accessories. These chemicals may damage the
plastic casing.
The WA6003 pistol grip includes:
•
M2.6x5L Phillips head screws (x4)
•
Label SE655 Class 1 LED Slim Pod Warning label
IMPORTANT Prior to installation, make sure the trigger mechanism is securely snapped into the pistol grip body and that the trigger
operates properly.
1. With the scanner or imager slim pod attached, position the pistol grip so that it fits snugly over the back of the unit and the drill
holes in the pistol grip are aligned with those on the back of the unit.
2. Tighten the screws to a torque of 5.0 in-lbs (Imperial) or 0.56N-m (SI) to secure the pistol grip in place.
IMPORTANT The warning sticker that is already applied to the pistol grip is applicable to the SE965 and SE4500 slim pods only. If
your hand-held is equipped with an SE655 slim pod, you will need to apply the extra warning label (PN 1073216) in the
box over top of the label already applied to the pistol grip.
© 2016 Symbol Technologies LLC, a subsidiary of Zebra Technologies Corporation. All
rights reserved. Zebra and the stylized Zebra head are trademarks of ZIH Corp.,
registered in many jurisdictions worldwide. All other trademarks are the property of their
respective owners.
8000313-002 Rev A 7/16
Loading...