Zebra HDK Omnii HDK Breakout Board Instruction Sheet English

OMNIITM HDK BREAKOUT BOARD INSTRUCTION SHEET

1. Introduction

This document describes the contents of the Omnii breakout board kit, and how to prepare it for use.

2. Contents of the Breakout Board Kit

The breakout board kit for Omnii includes the following items:

• 1 breakout board

• 1 flex cable

• 1 DCE-DTE serial communication cable

• 1 USB patch cable

• 25 jumpers

• 4 standoffs

•4 screws

3. Preparing the Breakout Board

Before connecting the breakout board to the hand-held computer, install the standoffs included with the kit to keep the board
components safely suspended above the work surface. Align the standoffs under the holes in the four corners of the board, and
install a screw in each to secure them in place. Do not overtighten!

© Copyright 2010 by Psion Teklogix Inc.

This document and the information it contains is the property of Psion Teklogix Inc., is
issued in strict confidence, and is not to be reproduced or copied, in whole or in part,

November 12, 2010

8000224 Rev. A Sheet 1 of 1

4. Setting the Jumpers

The following table shows the breakout board jumper settings for the most common device applications. For more details on
these jumpers, and on how to use the breakout board, consult the Omnii HDK User Manual (P/N 8000210).

Jumper RS-232 UART GPIO USB

J3 • 1-2 1-2 1-2

J15 •

Power

J37 • 1-2 1-2 •
J38 • 1-2 1-2 1-2
J16 1-2 1-2 2-3 •
J17 1-2 1-2 2-3 •
J18 1-2 1-2 2-3 •
J19 1-2 1-2 2-3 •
J20 2-3 1-2 • •
J21 2-3 1-2 • •
J22 2-3 1-2 • •
J23 2-3 1-2 • •
J24 2-3 • 2-3 •

Data

J25 2-3 • 2-3 •
J26 2-3 • 2-3 •
J27 2-3 • 2-3 •
J41 • • 2-3 •
J43 2-3 • 1-2 •
J44 2-3 • 1-2 •
J45 2-3 • 1-2 •
J46 2-3 • 1-2 •

1-2 (3V3)
2-3 (5V0)

• - not applicable

••

COMPANY HEADQUARTERS SUPPORT SERVICES

Psion Teklogix Inc. For local support services, go to:
2100 Meadowvale Boulevard, Mississauga www.psionteklogix.com/service-and-support.htm
Ontario, Canada L5N 7J9
Tel: [phone]
Fax: [phone]