SINGLE SCALE DISPLAY
INSTALLATION GUIDE
To install a single Scale Display:
1. Unpack the new Scale Display from its packaging.
2. To replace an existing display from an old scanner:
a. Disconnect the Scale Display cable from the scanner.
b. Unscrew the Scale Display from checkout, then remove the Scale Display
and its cable(s).
c. If possible, install the Scale Display in the same location.
3. To install a new Scale Display:
a. Identify the location to install the Scale Display.
b. Install the Scale Display where it will not impede access to items being
scanned, PIN Pads, printer validation, paper slots, etc.
NOTE BOTHthecashierandcustomerneedtoseetheweightvalue
displayed.
4. There can be up to four different types of Scale Displays:
- Single Interval - kg
- Single Interval - lb
- Dual Interval - kg
- Dual Interval - lb
a. Place the proper Scale Display overlay on the Scale Display. Select an
overlay to ensure the proper required weight unit s (kg or lb), and paramete rs
EXACTLY match the scale parameters printed on the scale Weights and
Measures label (see Figure 1).
b. Remove the adhesive backing , and c arefully se cure the overlay on t he front
Weight units, and parameters on
overlay must match exactly.
face of the display.
Figure 1.
Zebra Technologies Corporation
Lincolnshire, IL U.S.A.
http://www.zebra.com
Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The Symbol logo is
a registered trademark of Symbol Technologies, Inc., a Zebra Technologies company.
© 2015 Symbol Technologies, Inc.
Scale Display Overlay Placement
MN000094A02 Revision A - February 2015
Loading...