8
A. TX Antenna (#58005)
B. Neck strap (#58311)
C. Trainer cord (#58318)
D. Switch harness (#57215S)
E. Heavy duty gold pin switch harness (#54407) This can be removed
F. Stick extensions (#56381)
G. Flight Preserver (#58480)
4. REPLACEMENT PARTS & ACCESSORIES
Congratulations again and have fun!
Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland,
Ireland, The Netherland, Italy, Spain,
Norway, Portugal, United Kingdom,
Luxembourg, Sweden, Switzerland
MADE IN THE PHILIPPINES
Zebra 3 FM Instruction Manual
The following is a listing of replacement parts and
accessories available for the Zebra radio series from your hobby dealer.
- Always turn your transmitter on first and off last.
- Never operate your system without first performing a proper range check.
- FCC regulation in the USA prohibits changing the crystal in your transmitter.
For channel changes send your system to an authorized service/repair center.
- Never fly around or over houses, people or power lines.
- Always charge your batteries before you fly.
- It's a good idea to check your receiver batteries with a tester
This will verify the charge level in your receiver batteries.
- Always fly responsibly and respect the rights of others.
- Make sure your frequency is clear before turning on your system.
5. PRECAUTIONS
Instruction Manual
2 3
Introduction
Thank you for purchasing the Zebra 3 FM digital proportional radio control system.
The Zebra 3 FM is easy to use and utilizes the latest in solid-state components for
unsurpassed reliability and performance. It is important that you read and understand this manual
before you operate your system.
CONTENTS
1. TRANSMITTER
A. Features
- Ergonomically designed 3 channel FM transmitter.
- Precision gimbals.
- Neutral position adjustment for throttle
- SMT circuitry
- Servo reversing on CH1, CH2.
- CH1, CH2 Mixing. (Aero only)
- SIC(Simulating Interface Cable) Compatible
- Easy to read 1 LED battery indicators.
- Size: 174 x 168mm (6.85 x 6.61 in)
- Weight: 330g
- Power supply: 7.2V (6 cell) NiCd or NiMh battery or 6cell Dry battery
B. Layout
TRANSMITTER
ANTENNA
CARRYING
HANDLE
L.E.D
INDICATOR
TRANSMITTER
CRYSTAL
Ch.2 THROTTLE
CONTROL STICK
NEUTRAL POSITION
ADJUSTMENT LEVER
THROTTLE
TRIM LEVER
STEERING
TRIM LEVER
Ch.1 STEERING
CONTROL STICK
POWER
ON/OFF SWITCH
Ch.3 Slide Switch
THROTTLE SERVO
REVERSE SHUNT SWITCH
CHARGING JACK
MIXING SHUNT SWITCH
(Aero Only)
SIC JACK(Aero Only)
STEERING SERVO
REVERSE SHUNT SWITCH
FRONT
BACK
Zebra 3 FM Instruction ManualZebra 3 FM Instruction Manual
1. Transmitter
a. Features
b. Layout
c. Servo Reversing
d. Mixing (Aero only)
e. Trim lever
f. Reading the LED Battery Indicator
2. Battery Installation
3. Operation
a. Installation of Receiver and Servos
b. Transmitter, Receiver and Servo Settings
c. Simulator System
d. Range checking
4. Replacement Parts & Accessories
5. Precautions
Page 2.
Page 3
Page 4.
Page 5.
Page 6.
Page 7.
Page 8.
Loading...