Zeagle ZX 50D, ZX Ds-iv User Manual

ZX 50D & ZX DS-IV Regulator
Owner’s Manual
This owner’s manual uses signal words recommended by the American National Standards Institute (see ANSI Z535.4) to des
­ignate levels of hazard seriousness. These signal words and their designations are as follows:
!
!
!
-
ations.
WARNING:
Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.
Note to European Customers:
The Zeagle ZX 50D, & ZX DS-IV
regulators are rated for operating temperatures above 10° C.
EN250:2000 Certification extends to 50 m.
Breathing air used in Zeagle Scuba regulators should meet European EN12021 standards.
Introduction – Safety Information
Limited Lifetime Warranty
Disclaimer and Limitation of Remedy
Cold Water Diving
Nitrox Use / First Stages
Dry Environmental Sealing / Second Stage Features
Resistance Control Knob / Dive/Pre-Dive Venturi Lever
Octopus Use / Pre-Dive Check
Post-Dive Care
Maintenance
Code Of The Responsible Diver
Specifications
Service Record
Pages
.2
.3
.4
.6
.7
.8
.9
.10
.11
.12
.13
.14
.15
.1
Congratulations on your Zeagle Regulator Purchase!
Your Zeagle Regulator has been designed and manufactured to the highest possible standards of performance and reliability. With the reasonable care outlined in this manual it will provide you with many years of diving enjoyment.
Since 1979, Zeagle Systems Inc. has been providing divers with Scuba equipment and Buoyancy Control Devices. Zeagle Systems and our worldwide network of authorized dealers are always ready to serve you. For more information on our products, and for the dealer nearest you, visit our web site at www.zeagle.com. Thank you for choosing Zeagle!
Safety Information
Read these instructions carefully before using your regulator, and keep this manual for future reference. Following the care and maintenance section at the end of this book
-
let will help ensure reliable service.
Model Differences
The primary difference between the 50-D and DS-IV models involves the Low Pressure port location on the 1st stage. The DS-IV is a fixed port model, meaning that the 1st stage LP ports are machined into the main body and do not move. The 50-D has a Swivel Turret on the first stage. The Swiveling Turret contains the LP ports and the diver can rotate the Turrent to position the hoses even when the regulator is pressurized. Both the DS-IV and the 50-D are coupled to the same ZX 2nd stage.
.2
.3
Limited Lifetime Warranty To The Original Owner
1. Your regulator is guaranteed against defects in materials and workmanship. This warranty does not cover normal wear, or damage from accident, abuse, neglect, alterations, improper usage, or failure to follow reasonable care and maintenance as outlined in this manual. Under this limited warranty, Zeagle will either repair or replace, at its sole option, any original equipment or parts that fail to perform as intended. Shipping and Labor charges are not included and must be paid by you. To validate your warranty, you must fill out and return your warranty registration card to Zeagle within 30 days of purchase. This Limited Lifetime Warranty excludes filters, hoses, O-rings, diaphragms and mouthpieces, which are warranted for two years from the regulator’s date of purchase. Filling out the card requires printing CLEARLY the serial numbers of both the first and second stages. You can also register your regulator at www.zeagle.com on the internet in the “Product Support” section. The first stage serial number is stamped on the DS-IV first stage
between the ports (fig. 1). The 50­D first stage is stamped on the top of the turret bolt. The second stage serial number is stamped on the
mouthpiece tube (fig. 2). To read this serial number you must fold back the flexible silicone mouthpiece
to expose the numbers. Each serial number consists of a prefix letter followed by six numbers. All of the digits of both the first and second stages must be CLEARLY printed on your warranty registration card for your warranty to be activated.
2. For proof of original ownership, you must save the original pur
­chase receipt. It is your record of when and where the regulator was purchased. It also lets you know when your annual service should be performed.
3. To keep the original-owner limited lifetime warranty in effect, you must have your regulator inspected and serviced annually, within 30
Fig. 1
Fig. 2.
Serial #
A005678
.4
days before or after the anniversary of the purchase date. Failure to do so will invalidate your warranty. This servicing must be performed by an authorized Zeagle dealer. Save the receipts from this servicing for your records.
4. This limited warranty applies only to the original purchaser, and then only to certified divers.
5. Sometimes products from other manufacturers are attached to Zeagle equipment. This warranty does not cover those other products or make any claims as to the performance or suitability of those other products.
6. This limited warranty applies only to regulators sold through autho
-
rized Zeagle Systems dealers.
7. This warranty gives you specific legal rights. You may also have other rights that may vary from state to state.
Disclaimer And Limitation On Remedy
(Some States do not allow limitations on how long an implied warranty lasts or do not allow exclusion of incidental or consequential damages, so the following limitations or exclusions may not apply to you.)
Zeagle expressly limits any and all warranties, expressed or implied, to the terms of the limited warranty as set forth above
Your remedies are limited to those contained herein and are in lieu of all other remedies, whether based on breach of warranty or contract, negligence, strict product liability or other tort.
Zeagle specifically disclaims liability for any consequential, special or indirect damages arising out of the use of Zeagle Equipment.
Loading...
+ 14 hidden pages