Zeagle Flathead-lt, FLATHEAD-7 User Manual

This owner’s manual uses signal words recommended by the American National Standards Institute (see ANSI Z535.4) to des­ignate levels of hazard seriousness. These signal words and their designations are as follows:
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This signal word is to be limited to the most extreme situ­ations.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.
Table of Contents:
Pages
Introduction – Safety Information
Warranty Information
Disclaimer and Limitation of Remedy
Cold Water Diving Information
Nitrox Use / First Stage Features
Second Stage Features
Resistance Control Knob Dive / Pre-Dive Lever
Octopus Use
Wet Breathing
Pre-Dive Check
Post-Dive Care
Maintenance
Code Of The Responsible Diver
2
3
4
6
8
9
10
11
11
11
13
14
14
Specifications / Service Record
15,16
1
Congratulations on your Zeagle Regulator Purchase!
Your Zeagle “Flathead” Regulator is the top of the Zeagle Regulator line and has been designed and manufactured to the highest pos­sible standards of performance and reliability. With the reasonable care outlined in this manual it will provide you with many years of diving enjoyment.
Since 1979, Zeagle Systems Inc. has been providing divers with Scuba equipment and Buoyancy Control Devices. Zeagle Systems and our worldwide network of authorized dealers are always ready to serve you. For more information on our products, and for the dealer nearest you, visit our web site at www.zeagle.com. Thank you for choosing Zeagle!
Safety Information
Read these instructions carefully before using your regulator, and keep this manual for future reference.
Following the care and maintenance section at the end of this book­let will help ensure reliable service.
Model Differences
The primary difference between the Flathead-7 and Flathead-LT models, involves the 1st stages. The Flathead-7 has a dry-sealed first stage and a Heat-sink on the 2nd Stage to help prevent freezing in cold water. The Flathead-LT has a wet spring chamber on the 1st stage and plastic spacer on the 2nd stage to make the LT lighter while still maintaining the extremely high flow capacities.
2
Limited Lifetime Warranty To The Original Owner
1. Your Z / Flathead is guaranteed against defects in materials and work­manship. This guarantee does not cover normal wear, or damage from accident, abuse, neglect, alterations, improper usage, or failure to follow reasonable care and maintenance as outlined in this manual. Under this limited warranty, Zeagle will either repair or replace, at its sole option, any original equipment or parts that fail to perform as intended. Shipping and Labor charges are not included and must be paid by you. To validate your warranty, you must fill out and return your warranty registration card within 30 days of purchase. This Limited Lifetime Warranty excludes filters, hoses, O-rings, diaphragms and mouthpieces, which are warranted for two years from the regulator’s date of purchase. Filling out the card requires printing CLEARLY the serial numbers of both the first and second stages. The first stage serial number is stamped on the first stage on the top of the regulator (fig. 1). The second stage serial number is stamped on the mouthpiece tube (fig. 2). To read this serial number you must fold back the flexible silicone mouthpiece to expose the numbers. Each serial number consists of a
ID #
pre-fix letter followed by six numbers. All of the digits of both the first and second stages must be CLEARLY printed on your warranty registration card for your warranty to be activated. You can also register at www.zeagle.com.
Fig. 2.
2. For proof of original ownership, It is your record of when and where the regulator was purchased.
It also lets you know when your annual service should be performed.
Fig. 1
3. To keep the original-owner Limited Lifetime Warranty in effect, you
must have your regulator inspected and serviced annually, within 30 days before or after the anniversary of the purchase date. Failure to do so will invalidate your warranty. This servicing must be performed by an authorized Zeagle dealer. Save the receipts from this servicing for your records.
3
4. This limited warranty applies only to the original purchaser, and then only to certified divers.
5. Sometimes products from other manufacturers are attached to Zeagle Equipment. This warranty does not cover those other products or make any claims as to the performance or suitability of those other products.
6. This limited warranty applies only to regulators sold in the USA through authorized Zeagle Systems dealers.
7. This warranty gives you specific legal rights. You may also have other rights that may vary from state to state.
8. This warranty applies only to regulators purchased from Authorized Zeagle Dealers located within the United States. The regulator must be picked up by the original owner at the dive store. Regulators shipped to
the customer in another location are not covered. Warranty coverage in countries other than the US varies. Outside the US your dealer will be able to get further Warranty information from the Authorized Zeagle Regional Distributor.
Disclaimer And Limitation On Remedy
(Some states do not allow limitations on how long an implied warranty lasts or do not allow exclusion of incidental or consequential damages, so the following limitations or exclusions may not apply to you.)
Zeagle expressly limits any and all warranties, expressed or implied, to the terms of the limited warranty as set forth above. Your remedies are limited to those contained herein and are in lieu of all other remedies, whether based on breach of warranty or contract, negligence, strict product liability or other tort. Zeagle specifically disclaims liability for any consequential, special or indirect damages arising out of the use of Zeagle Equipment.
4
Loading...
+ 14 hidden pages