Z Com XG 300 User Manual

Preliminary User manual

Z-COM XG-300

IEEE 802.11g WLAN Cardbus Card

User Manual

Version 0.1

FCC ID: M4Y-XG-300 Page 1 of 10

Preliminary User manual

Table of Contents

0-INTRODUCTION ....................................................................................................3

1-CARDBUS INSTALLATION PROCEDURE.......................................................3

1.1 INSTALLING THE CARDBUS CARD INTO THE HOST PC NOTEBOOK ...................3

1.2 INSTALLING THE SOFTWARE DRIVERS ................................................................3

1.3 WIRELESS LAN INSTALLATION GUIDE LINES AND AUTHORIZATION FOR USE .7

2-REGULATORY INFORMATION......................................................................... 7

2.1 FCC INFORMATION TO USER .............................................................................7

2.2 FCC GUIDELINES FOR HUMAN EXPOSURE ........................................................7

2.3 FCC ELECTRONIC EMISSION NOTICES..............................................................7

2.4 FCC RADIO FREQUENCY INTERFERENCE STATEMENT.....................................8

2.5 EXPORT RESTRICTIONS .......................................................................................8

2.6 EUROPE - EU DECLARATION OF CONFORMITY.................................................9

3-TECHNICAL SPECIFICATIONS.......................................................................10

FCC ID: M4Y-XG-300 Page 2 of 10

Preliminary User manual

0-Introduction

The Z-Com XG-300 WLAN NIC is a complete wireless high speed Network Interface Card (NIC)
utilizing the Intersil PRISM GT ® chip set. It conforms to the IEEE 802.11g protocol and operates in
the 2.45 GHz ISM frequency bands.

• Fully compliant with the IEEE 802.11g WLAN standards

• FCC Certified Under Part 15 (pending) to Operate in the 2.45 Bands

• Support for 54, 48, 36, 24, 18, 12, 9, and 6 Mbps OFDM, 11 and 5.5 Mbps CCK and legacy 2 and 1
Mbps data rates

• Driver Supports Microsoft Windows ® 98/SE, ME, XP and 2000 (SR1)

1-Cardbus Installation procedure

1.1 Installing the Cardbus card into the host PC Notebook

a-Turn Host PC off, then insert Cardbus card into Cardbus slot of notebook Host PC.

CAUTION:
1-- This assembly is designed to operate with a supply voltage of 3.3V in laptop computers supporting the
CARDBUS32 standard.

2-- Do not force engagement of the card in the CARDBUS32 slot. It is mechanically designed to prevent
improper insertion.

1.2 Installing the software drivers

a-Start windows

b-When windows detects new hardware and asks for drivers, point to directory where the Z-Com driver
is located (for example floppy drive, cdrom , harddisk) to install.

c-after drivers are installed, restart windows

d-the Z-Com WLAN icon will appear in system tray on the bottom right of the screen (see yellow
arrow in fig. 01)

fig, 01: Z-Com WLAN icon

FCC ID: M4Y-XG-300 Page 3 of 10