Zcom AS220V2 Quick Start Manual

AS220V2 2x2 Dual Band 802.11ac Wave 2 Indoor Access Point QSG

AS220V2 2x2 Dual Band 802.11ac Wave 2 Indoor Access Point QSG

One indoor

access point

One mounting bracket

+ one screw

Two mounting bracket screws

+ screw anchors

One

allen wrench

One quick start guide

Note: If any of the items, mentioned above, are not included in the packaging or are
damaged in any way, contact your reseller immediately.

 Insert the mounting bracket into the socket using

the two screws (included in the packaging).

 Slide the device onto the mounting

bracket to finish the installation.

Note: Before lock two screws into the socket, please reserve space up to 15 cm in length
above bracket for installation.

Package Contents

Installation Requirements

TERMS OF USE: All Ethernet cabling runs must use CAT5e, 24AWG (or above) Shielded Twisted Pair
(STP) cabling. It is the professional installer’s responsibility to follow local country regulations,
including operation within legal frequency channels, output power, indoor cabling requirements,
and Dynamic Frequency Selection (DFS) requirements.

Mounting the Access Point

In-wall mount

 Determine where you want to mount the device, position the socket into the slot.

1

AS220V2 2x2 Dual Band 802.11ac Wave 2 Indoor Access Point QSG

Note: Before drill two holes into the wall, please reserve space up to 15 cm in length
above bracket for installation.

 Install the mounting bracket onto the wall

using the two screws (included in the
packaging) into the screw plugs in the wall.

 Slide the device onto the mounting bracket

to finish the installation.

Note: The thickness of ceiling board should be less than 15mm.

 Insert the ceiling screw through the mounting

bracket, ceiling board, and ceiling mount as the
following picture.

 Slide the device onto the mounting bracket

to finish the installation.

Wall mount

 Determine where you want to mount the device, position the mounting bracket onto the wall,

and use a marker to mark the two screw holes on the wall.

 Drill the two holes into the wall and insert the two screw anchors (included in the packaging)

into the holes.

Ceiling Mount (Optional accessory_AS-CLM4)

 Determine where you want to mount the device, position the mounting bracket onto the ceiling

board.

 Use a marker to locate the two screw holes on the ceiling, and drill the two holes into the ceiling.

2