Z-Com AC-1028 Quick Start Manual
AC-1028 In-Wall Access Point
Quick Start Guide
This Quick Setup Guide provides step-by-step instructions on how to set up your AC-1028 In-Wall
Access Point. After completing the steps described in this guide, you will be able to place the AP at
your site and provide wireless network access to users.
PACKAGE CONTENTS
AC-1028 M3 Screws
TERMS OF USE: It is the customer’s responsibility to follow local country regulations, including
operation within legal frequency channels, output power, and indoor cabling requirements.
HARDWARE OVERVIEW
Top View
No Item
1 LAN 1
2 LAN 2
3 Reserved Port
4 Screw Holes
LED Indication
NO LED STATE DESCRPTIOON
1 PWR
Off The device is not powered on
On (Amber
) Power is being supplied to the device
.
The LAN LEDs will light on immediately
when the power is supplied to the
device and go off
after
few seconds.
2 LAN Off No Link
On (Green)
Ethernet is linked
Blinking
(Green)
Ongoing data transmission
Bottom View
No Item
1 Power IDC
2 Reserved Port
Side View
No Item
1 Reset Button
SETUP REQUIREMENTS
Before installing your AC-1028 access point, be sure that you have the following:
A computer from which you can access the AP Web interface
A CAT5 UTP cable of required length
Phillips screwdriver
Wire stripper/cutter
Punch down tool
Needle-nose pliers (Optional)
IMPORTANT: The mFi Switch is to be installed by a qualified electrician in accordance with local
electrical codes and regulations.
WARNING: TO AVOID FIRE, SHOCK OR DEATH; turn off power at the circuit breaker or fuse before
installing.
Hardware Installation
STEP 1: Remove the wall outlet
Unplug the phone or networking device from the existing wall outlet if any. Remove the outlet from
the wall.
Note: The recommended telephone wall outlet dimensions are 86mm by 86 mm.
STEP 2: Connect the Ethernet Cable
1. Pull out the Ethernet cable from a PoE switch in the wall. Cut off the RJ-45 connector and stripping
away 12 mm (½") of insulation from the end of each wire.
Loading...