Z Com 0005850 Users Manual

802.11a Wireless LAN Access Point XV-5850

User’s Manual

Version 1.1 -July. 2007

CONTENTS

Introduction ............................................................……...............……........2

Hardware Installation ............................................…….......…….................3

WAB102 AP Default Setting……….……………………………………….4

Web Management Settings ………………………………………………..5

Start - Up & Log in ………………………………………………………….5

Main Page …………………………………………………………………...5

Setup …………...…………………………………………………………....6

Password…………….…..…………………………………………………...7

WEP Security ……...………………………………………………………...8

Access Control…………………………………………………………….…9

Advance Setup…………...…………………………………………………10

Factory Default…..…………………………………………………………12

Firmware Upgrade …………………………………………………………12

Status….………….…………………………………………………………13
Troubleshooting ……………………………………………………………14

Technical Specifications .……………………………………………………16

Introduction

Thank you for purchasing your WAB102 802.11a Wireless AP.

This manual will assist you with the installation procedure.

The package you have received should contain the following items:

• WAB102 802.11a Wireless AP……………….……………………………..x1

• User’s Manual…………………………………………………………………x1

• Power Adapter…………………………………………………………………x1

If any of the above items are not included or damaged, please contact your local vendor for

support.

Safety Notification

Your Wireless AP should be placed in a safe and secure location. To ensure proper operation,

please keep the unit away from water and other damaging elements.

 Please read the user manual thoroughly before you install the device.

 The device should only be repaired by authorized and qualified personnel.

 Please do not try to open or repair the device yourself.

 Do not place the device in a damp or humid location, i.e. a bathroom.

 The device should be placed in a sheltered and non-slip location within a temperature

range of +5 to +40 Celsius degree.

 Please do not expose the device to direct sunlight or other heat sources. The housing and

electronic components may be damaged by direct sunlight or heat sources.

Hardware Installation
Front Panel

The front panel provides LED’s for device status. Refer to the following table
for the meaning of each feature.

LED STATUS Description
Power Off No Power

Status Blink 1. Power up 2. firmware upgrade

On Power on

Ethernet Indicates data traffic on the 100 Mbps LAN

11a Blink

Off no Ethernet link detected
Green On 100Mbps Fast Ethernet link detected. No activity.

Green
Blink

Amber On 10 Mbps Ethernet link detected but no activity
Amber

Blink

Indicates data traffic on the 10 Mbps LAN
Indicates the device is linking or active data

through wireless links

Rear Panel

The rear panel features 1 LAN port and Factory Reset button. Refer to the
following table for the meaning of each feature.

WAB102 AP Default Settings

The default settings are shown following.

User Name
Password
SystemName 00 60 B3 xx xx xx where xx

AP IP Address
AP Subnet Mask 255.255.255.0
ESSID for both 11a&b
11a RF Channel Best
11b RF Channel best
RF Roaming Enabled
Encryption Disabled

admin
default

xx xx are the last six digits of
the AP’s MAC address

192.168.1.20

Wireless

MAKE CORRECT NETWORK SETTINGS OF YOUR COMPUTER

To change the configuration, use Internet Explorer (IE) or Netscape Communicator to connect

the WEB management 192.168.1.20. Administrator’s Password default is default.

Main Page

Here allow user to configure basic network settings.