zBoost ZB570-TRI-ALTE, ZB570-TRI-VLTE Users Manual

zBoost® TRIO Pro

ZBC775 Manual

Models:

• ZBC775-A

• ZBC775-V

zBoost® products have a 30-day money back guarantee when purchased directly from
zBoost. If product is purchased from a reseller or third party, the purchaser is subject to the
policies of the third party.

2 year manufacturer warranty. Warranty registration at www.zBoost.com

v.0314

zBoost® TRIO Pro ZBC775 Manual zBoost® TRIO Pro ZBC775 Manual

FCC Requirements

This is a CONSUMER Device.

BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider’s consent. Most wireless providers consent to the use of signal boosters. AT&T, Sprint,
T-Mobile, Verizon and 90 additional have already given consent for all consumers to use this device.
Some providers may not consent to the use of this device on their network. If you are unsure, contact
your provider.

You MUST operate this device with approved antennas and cables as specifi ed by the manufacturer.
Antennas MUST be installed at least 20 cm (8 inches) from any person.

You MUST cease operating this device immediately if requested by the FCC or a licensed wireless
service provider.

WARNING. E911 location information may not be provided or may be inaccurate for calls served by
using this device.

FCC contact information: www.fcc.gov/signal-boosters/registration

Warning

Any product modifi cations that use unauthorized
antennas, cables, and/or coupling devices is no longer
FCC compliant and will void the product warranty.

FCC Information

FCC ID: SO4ZB570-TRI-VLTE, SO4ZB570-TRI-ALTE

Warning: Changes or modifi cations to this device not expressly approved by zBoost could void the

user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If the equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected

• Consult the dealer or an experienced radio/TV technician for help

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. In accordance with FCC requirements of human exposure to radiofrequency
fi elds, the radiating element (antenna) shall be installed such that a minimum separation distance
of 20cm (8in) is maintained from all persons. Additionally, the device must not be used above 10 m
above ground.

About zBoost®

zBoost, the leader in cell phone signal boosters, manufactures an award-winning line of cell
phone signal boosters that enhance the performance of your cell phone, smartphone and
wireless data card.

Uses patented technologies and protects the carrier networks.

2-year manufacturer warranty – register your product at www.zBoost.com.

Industry Canada Regulations

IC ID: 5544A-ZB570TRIVLT, 5544A-ZB570TRIALT

This Class B digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

The term “IC:” before the radio certifi cation number only signifi es that Industry Canada technical
specifi cations were met.

RF Exposure: The manufacturer’s rated output power of this equipment is for single carrier
operation. For situations when multiple carrier signals are present, the rating would have to be
reduced by 3.5 dB, especially where the output is re-radiated and can cause interference to
adjacent band users. This power reduction is to be by means of input power or gain reduction and
not by an attenuator at the output of the device.

Cet appareillage numérique de la classe [B] répond à toutes les exigences de l’interférence
canadienne causant des règlements d’équipement. L’opération est sujette aux deux conditions
suivantes: (1) ce dispositif peut ne pas causer l’interférence nocive, et (2) ce dispositif doit accepter
n’importe quelle interférence reçue, y compris l’interférence qui peut causer l’opération peu désirée.

Le fabricant nominale de la puissance de sortie de ce matériel est simple transporteur. Pour les
situations lorsque plusieurs signauxporteurs sont présents, l’évaluation devrait être réduite de

3.5 dB, en particulier lorsque le signal de sortie est ré-émise et peut provoquer des interférences
adjacentes à la bande utilisateurs. Ce pouvoir est de la réduction par le biais de la sortie
d’alimentation ou la réduction de gain et non par un atténuateur à la sortie du dispositif.

Please note: This unit has been approved for use in Canada under RSS 131, however, consent
for the use of this device to improve cellular or PCS coverage, must be obtained through your
cellular or PCS provider, prior to placing the unit in operation. Please refer to the Industry Canada
document CPC 2-1-05, Section 6.1 available or viewable at:
http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf08942e.html

Copyright Notice

This manual is copyrighted. All rights reserved. This manual, whole or in part, may not be copied,
photocopied, reproduced, translated or reduced to any electronic medium or machine readable
form for distribution. This manual whole or in part, may not be modifi ed without prior consent, in
writing, from zBoost.
Copyright © 2013 by zBoost, Inc.

Trademarks

Wireless Extenders, Wi-Ex, the Wi-Ex logo, zBoost, the zBoost logo and Extending Cell Zones are
registered trademarks of zBoost, Inc.

i ii

zBoost® TRIO Pro ZBC775 Manual zBoost® TRIO Pro ZBC775 Manual

Safety and Product Warranty Information

Safety Guidelines

In accordance with FCC requirements of human exposure to radio frequency fi elds, the radiating
element (antenna) shall be positioned such that a minimum separation distance of 8 inches (20cm)
is maintained between the radiating element and the user and/or general population.

Limited Liability

In no event shall zBoost be liable for any direct, indirect, special, punitive, incidental, exemplary
or consequential damages, or any damages, whether in an action under contract, negligence,
or any other theory, arising out of or in connection with the set up of, use of, inability to use, or
performance of the information, services, products, and materials available from this manual.
These limitations shall apply notwithstanding any failure of essential purpose of any limited
remedy. Because some jurisdictions do not allow limitations on how long an implied warranty
last, or the exclusion or limitation of liability for consequential or incidental damages, the above
limitations may not apply to you.
For full warranty guidelines, see page 13.

Package Contents

Before you begin, make sure all of the following parts came with your zBoost TRIO Pro:

Literature Contents:

① Setup overview for zBoost TRIO Pro

Product Contents:

② zBoost Base Unit

③ Indoor Antenna with TNC-F adaptor

④ Power Supply

⑤ RG-6 Coax Cable (15 ft.)

⑥ RG-6 Coax Cable (50 ft.)

⑦ External Antenna

⑧ External Antenna Mounting Hardware

①

③

⑤

SETUP OVERVIEW

②

④

⑥

iii iv

⑧

⑦

zBoost® TRIO Pro ZBC775 Manual zBoost® TRIO Pro ZBC775 Manual

Optional Accessories Table of Contents

The following accessories are authorized for this zBoost product. Please see our website for
complete selection. To order, call 1-800-871-1612, or visit www.zBoost.com.

Broadcast Antennas - Indoor

CANT-0039 Indoor Broadcast Antenna, Omni Whip Direct to Booster, Black, Wideband, LTE-

CEL-AWS-PCS (1 dBi)

CANT-0045* Indoor Broadcast Antenna, Wideband Directional Panel, LTE-CEL-AWS-PCS

(8 / 7.5 dBi)

YX052 Indoor Broadcast Antenna, Wideband Omnidirectional Ceiling Mount, LTE-CEL-

AWS-PCS (1 / 2 dBi)

External Antennas - Outdoor

CANT-0040 Outdoor External Antenna, Wideband Omni Directional, LTE-CEL-AWS-PCS

(3 / 5 dBi)

CANT-0042 Outdoor External Antenna, Wideband Directional Log Periodic, LTE-CEL-AWS-PCS

(10 / 12 dBi)

CANT-0043 Window-Mount External Antenna, Wideband Directional Panel, LTE-CEL-AWS-PCS

(6 / 7 dBi)

Coax Cable - To be used in addition to the cable included in your kit

YX030-0W8 8 Inch Window Entry Cable with F-Female Connectors

YX030-15W 15 Foot RG-6 Coaxial Extension Cable with F-Male Connectors

YX030-35W 35 Foot RG-6 Coaxial Extension Cable with F-Male Connectors

YX030-50W 50 Foot RG-6 Coaxial Cable with F-Male Connectors

YX031-100W 100 Foot Low Loss RG-11 Coaxial Cable with F-Male Connectors

Accessories

YX012 Outdoor External Antenna Grounding Kit

FCC Requirements ........................................................................................................................i

FCC Information ............................................................................................................................i

Industry Canada Regulations .......................................................................................................ii

Copyright Notice ..........................................................................................................................ii

Trademarks ..................................................................................................................................ii

Safety Guidelines ........................................................................................................................ iii

Limited Liability ........................................................................................................................... iii

Safety and Product Warranty Information ................................................................................... iii

Package Contents ........................................................................................................................ iv

Optional Accessories .................................................................................................................... v

Table of Contents .......................................................................................................................... 1

Overview ........................................................................................................................................ 2

Why Indoor Signals Can Be Weak ............................................................................................... 2

Preparing to Set Up Your zBoost Product .................................................................................... 3

Tools Needed .............................................................................................................................. 3

Check for External Strength ........................................................................................................ 3

IMPORTANT: Before Installing, Note These Important Factors in Determining Performance ....... 4

Grounding the External Antenna .................................................................................................. 4

Securing Cable with a Drip Loop ................................................................................................. 5

Power Requirements ................................................................................................................... 5

Setting Up Your zBoost Signal Booster ....................................................................................... 6

FIRST: Mount the External Antenna............................................................................................. 6

SECOND: Position the Base Unit and Indoor Antenna ................................................................. 6

THIRD: Run the Coaxial Cable between the External Antenna and Base Unit ............................. 7

FOURTH: Connect the zBoost Base Unit to Power ...................................................................... 7

FIFTH: Antenna Aiming ............................................................................................................... 8

Confi rm That Your zBoost is Working Properly ............................................................................ 9

Improving Your Coverage Area ..................................................................................................... 9

zBoost Base Unit Light Indicators .............................................................................................. 10

Technical Specifi cations ..............................................................................................................11

Frequently Asked Questions ...................................................................................................... 12

Warranty Information .................................................................................................................. 13

* The FCC requires that this panel antenna has a minimum horizontal separation of 6 feet (2 meters)
from other CMRS (commercial mobile radio service) devices.

v 1