zBoost ZB570-PCS-CEL User Manual
zBoost Cellular REACH
ZB560Y Manual
zBoost® products have a 30-day money back guarantee when purchased directly from
zBoost. If product is purchased from a reseller or third party, the purchaser is subject to the
policies of the third party.
2 Year manufacturer warranty. Warranty registration at www.zBoost.com
v.0214
zBoost® Cellular REACH ZB560Y Manual zBoost® Cellular REACH ZB560Y Manual
FCC Requirements
This is a CONSUMER Device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider’s consent. Most wireless providers consent to the use of signal boosters. AT&T, Sprint,
T-Mobile, Verizon and 90 additional carriers have already given consent for all consumers to use this
device. Some providers may not consent to the use of this device on their network. If you are unsure,
contact your provider.
You MUST operate this device with approved antennas and cables as specifi ed by the manufacturer.
Antennas MUST be installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed wireless
service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by
using this device.
FCC contact information: www.fcc.gov/signal-boosters/registration.
Warning
Any product modifi cations that use unauthorized
antennas, cables, and/or coupling devices is no longer
FCC compliant and will void the product warranty.
About zBoost
®
zBoost, a leader in cell phone signal boosters manufactures zBoost, the award-winning line of
cell phone signal boosters that enhance the performance of your cell phone, smartphone and
wireless data card.
Compatibility – Dual Band zBoosts are compatible with 800 MHz and 1900 MHz regardless of
technology- including CDMA and GSM.
Uses patented technologies and protects the carrier network.
2-year manufacturer warranty – Warranty registration at www.zBoost.com.
FCC Information
FCC ID: SO4ZB570-PCS-CEL
Warning: Changes or modifi cations to this device not expressly approved by zBoost could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If the equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. In accordance with FCC requirements of human exposure to radiofrequency
fi elds, the radiating element (antenna) shall be installed such that a minimum separation distance of
20cm (8in) is maintained from all persons.
Industry Canada Regulations
IC ID: 5544A-ZB570PCSCEL
This Class B digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The term “IC:” before the radio certifi cation number only signifi es that Industry Canada technical
specifi cations were met.
RF Exposure: The manufacturer’s rated output power of this equipment is for single carrier
operation. For situations when multiple carrier signals are present, the rating would have to be
i ii
reduced by 3.5 dB, especially where the output is re-radiated and can cause interference to
zBoost® Cellular REACH ZB560Y Manual zBoost® Cellular REACH ZB560Y Manual
adjacent band users. This power reduction is to be by means of input power or gain reduction and
not by an attenuator at the output of the device.
Cet appareillage numérique de la classe [B] répond à toutes les exigences de l’interférence
canadienne causant des règlements d’équipement. L’opération est sujette aux deux conditions
suivantes: (1) ce dispositif peut ne pas causer l’interférence nocive, et (2) ce dispositif doit accepter
n’importe quelle interférence reçue, y compris l’interférence qui peut causer l’opération peu désirée.
Le fabricant nominale de la puissance de sortie de ce matériel est simple transporteur. Pour les
situations lorsque plusieurs signaux porteurs sont présents, l’évaluation devrait être réduite de
3.5 dB, en particulier lorsque le signal de sortie est ré-émise et peut provoquer des interférences
adjacentes à la bande utilisateurs. Ce pouvoir est de la réduction par le biais de la sortie
d’alimentation ou la réduction de gain et non par un atténuateur à la sortie du dispositif.
Please note: This unit has been approved for use in Canada under RSS 131, however, consent
for the use of this device to improve cellular or PCS coverage, must be obtained through your
cellular or PCS provider, prior to placing the unit in operation. Please refer to the Industry Canada
document CPC 2-1-05, Section 6.1 available or viewable at:
http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf08942e.html
Safety and Product Warranty Information
Copyright Notice
This manual is copyrighted. All rights reserved. This manual, whole or in part, may not be copied,
photocopied, reproduced, translated or reduced to any electronic medium or machine readable
form for distribution. This manual whole or in part, may not be modifi ed without prior consent, in
writing, from zBoost.
Copyright © 2014 by zBoost.
Package Contents
Before you begin, make sure all of the following parts came with your zBoost ZB560Y.
Literature Contents:
① Setup overview
Product Contents:
② zBoost Base Unit
③ Indoor Antenna
④ Power Supply
⑤ RG-6 Coax Cable, 50 ft.
⑥ External Antenna
⑦ Mounting Hardware
①
②
③
④
SETUP OVERVIEW
Trademarks
zBoost, the zBoost logo, Wireless Extenders, Wi-Ex, the Wi-Ex logo, and Extending Cell Zones are
registered trademarks of zBoost.
Safety Guidelines
In accordance with FCC requirements of human exposure to radio frequency fi elds, the radiating
element (antenna) shall be positioned such that a minimum separation distance of 8 inches (20cm)
is maintained between the radiating element and the user and/or general population.
Limited Liability
In no event shall zBoost be liable for any direct, indirect, special, punitive, incidental, exemplary
or consequential damages, or any damages, whether in an action under contract, negligence,
or any other theory, arising out of or in connection with the set up of, use of, inability to use, or
performance of the information, services, products, and materials available from this manual.
These limitations shall apply notwithstanding any failure of essential purpose of any limited
remedy. Because some jurisdictions do not allow limitations on how long an implied warranty
last, or the exclusion or limitation of liability for consequential or incidental damages, the above
limitations may not apply to you. For full warranty guidelines, see page 13.
iii iv
⑤
⑥
⑦
zBoost® Cellular REACH ZB560Y Manual zBoost® Cellular REACH ZB560Y Manual
Accessories
The following accessories are authorized for this zBoost product. Please see our website for
complete selection. To order, call 1-800-871-1612 or visit, www.zBoost.com
Broadcast Antennas - Indoor
CANT-0032 Indoor Broadcast Antenna, Omni Whip Direct to Booster, Black, CEL-PCS (1 dBi)
CANT-0034 Indoor Broadcast Antenna, Omni Whip Direct to Booster, White, CEL-PCS (1 dBi)
CANT-0039 Indoor Broadcast Antenna, Omni Whip Direct to Booster, Black, Wide- Band, LTE-
CEL-AWS-PCS (1 dBi)
YX027-F* Indoor Broadcast Antenna, Directional Panel w/ F-Female Connector, CEL-PCS
(6 / 8 dBi)
YX052 Indoor Broadcast Antenna, Ceiling Mount Omni w/ F-Female Connector, LTE-CEL-
AWS-PCS (1 / 2 dBi)
External Antennas - Outdoor
CANT-0028 Outdoor External Antenna, Directional Low Profi le Panel, CEL-AWS-PCS (6 / 8 dBi)
CANT-0031 Window-mount External Antenna for YX540 zBoost Metro, Directional Panel, CEL-
PCS (6 / 8 dBi)
CANT-0033 Outdoor External Antenna, Small Omni, CEL-PCS (3 / 5 dBi)
CANT-0036 Outdoor External Antenna, Omni with Industrial Casing, CEL-PCS (3 / 5 dBi)
CANT-0040 Outdoor External Antenna, Wide-Band Omni Directional, LTE-CEL-AWS-PCS
(3 / 5 dBi)
CANT-0042 Outdoor External Antenna, Wide-Band Directional Log Periodic, LTE-CEL-AWS-PCS
(10 / 12 dBi)
YX021-CEL Outdoor External Antenna, Directional Panel, CEL (8 dBi)
YX023-PCS Outdoor External Antenna, Directional Panel, PCS (13 dBi)
YX026-CEL Outdoor External Antenna, Directional 3 foot Yagi with 12 Elements, CEL (11 dBi)
YX039-PCS-CEL Outdoor External Antenna Kit, Two Directional Panels with Combiner, CEL-PCS
(8 / 13 dBi)
Coax Cable - To be used in addition to the cable included in your kit
YX030-0W8 8 Inch Window Entry Cable with F-Female Connectors
YX030-15W 15 Foot RG-6 Coaxial Extension Cable with F-Male Connectors
YX030-35W 35 Foot RG-6 Coaxial Extension Cable with F-Male Connectors
YX030-50W 50 Foot RG-6 Coaxial Cable with F-Male Connectors
YX031-10W 10 Foot RG-8X Coaxial Cable with TNC-Male & Female Connectors (Booster to
Distribution Antenna)
YX031-100W 100 Foot Low Loss RG-11 Coaxial Cable with F-Male Connectors
Accessories
YX012 Outdoor External Antenna Grounding Kit
Table of Contents
FCC Requirements ........................................................................................................................i
FCC Information ...........................................................................................................................ii
Industry Canada Regulations .......................................................................................................ii
Safety and Product Warranty Information ................................................................................... iii
Copyright Notice .........................................................................................................................iii
Trademarks .................................................................................................................................iii
Safety Guidelines ........................................................................................................................iii
Limited Liability ........................................................................................................................... iii
Package Contents ........................................................................................................................ iv
Accessories ................................................................................................................................... v
Table of Contents .......................................................................................................................... 1
Overview ........................................................................................................................................ 2
Why Indoor Signals Can Be Weak ............................................................................................... 2
Preparing to Set Up Your zBoost Product .................................................................................... 3
Tools Needed .............................................................................................................................. 3
Check for Signal Strength ............................................................................................................. 3
Antenna Bracket Assembly ......................................................................................................... 4
Additional Cable Requirements ................................................................................................... 4
Grounding the External Antenna .................................................................................................. 5
Securing Cable with a Drip Loop ................................................................................................. 5
Power Requirements ................................................................................................................... 5
Setting Up Your zBoost Signal Booster ....................................................................................... 6
FIRST: Mount the External Antenna............................................................................................. 6
Antenna Bracket Assembly ......................................................................................................... 6
SECOND: Place the zBoost Base Unit where you want to create a Cell Zone
THIRD: Run the Coaxial Cable .................................................................................................... 7
FOURTH: Connect zBoost Base Unit to Power ........................................................................... 7
Confi rm That Your zBoost is Working Properly ............................................................................ 8
Improving Your Coverage Area ..................................................................................................... 9
zBoost Base Unit Light Indicators .............................................................................................. 10
Technical Specifi cations ..............................................................................................................11
Frequently Asked Questions ...................................................................................................... 12
Warranty Information .................................................................................................................. 13
TM
......................... 6
* The FCC requires that this panel antenna has a minimum horizontal separation of 6 feet (2 meters)
from other CMRS (commercial mobile radio service) devices.
v 1
Loading...