zBoost YX510 Users Manual
FCC Part 22/24
Transmitter Certification
Test Report
FCC ID: SO4YX510
FCC Rule Part: CFR 47 Part 22 Subpart H,
CFR 47 Part 24 Subpart E
ACS Report Number: 06-0291-22H, 06-0291-24E
Manufacturer: Wireless Extenders
Equipment Type: Dual Band Bi-Directional Signal Booster
Model: YX510-PCS-CEL
Manual
5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598
zBoost YX500/510 Series Installation Guide
Wi-Ex
i
FCC Information
FCC ID: SO4YX500-CEL
: SO4YX500-PCS :SO4YX510
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in the residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Increase the separation between the equipment and receiver.
• Reorient or relocate the receiving Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or a professional installer for help.
Copyright Notice
This manual is copyrighted. All rights reserved. This manual, whole or in part, may not be
copied, photocopied, reproduced, translated, or reduced to any electronic medium or machinereadable form for distribution. This manual, whole or in part, may not be modified without prior
consent, in writing, from Wireless Extenders.
Copyright © 2006 by Wireless Extenders, Inc.
Trademarks
Wireless Extenders, Wi-Ex, the Wi-Ex logo, zBoost, the zBoost logo, Extending Cell Zones
and Wireless Where You Want It are registered trademarks of Wireless Extenders, Inc.
iDEN is a registered trademark of Motorola.
Nextel is a registered trademark of Nextel Communications Corp.
Industry Canada Regulations
Canada IC :5544A-YX500CEL
:5544A-YX500PCS :5544A-YX510
This Class B digital apparatus meets all requirements of the Canadian
Interference Causing Equipment Regulations. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Cet appareillage numérique de la classe [B] répond à toutes les exigences de
l'interférence canadienne causant des règlements d'équipement. L'opération est
sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer
l'interférence nocive, et (2) ce dispositif doit accepter n'importe quelle interférence
reçue, y compris l'interférence qui peut causer l'opération peu désirée.
ii
zBoost YX500/510 Series Installation Guide
Wi-Ex
Read First Before Installing Your zBoost Product
Before unpacking this box, verify that your phone operates on the frequency
band supported by this product.
- The YX500-CEL will enhance your in-building coverage for local
provider networks operating at the 800MHz (Cellular) frequency.
- The YX500-PCS will enhance your in-building coverage for local
provider networks operating at the 1900MHz (PCS) frequency.
- The YX510-PCS-CEL will work for both Cellular and PCS
frequencies.
(NOTE) The YX500 Series is not compatible with iDEN, Nextel, SMR or ESMR
frequency services.
To verify that your phone will work in conjunction with the model
purchased, please follow these four simple steps:
1) Unpack the Base Unit, Base Unit Antenna and power supply only.
2) Connect the Base Unit Antenna and the power supply to Base Unit and plug
it into an outlet. The green power light will illuminate.
3) Bring the unit to an area where there is enough signal to place a call (using
an extension cord may be necessary). If the Signal light begins flashing
green while placing a call, you can proceed with the installation of the
system. If it flashes red, move your phone further away from the Base
Unit (typical for GSM) and retry.
4) If the Signal light does not flash green, try to place another call with your cell
phone directly touching the unit. If the Signal Light still does not flash
green, your cell phone may be operating on frequency supported by a
different model. Some carriers, such as Cingular and Verizon change
frequency depending upon location. Go to www.wirelessadvisor.com
contact Wi-Ex technical support at 1-800-871-1612 for further
assistance.
or
zBoost YX500/510 Series Installation Guide
Wi-Ex
Safety and Product Warranty Information
Safety Guidelines
Please adhere to the following safety guidelines during the installation of your Product
1
) In accordance with FCC requirements of human exposure to radiofrequency fields,
2) If a ladder is required for install, make sure that the ladder feet are on a flat surface
3) You should always wear proper eye protection when working with power tools.
4) Keep all plastic bags away from children to avoid suffocation hazard.
5) Before drilling make sure you know the location of existing electrical wiring to avoid
Limited Liability
In no event shall Wireless Extenders be liable for any direct, indirect, special, punitive,
incidental, exemplary or consequential damages, or any damages, whether in an action
under contract, negligence, or any other theory, arising out of or in connection with the
installation of, use of, inability to use, or performance of the information, services,
products, and materials available from this manual. These limitations shall apply
notwithstanding any failure of essential purpose of any limited remedy. Because some
jurisdictions do not allow limitations on how long an implied warranty last, or the exclusion
or limitation of liability for consequential or incidental damages, the above limitations may
not apply to you.
Customer Support
the radiating element (antenna) shall be installed such that a minimum
separation distance of 8 inches (20cm) is maintained between the radiating
element and the user and/or general population.
and the ladder is securely fixed. It is highly recommended that you have
someone assist you while you are on a ladder
contact with the wiring which could cause an electrical shock and severe the
wiring.
iii
If you have any problems with the operation of your product please
visit our website http://www.Wi-Ex.com
or contact Wi-Ex customer
support at 1-800-871-1612 for assistance.
Warning:
Changes or modifications not expressly approved
by Wi-Ex could void the user’s authority to
operate this equipment and/or void the product
warranty.
iv
zBoost YX500/510 Series Installation Guide
Wi-Ex
Outdoor Installation of the Signal Antenna
Grounding the Signal Antenna
If you decide to install the Signal Antenna outdoors, it must be properly grounded.
This will help protect your property against lightning strikes during a lightning
storm.
The installation must be in accordance with Article 810 of the National Electric
Code (NEC). A listed antenna discharge unit must be provided for the lead-in
coaxial cable per NEC article 8.10.20 or the shield of the coaxial cable must be
permanently and effectively grounded in accordance with NEC article 8.10.21.
Please consult a professional installer or electrician for more information.
Additional instructions and hardware are also available in the Wi-Ex Outdoor
Installation and Grounding Kit (Part# YX012).
Securing Cable With a Drip Loop
If you install the Signal Antenna outdoors, create a drip loop with the coaxial cable at
the point where the cable enters the building through an outside wall. This can be
done by twisting and securing the cable into a loop (no less than 4” across) near the
entry point. This will help prevent moisture from gathering at entry point and leaking
into the building. Consult a professional installer if you need more information.
Additional instructions are also available in the Wi-Ex Outdoor Installation and
Grounding Kit (Part # YX012).
Pre-installation Guidelines
Outdoor installation is preferred when a home is In an area of weak outdoor signal
area (generally 1 to 2 bars as indicated on the cell phone).
Avoid any drilling or nailing directly into the roof. This could allow water to leak into
your home and cause damage.
Choosing to mount the antenna into fascia will not compromise your roof and
places the antenna higher above ground level.
Note:
The zBoost YX500/510 Series is fully
automatic. The Install, Signal, and Power
lights on the Base Unit are not buttons.
There are no buttons to press on the
Base Unit.
zBoost YX500/510 Series Installation Guide
Wi-Ex
Read First Before Installing Your zBoost YX500/510 Series Product ii
Safety and Product Warranty Information iii
Safety Guidelines iii
Limited Liability iii
Customer Support iii
Outdoor Installation of the Signal Antenna iv
Grounding the Signal Antenna iv
Securing Cable with a Drip Loop iv
Package Contents 2
Accessories - To improve your coverage 4
zBoost YX500/510 Series Product Overview 5
Why Indoor Signals Can be Weak 5
Preparing to Install the zBoost YX500/510 Series 6
Check Signal Strength 6
Determine the Needed Coverage Area 6
Location of Signal Antenna and Base Unit Antenna 7
Additional Cable Requirements 7
Power Requirements 7
Installation Tools Needed 8
Installing Your zBoost 8
Installing the Signal Antenna 8
Running the Coaxial Cable to the Base Unit 11
Installing the Base Unit 12
Confirm that the zBoost YX500/510 Series is Working Properly 14
Improving Your Coverage Area 15
Troubleshooting the zBoost YX500/510 Series System 15
YX500-CEL Technical Specifications 16
YX500-PCS Technical Specifications 16
YX510-PCS-CEL Technical Specifications (Dual Band Unit) 17
Frequently Asked Questions 18
Warranty Information 21
1
2
zBoost YX500/510 Series Installation Guide
Wi-Ex
Package Contents
Before you begin, make sure all of the following parts came with your kit:
Quantity Part # Description
1 1
2 1 DMAN-0013 Installation Tips (CEL and Dual Band only)
DMAN-0003
DMAN-0009
Before Unpacking Sheet (PCS only)
Installation Tips (CEL only)
3 1 DMAN-0016 Installation Overview Poster
4 1 DMAN-0015 YX500/510 Series Installation Guide
5 1
APRD-0003
APRD-0009
APRD-0001
APRD-0008
APRD-0007
YX500-CEL Base Unit (800Mhz)
YX510-CEL Base Unit (800Mhz)
YX500-PCS Base Unit (1900MHz)
YX510-PCS Base Unit (1900MHz)
YX510-PCS-CEL Base Unit (Dual Band.)
6 1
CPSP-0003
CPSP-0004
Base Unit Power Supply YX500
Base Unit Power Supply YX510
7 4 CHDW-0007 Base Unit rubber feet
8 1 FHSG-0004 Base Unit Bracket
9 1
10 1
11 1 CHDW-0008 Signal Antenna mounting bracket
CANT-0010
CANT-0002
CANT-0016
CANT-0016
CANT-0001
CANT-0015
2dBi YX500-CEL Base Antenna
2dBi YX500-PCS Base Antenna
0dBi YX510- PCS-CEL Base Antenna
(CANT-0016 maybe included for all models
listed above)
3dBi YX500-CEL Signal Antenna
3dBi YX500-PCS Signal Antenna
3dBi YX510-PCS-CEL Signal Antenna
(CANT-0015 maybe included for all models
listed above)
12 1
13 2 CHDW-0001 Self-tapping #6 x 7/8" Philips Screw
CCBL-0003
CCBL-0001
50' white, DBS coaxial cable (CEL or Dual Band)
35’ white, DBS coaxial cable (PCS)
14 2 CHDW-0002 Self-tapping #6 Sheet Rock Anchor
15 2 CHDW-0005 Wood Screw #6 x 1" Philips
zBoost YX500/510 Series Installation Guide
Wi-Ex
Figure 1 – Package Contents
*Note: The satellite coaxial cable provided for YX500-PCS is 50’
3
4
zBoost YX500/510 Series Installation Guide
Wi-Ex
Accessories to Improve Your Coverage
The following accessories are also available to improve signal reception and
provide increased coverage in your home or office or to improve installation.
Please see our website for more accessories.
To order, call 1-800-871-1612 or visit, www.Wi-Ex.com.
Part # Description
YX012
YX013
YX022-CEL
YX023-PCS
YX024-PCS
YX025-CEL
YX026-CEL
YX027-PCSCEL
YX028-PCS-
CEL
YX030-15W
Outdoor Installation and Grounding Kit
Wall mounting bracket for the YX023
6 dBi Outdoor Omni Signal Antenna upgrade for zBoost
YX500/510 Series CEL
13 dBi Outdoor Directional Signal Antenna upgrade for
zBoost YX500/510 Series PCS
7 dBi Indoor Directional Base Unit Antenna upgrade for
zBoost YX500/510 Series PCS
7 dBi Outdoor Directional Signal Antenna upgrade for
zBoost YX500/510 Series CEL
11 dBi Outdoor Directional Signal Antenna upgrade for
zBoost YX500/510 Series CEL
Indoor Dual Band Directional Base Unit Antenna upgrade
(works with all models)
6 dBi gain for CEL, 9 dBi gain for PCS
Indoor Dual Band Directional Signal Antenna upgrade - for
indoor window installations where outdoor mounting of signal
antenna is not possible
15 ft. Outdoor coax extension cable, white, low-loss RG-6
YX030-35W 35 ft. Outdoor coax extension cable, white, low-loss RG-6
YX031-10W
YX030-08W
YX050-PCS-
CEL
10 ft. Base Unit antenna extension cable, white, low-loss
8” white window entry flat cable
Indoor Dual Band Omni Ceiling Antenna
Loading...