Zapp Z030 User Manual
Z030
Caution for Safety ………………………………………………………………… 3
Package Includes ………………………………………………………………… 4
Overview of the Z030 …………………………………………………………… 5
Introduction ………………………………………………………………………… 6
Installing and Configuring the ZO30 ………………………………………… 7
1. Notebook PC System Requirements ………………………………………… 7
2. Installing the Z030 Manager onto Notebook PCs (Windows 2000 and XP) 8
3. Z030 Card Insertion and Device Initialization ……………………………… 13
Using Z030 Manager ……………………………………………………………… 17
Message …………………………………………………………………………… 18
1. SMS ……………………………………………………………………………… 18
2. Receive SMS …………………………………………………………………… 18
3. Delete …………………………………………………………………………… 18
Connecting to the internet ……………………………………………………… 19
1. Connecting to the Internet ……………………………………………………… 19
Setting ……………………………………………………………………………… 20
FAQ (Frequently asked Questions) …………………………………………… 22
Technical Information …………………………………………………………… 23
Contents
Z030
Z030
Caution for Safety
DO NOT disassemble or modify the Card
The risk of electric shock or fire may result. Do not use any
detergent or chemicals such as alcohol, benzene or sniffer to
clear your card.
It may cause the failure or equipment or the risk of explosion.
DO NOT use this equipment where the
place prohibited using your card such as in
hospital or in aircraft.
RF energy may effect on the medical devices or aircraft.
If you use any other personal medical device, maintain a
proper distance between your card and the device. Your card
may affect to the devices using all kinds of radio frequencies
(RF) energies.
DO NOT expose this equipment to rain or
spilled beverages.
Do not use this equipment in an extreme environment where
high temperature or high humidity exists. Do not use hair
dryer, heating, or microwave to dry the wetted PCMCIA Card.
It may cause the malformation of the PCMCIA Card or
explosion.
Z030
•Wireless Access Card
(model No.Z030)
•Installation CD
(Including Access Manager
software and complete
User Guide as PDF document)
Package Includes
Z030
Z030
Overview of the Wireless Access Card
UIM Card Connector
(not available in Zapp network)
64Pin Connector
LED Lamp
External Antenna Connector
18Pin Connector
Ear-Microphone
Connector
Internal Antenna
Z030
Install the Z030 Manager Software and Z030 drivers before
using the PCMCIA card. Please do NOT insert the Z030
PCMCIA card into the laptop before following the installation
steps provided below, in this user guide.
Please check the contens of the purchased package.
IMPORTANT !
1. The Z030 Manager Software is available only in English
language.
2. The options of the Z030 Manager Software which are not
described in this user guide, are not available with the
Z030 in the Zapp network.
Introduction
Z030
Z030
Installing and Configuring Wireless Access Card
1. Notebook PC System Requirements
The O/S (operating system) in PC should support
Windows 2000, XP
To install and run the Wireless Access Card and
accompanying Access Manager Software, you will
need these minimum system resources:
CPU: Pentium II (150MHz or higher)
Card slots: type II PC Card slot or Type II Compact Flash slot
Communication Ports: 1 port available
Disk Drive: CD-ROM
I/O Resource: 1 IRQ, 32 bytes I/O space
Memory: 64MB
Disk Space: 23MB
Z030
2. Installing Z030 Manager onto Notebook PCs
(Windows 2000 and XP)
Insert the installation CD into your CD-ROM drive.
The installation Wizard will launch and guide you through
the installation process. Use the Next and Back buttons to
navigate through the wizard, noting the following:
In order to continue with the installation, you click Yes to
accept the terms of the License Agreement
Using the default setting for destination Folder and Program
Folder is recommended. If you need to install the software
to a different folder, click Browse, select the folder into
which you would like to install the program, and then click
next, to continue.
2-1. Install Access Manager
Insert the installation CD into your CD-ROM drive. The
Setup program should launch automatically.
If the system is ready, the <Z030 Manager setup> window
is displayed.
Note : Don’t insert PCMCIA Card in your notebook
Installing and Configuring Wireless Access Card
Loading...