Zaor MIZA V - Stand Assembly

PAG 1

MIZA V - Stand

Thank you for choosing a piece of Zaor studio furniture,

which will hopefully make your life easier, more ergonomic and improve the looks of your workspace.

Before you can enjoy the comfort of your new acquisition you need to assemble it.

We have tried to give you as much detail as needed and as little as possible.

Should you run into any difficulty with this assembly you can get in touch with us via

[e-mail] to set up a Skype session or phone call.

Here is a general instruction on how to use the furniture assembly kits:

Insert and screw in the system bolt(s) into the socket(s) already present on the part(s) making sure the hole is at 90º from the edge

1)

2) Insert the excenter(s) into the round holes on the part to be joined, aligning the hole(s) on the side with the axis of the bolt(s)

3) Assemble the connecting parts,inserting the bolts into the smaller holes in the connecting part, the bolt tip fitting into the side hole

of the excenter until the hole in the bolt and the center hole of the excenter align

insert the locking screw into the excenter, and tighten with a cross screw driver all the way without using force!

4)

System bolt with hole

Excenter with 2 holes

Locking screws