Zanussi ZT 6905 User Manual
DISHWASHER
ZT 6905
INSTRUCTION BOOK
152977 34/1
UK
COP04
2
The control panel
Description of the appliance
1. Levelling spacers
2. Upper basket stop
3. Upper spray arm
4. Salt container
5. Large filter
6. Detergent dispenser
7. Control panel
8. Rating plate
9. Rinse aid dispenser
10. Central filter
11. Lower spray arm
12. Upper basket
13. SID detergent dispenser
(Super Intensity Dispenser)
In this fully integrated appliance the controls are located
on the top of the door. When selecting a programme, the
door needs to be open.
1. ON/OFF push button
2. HALF LOAD push button
3. SALT indicator light
4. ON/OFF indicator light
5. Programme selector push buttons
6. "END OF CYCLE" indicator light
Audible signals have been introduced to help indicate
which operations the dishwasher is performing.
Short signal "instruction accepted"
When any of the push buttons are pressed (except the
ON/OFF push button), a short audible signal informs you
that the machine has accepted the instruction given.
Long signal "programme starting"
A continuous audible signal, heard only when you close
the dishwasher door, informs you that the washing
programme is starting.
Intermittent signal "end of programme"
An intermittent audible signal informs you that the wash
programme has ended.
If you wish to deactivate these audible signals, press both
programme buttons 3 and 4 for about 3 seconds, until the
intermittent audible signal can no longer be heard.
To reactivate the audible signals, press buttons together
again for about 3 seconds, until an intermittent audible
signal is heard.
The setting will remain memorised after switching off
the dishwasher.
1
2
3
4
5
6
IN72
13
12
11
10
9
8
7
SO323
3
Type of load
Degree of soil
and
type of load
Required
push buttons
Recommended quantity
of detergent
wash prewash
Cycle
description
PRO20en
Washing programmes
RINSE
&
HOLD
INTENSIVE
70°C
NORMAL
65°C
*
BIO
50°C
**
QUICK
50°C
Hot prewash
Main wash up to 70°C
2 cold rinses
1 hot rinse
Drying
Warm prewash
Main wash up to 65°C
1 cold rinse
1 hot rinse
Drying
Cold prewash
Main wash up to 50°C
1 cold rinse
1 hot rinse
Drying
Main wash up to 50°C
1 cold rinse
1 hot rinse
1 cold rinse
(to avoid food scraps from
sticking together).
Any.
Partial load (to be
completed later in
the day)
Heavy soil.
Crockery, cutlery,
pots and pans
Normal soil.
Crockery and
cutlery
Normal soil.
Crockery and
cutlery
Light soil.
Crockery and party
crockery
ON/OFF
+
RINSE & HOLD
ON/OFF
+
INTENSIVE 70°C
ON/OFF
+
NORMAL 65°C
ON/OFF
+
BIO 50°C
ON/OFF
+
QUICK 50°C
**
This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery
(except pots) so that you may re-use them promptly.
Important!
If you select the “HALF LOAD” push button, load crockery, cutlery, pots and pans only in the lower basket and
remember to reduce the quantity of detergent.
*
Testing programme for EN 50242 (see "Hints for Test Centres).
25 g 5 g
25 g 5 g
30 g /
25 g 10 g
//
This dishwasher model is supplied with the SID detergent
dispenser, located in the centre of the upper basket.
In this case add the required detergent for the prewash in
the SID.
Check that the SID is not clogged with detergent residue.
If necessary rinse it under running water after having
removed it from the basket by twisting it anticlockwise and
pulling it upwards.
Fasten it back onto the support by turning it clockwise.
Never use your dishwasher without the SID
dispenser.
Since SID also ensures correct distribution of
the water to the upper spray arm, running the
dishwasher without it will impair the washing
results.
Protection against flooding
This dishwasher model is fitted with a device in the bottom
of the machine to protect against flooding.
The device will operate if there are any water leakage in
the machine, however it will operate if the machine is on.
In case of intervention, turn the water tap and call the
Service Force Centre.
MA12
DE14
4
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON/OFF push button
The ON/OFF indicator light comes on.
3. Check that there is rinse aid and
salt
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing programmes"
chart.
Close the detergent dispenser lid.
7. Set the programme
The selection of a programme occurs with the door
partially opened.
Press the programme push button which
corresponds to the washing programme you wish to
select, the corresponding indicator light will flash.
If necessary, press the HALFLOAD push button.
8. Start the programme
Close the door.
An audible signal advises you that the programme
has started.
The indicator light which corresponds to the
programme under way is now permanently on.
9. At the end of the washing
programme
At the end of the programme the dishwasher will
automatically stop and an audible signal informs you
that the programme has finished.
The "END OF CYCLE" indicator lights flashes.
The ON/OFF indicator light remains on until the
ON/OFF push button is depressed.
10. Switch off the dishwasher
Wait 15/20 minutes before opening the
dishwasher’s door; in this way you will avoid
burning yourself when removing the dishes and
avoid also the damage of the nearby furniture
caused by the escape of steam.
Switch off the dishwasher by pressing the ON/OFF
push button and open the door.
Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
onto the dishes in the lower one.
When the washing programme has finished, it
is recommended that the dishwasher is
unplugged and the water tap turned off.
In general it is not advisable to open the door
while the machine is working; if the door is
opened however, a safety device ensures that
the machine stops.
Important!
Care must be taken if the door is opened during
the hot phase or immediately after a
programme has finished, as steam may escape.
Operating sequence
5
Loading your appliance
Before placing dishes in the machine, remove any scraps of
food, to avoid clogging the filters and consequently reducing
the performance.
Do not load very small items which can fall
through the baskets.
The lower basket
The lower basket is designed to take saucepans, lids,
plates, salad bowls, cutlery etc.
Serving dishes and large lids should be arranged around the
edge of the basket, ensuring that the upper spray arm can
turn freely.
The two rear rows of prongs on the lower basket can be
easily lowered to allow you to load pots, pans and bowls.
To lower the prongs:
- Slightly pull them upward and let them drop down
(see picture).
- To bring them back to the standing position, just pull
them up again.
The cutlery basket
Long bladed knives stored in an upright position
are a potential hazard.
These items should only be placed in the
removable knife basket.
Take care when loading or unloading sharp items
such as knives.
Cutlery should be placed in the removable cutlery basket
with the handles facing downwards.
If the handles protrude from the bottom of the basket,
obstructing the lower spray arm, load the cutlery with the
handles facing upwards.
Mix spoons with other cutlery to prevent them from sticking
together.
For best results use the cutlery grid/s inserts provided.
The cutlery basket is in two parts which can be separated to
give greater loading flexibility. To separate the two parts,
slide them horizontally in opposite directions and pull them
apart. To reassemble, reverse the procedure.
Using your appliance
UI48
UI21
UI85
UI62
UI63
UI18
6
The upper basket
The upper basket is designed for plates (dessert plates,
saucers, dinner plates of up to 25 cm in diameter), salad
bowls, cups and glasses.
Arrange items on and underneath the fold-down cup racks
so that water can reach all surfaces.
For taller items, the cup racks can be folded upwards.
Light items (plastic bowls etc.) should be loaded in the upper
basket and arranged so they do not move.
In case that plates are loaded in the upper
basket:
load them starting from the rear positions of the
basket, tilting them slightly forwards and avoiding the
front positions near the door.
Before closing the door, ensure that the spray
arms can rotate freely.
Adjusting the height of the upper
basket
If washing very large plates (over 27 cm and up to 32 cm in
diameter) you can load them in the lower basket after
moving the upper basket to the higher position.
To move to the higher position proceed as follows:
1. Move the front runner stops (A) of the upper basket
outwards and slide the basket out.
2. Refit the basket in the higher position and replace the
stops (A) in their original position.
When the top basket is in the higher position it
will only take plates up to 20 cm in diameter and
you will not be able to use the raised cup racks.
After loading your machine always close the
door, as an open door can be a hazard.
US47
A
RC01
US71
Dimensions Width 59.6 cm
Height 81.8 - 87.8 cm
Max depth 55.5 cm
Max depth with open door 11 1.4 cm
Electrical connection Voltage 220/240 V - 50 Hz
Motor rating during wash 200 W
Power of heating element 2100 W
Overall power 2300 W
Water supply pressure Minimum 50 kPa (0.5 bar)
Maximum 800 kPa (8 bar)
Capacity 12 place settings
Technical specifications
7
Hints for test centres
Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser
Test standard: EN 50242
Reference programme: BIO 50°c
Load: 12 standard place settings
Rinse aid selector: position 5
Detergent dosage: 25 g in the dispenser
5 g on the dispenser lid
Arrangement upper basket
Arrangement lower basket
Arrangement cutlery basket
Instruction Book - part 1
- Before use
- Maintenance
- Installation
1
Contents
Important safety information 2
Before use 3
Setting the water softener 3
Filling with salt 4
Filling with rinse aid and adjusting the dose 5
Use of detergent 6
Hints and tips 7
Maintenance and cleaning 8
Internal cleaning 8
Cleaning the filters 8
External cleaning 8
Prolonged periods of non-operation 8
Frost precautions 8
Moving the machine 8
Something not working 10
Installation 12
Water supply connections 12
Water outlet connection 13
Electrical connection 14
Guide to use the instruction book
Safety instructions
1. 2. 3. Step by step
Hints and tips
Environmental information
DISHWASHER
152981 52/1
Installation
● This appliance is heavy. Care should be taken when
moving it.
● It is dangerous to alter the specifications or attempt to
modify this product in any way.
● Care must be taken to ensure that the appliance does
not stand on the electrical supply cable.
● Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
● Any plumbing work required to install this appliance
should be carried out by a qualified plumber or
competent person.
Child Safety
● This appliance is designed to be operated by adults.
Children should not be allowed to tamper with the
controls or play with the product.
● Keep all packaging well away from children.
● Keep all detergents in a safe place out of children's
reach.
During Use
● Items that are contaminated by petrol, paint, steel or
iron debris, corrosive, acidic or alkaline chemicals
must not be washed in this dishwasher.
● Under no circumstances should you open the door
whilst the appliance is in operation. Always turn off the
appliance before opening the door.
● Only use detergent specifically designed for use in
dishwashers.
● Long bladed knives stored in an upright position are
a potential hazard.
● Long and/or sharp items of cutlery such as carving
knives must be positioned horizontally in the upper
basket.
● When finishing loading or unloading close the door, as
an open door can be a hazard.
● Do not sit or stand on the open door.
● Isolate the appliance from the power supply and turn
off the water supply after use.
● Care should be taken when cleaning the bottom door
seal and hinge area as any exposed metal edges may
cut if care is not taken.
● This product should be serviced by an authorised
Service engineer, and only genuine spare parts
should be used.
● Under no circumstances should you attempt to repair
the machine yourself. Repairs carried out by
inexperienced persons may cause injury or serious
malfunctioning. Contact your local Service Force
Centre. Always insist on genuine spare parts.
Conservation
In the interest of the environment:
● Materials marked with the symbol are recyclable.
● Check with your local Council or Environmental
Health Office to see if there are facilities in your area
for re-cycling this appliance.
● When the appliance is to be scrapped, cut off the
power supply cable and make the door closing device
unusable to prevent young children from being
trapped inside.
● Help to keep your country tidy - use authorised
disposal sites for your old appliance.
2
Important safety information
It is most important that this instruction book should be retained with the appliance for future reference. Should
the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always
ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the
appliance and the relevant safety information.
This information has been provided in the interest of your safety. You MUST read it carefully before installing or
using the appliance.
Loading...