GETTING
STARTED?
EASY.
User Manual
ZRA40113WA
ZRA40144WA
EN User Manual
Refrigerator
SAFETY INFORMATION
Before the installation and use of the appliance, carefully read the
supplied instructions. The manufacturer is not responsible for any
injuries or damages that are the result of incorrect installation or
usage. Always keep the instructions in a safe and accessible
location for future reference.
CHILDREN AND VULNERABLE PEOPLE SAFETY
• This appliance can be used by children aged 8 years and
above and by persons with reduced capabilities provided that
they have been given instruction and/or supervision regarding
the safe use of the appliance and understand the potential
hazards involved.
• Do not let children play with the appliance.
• Children shall not carry out cleaning and user maintenance of
the appliance without supervision.
• Keep all packaging away from children and dispose of it
appropriately.
GENERAL SAFETY
• This appliance is intended to be used in household and similar
applications such as:
– Farm houses; staff kitchen areas in shops, offices and other
working environments
– By clients in hotels, motels, bed and breakfast and other
residential type environments
• Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction.
• Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the
manufacturer.
• Do not damage the refrigerant circuit.
• Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
• Do not use water spray and steam to clean the appliance.
2
• Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
• Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
• Remove all the packaging and the transit bolts.
• Do not install or use a damaged appliance.
• Follow the installation instruction supplied with
the appliance.
• Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
• Do not install the appliance close to radiators or
cookers, oven or hobs.
• The rear of the appliance must stand against the
wall.
• Do not install the appliance where there is direct
sunlight.
• Do not install this appliance in areas that are too
humid or too colds, such as the construction
appendices, garages or wine cellars.
• When you move the appliance, lift it by the front
edge to avoid scratching the floor.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electrical
shock.
• The appliance must be earthed.
• Make sure that the electrical information on the
rating plate agrees with the power supply. If not,
contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and extension
cables.
• Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service
Centre or an electrician to change the electrical
components.
• The mains cable must stay below the level of the
mains plug.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
USE
WARNING! Risk of injury, burns,
electrical shock or fire.
• Do not change the specification of this
appliance.
• Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
• Be careful not to cause damage to the
refrigerant circuit. It contains isobutane (R600a),
a natural gas with a high level of environmental
compatibility. This gas is flammable.
• If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of
ignition in the room. Ventilate the room.
• Do not let hot items to touch the plastic parts of
the appliance.
• Do not store flammable gas and liquid in the
appliance.
• Do not put flammable products or items that are
wet with flammable products in, near or on the
appliance.
• Do not touch the compressor or the condenser.
They are hot.
3
CARE AND CLEANING
WARNING! Risk of injury or damage
to the appliance.
• Before maintenance, deactivate the appliance
and disconnect the mains plug from the mains
socket.
• This appliance contains hydrocarbons in the
cooling unit. Only a qualified person must do the
maintenance and the recharging of the unit.
• Regularly examine the drain of the appliance and
if necessary, clean it. If the drain is blocked,
defrosted water collects in the bottom of the
appliance.
DISPOSAL
WARNING! Risk of injury or
suffocation.
• Disconnect the appliance from the mains
supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children and pets
to be closed inside of the appliance.
• The refrigerant circuit and the insulation
materials of this appliance are ozone-friendly.
• The insulation foam contains flammable gas.
Contact your municipal authority for information
on how to discard the appliance correctly.
• Do not cause damage to the part of the cooling
unit that is near the heat exchanger.
CONTROL PANEL
SWITCHING ON
1. Connect the mains plug to the mains socket.
2. Turn the Temperature regulator clockwise to a
medium setting.
SWITCHING OFF
To turn off the appliance, turn the Temperature
regulator to the "O" position.
TEMPERATURE REGULATION
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
1. turn the temperature regulator towards lower
settings to obtain the minimum coldness
2. turn the temperature regulator towards higher
settings to obtain the maximum coldness
A medium setting is generally the most
suitable. However, the exact setting
should be chosen keeping in mind that
the temperature inside the appliance
depends on:
• room temperature
• frequency of opening the door
• quantity of food stored
• appliance location.
If the ambient temperature is high or
the appliance is fully loaded, and the
appliance is set to the lowest
temperature, it may run continuously
causing frost to form on the rear wall.
In this case the temperature regulator
must be set to a higher temperature to
allow automatic defrosting and reduce
energy consumption this way.
CARE AND CLEANING
WARNING! Refer to Safety chapters.
CLEANING THE INTERIOR
Before using the appliance for the first time, wash
the interior and all internal accessories with
4
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive
powders, as these will damage the
finish.
PERIODIC CLEANING
CAUTION! Do not pull, move or
damage any pipes and/or cables
inside the cabinet.
CAUTION! Take care of not to
damage the cooling system.
CAUTION! When moving the cabinet,
lift it by the front edge to avoid
scratching the floor.
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral soap.
2. Regularly check the door seals and wipe clean
to ensure they are clean and free from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
compressor at the back of the appliance with a
brush.
This operation will improve the performance of
the appliance and save electricity consumption.
DEFROSTING OF THE REFRIGERATOR
Frost is automatically eliminated from the
evaporator of the refrigerator compartment every
time the motor compressor stops, during normal
use. The defrost water drains out through a trough
into a special container at the back of the
appliance, over the motor compressor, where it
evaporates.
It is important to periodically clean the defrost water
drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
PERIODS OF NON-OPERATION
When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the door/doors open to prevent
unpleasant smells.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem Possible cause Solution
The appliance is noisy. The appliance is not suppor-
ted properly.
Check if the appliance stands
stable.
The compressor operates
continually.
Temperature is set incorrectly.
Refer to "Operation" chapter.
5
Problem Possible cause Solution
Many food products were put
in at the same time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on
the rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
Water flows inside the refrigerator.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evaporative tray above the compressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the appliance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The food products' temperature is too high.
Let the food products temperature decrease to room temperature before storage.
Many food products are stored at the same time.
Store less food products at the
same time.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
1. Disconnect the plug from the mains socket.
2. Push the movable part of the lamp cover (1) to
unhook it.
3. Remove the lamp cover (2).
2
1
4. Replace the bulb with one of the same power
and shape, specifically designed for household
appliances.
5. Install the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
switches on.
6
INSTALLATION
WARNING! Refer to Safety chapters.
POSITIONING
This appliance can be installed in a dry, well
ventilated indoor where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ELECTRICAL CONNECTION
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
A B
C
D
E
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and yellow to
the terminal marked either with the letter “E“ or
by the earth symbol or coloured green and
yellow.
2. Connect the wire coloured blue to the terminal
either marked with the letter “N“ or coloured
black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or coloured
red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over
the outer sheath.
Make sure the electricity supply voltage is the
same as that indicated on the appliance rating
plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B).
In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
WARNING! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
7
INSTALLATION OF THE APPLIANCE AND
DOOR REVERSAL
Please refer to separate instructions
on installation (ventilation
requirements, levelling) and door
reversal.
TECHNICAL DATA
Height 1850 mm
Width 595 mm
Depth 658 mm
Voltage 230 - 240 V
Frequency 50 Hz
The technical information is situated in the rating
plate, on the external or internal side of the
appliance and in the energy label.
ENVIRONMENT CONCERNS
Please recycle all materials marked with the symbol
. Dispose of all packaging materials
appropriately and help to protect the environment,
and future generations. Do not dispose of electrical
equipment marked with the symbol along with
the general house hold waste. Dispose all electrical
goods via applicable local authority collections, or
at local authority or, commercial recycling centres.
8
*
9
10
11
WWW.ZANUSSI.COM/SHOP
280155966-A-122016
Loading...