Zanussi ZOG15311 User Manual

EN

ZOG15311

User Manual

Oven

EG

Contents

Safety information 2
Safety instructions 3
Product description 6
Before first use 6
Daily use 7
Clock functions

9

Using the accessories

10

Additional functions 11
Hints and tips 11
Care and cleaning 14
Troubleshooting 15
Installation 16
Technical information

19

Subject to change without notice.

Safety information

Before the installation and use of the appliance, carefully read the
supplied instructions. The manufacturer is not responsible if an
incorrect installation and use causes injuries and damages.
Always keep the instructions with the appliance for future
reference.

Children and vulnerable people safety

• This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.

• Do not let children play with the appliance.

• Keep all packaging away from children.

• Keep children and pets away from the appliance when it

operates or when it cools down. Accessible parts are hot.

• If the appliance has a child safety device, we recommend you

activate it.

• Cleaning and user maintenance shall not be made by children

without supervision.

• Children of less than 3 years should be kept away unless

continuously supervised.

General Safety

• Only a qualified person must install this appliance and replace

the cable.

2 www.zanussi.com

• Internally the appliance becomes hot when in operation. Do not

touch the heating elements that are in the appliance. Always
use oven gloves to remove or put in accessories or ovenware.

• Before maintenance cut the power supply.

• Ensure that the appliance is switched off before replacing the

lamp to avoid the possibility of electric shock.

• Do not use a steam cleaner to clean the appliance.

• Do not use harsh abrasive cleaners or sharp metal scrapers to

clean the glass door since they can scratch the surface, which
may result in shattering of the glass.

• If the supply cord is damaged, it must be replaced by the

manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.

• To remove the shelf supports first pull the front of the shelf

support and then the rear end away from the side walls. Install
the shelf supports in the opposite sequence.

Safety instructions

This appliance is suitable for the following
markets: EG

Installation

WARNING!

Only a qualified person must install
this appliance.

• Remove all the packaging.

• Do not install or use a damaged appliance.

• Obey the installation instruction supplied
with the appliance.

• Always be careful when you move the
appliance because it is heavy. Always wear
safety gloves.

• Do not pull the appliance by the handle.

• Keep the minimum distance from the other
appliances and units.

• Make sure that the appliance is installed
below and adjacent safe structures.

• The sides of the appliance must stay
adjacent to appliances or to units with the
same height.

• Do not operate the appliance without the
cavity bottom cover. It is a functional safety
component.

• The appliance is equipped with an electric
cooling system. It must be operated with the
electric power supply.

Electrical connection

WARNING!

Risk of fire and electrical shock.

• All electrical connections should be made by
a qualified electrician.

• The appliance must be earthed.

• Make sure that the electrical information on
the rating plate agrees with the power
supply. If not, contact an electrician.

• Always use a correctly installed shockproof
socket.

• Do not use multi-plug adapters and
extension cables.

• Make sure not to cause damage to the
mains plug and to the mains cable. Should
the mains cable need to be replaced, this
must be carried out by our Authorised
Service Centre.

• Do not let mains cables touch or come near
the appliance door, especially when the door
is hot.

www.zanussi.com 3

• The shock protection of live and insulated
parts must be fastened in such a way that it
cannot be removed without tools.

• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.

• If the mains socket is loose, do not connect
the mains plug.

• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.

• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.

• The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.

• This appliance complies with the E.E.C.
Directives.

Gas connection

• All gas connections must be made by a
qualified person.

• Before installation, make sure that the local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.

• Make sure that there is air circulation around
the appliance.

• The information about the gas supply is on
the rating plate.

• This appliance is not connected to a device,
which evacuates the products of
combustion. Make sure to connect the
appliance according to current installation
regulations. Pay attention to requirements
regarding adequate ventilation.

Use

WARNING!

Risk of injury, burns and electrical
shock or explosion.

• Use this appliance in a household only.

• Do not change the specification of this
appliance.

• Make sure that the ventilation openings are
not blocked.

• Do not let the appliance stay unattended
during operation.

• Deactivate the appliance after each use.

• Be careful when you open the appliance
door while the appliance is in operation. Hot
air can release.

• Do not operate the appliance with wet hands
or when it has contact with water.

• Do not apply pressure on the open door.

• Do not use the appliance as a work surface
or as a storage surface.

• Open the appliance door carefully. The use
of ingredients with alcohol can cause a
mixture of alcohol and air.

• Do not let sparks or open flames to come in
contact with the appliance when you open
the door.

• Do not put flammable products or items that
are wet with flammable products in, near or
on the appliance.

WARNING!

Risk of damage to the appliance.

• To prevent damage or discoloration to the
enamel:

– do not put ovenware or other objects in

the appliance directly on the bottom.

– do not put aluminium foil directly on the

bottom of the appliance.

– do not put water directly into the hot

appliance.

– do not keep moist dishes and food in the

appliance after you finish the cooking.

– be careful when you remove or install

the accessories.

• Discoloration of the enamel has no effect on
the performance of the appliance. It is not a
defect in the sense of the warranty law.

• Use a deep pan for moist cakes. Fruit juices
cause stains that can be permanent.

• This appliance is for cooking purposes only.
It must not be used for other purposes, for
example room heating.

• Always cook with the oven door closed.

• If the appliance is installed behind a furniture
panel (e.g. a door) make sure the door is
never closed when the appliance is in
operation. Heat and moisture can build up
behind a closed furniture panel and cause
subsequent damage to the appliance, the
housing unit or the floor. Do not close the
furniture panel until the appliance has cooled
down completely after use.

4 www.zanussi.com

Care and cleaning

WARNING!

Risk of injury, fire, or damage to the
appliance.

• Before maintenance, deactivate the
appliance and disconnect the mains plug
from the mains socket.

• Make sure the appliance is cold. There is the
risk that the glass panels can break.

• Replace immediately the door glass panels
when they are damaged. Contact the
Authorised Service Centre.

• Be careful when you remove the door from
the appliance. The door is heavy!

• Clean regularly the appliance to prevent the
deterioration of the surface material.

• Remaining fat or food in the appliance can
cause fire.

• Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads,
solvents or metal objects.

• If you use an oven spray, obey the safety
instructions on the packaging.

• Do not clean the catalytic enamel (if
applicable) with any kind of detergent.

Internal light

• The type of light bulb or halogen lamp used
for this appliance is only for household
appliances. Do not use it for house lighting.

WARNING!

Risk of electrical shock.

• Before replacing the lamp, disconnect the
appliance from the power supply.

• Only use lamps with the same specifications.

Disposal

WARNING!

Risk of injury or suffocation.

• Contact your municipal authority for
information on how to discard the appliance
correctly.

• Disconnect the appliance from the mains
supply.

• Cut off the mains cable and discard it.

• Flat the external gas pipes.

Service

• To repair the appliance contact an
Authorised Service Centre.

• Use original spare parts only.

www.zanussi.com 5

Product description

General overview

1

2 63 4

12

5

1

13

5

4

3

2

1

7

8

9

11

10

1

Control panel

2

Gas block indicator

3

Knob for the oven functions

4

Electronic programmer

5

Knob for the temperature

6

Temperature lamp / symbol / indicator

7

Air vents for the cooling fan

8

Heating element

9

Lamp

10

Turnspit hole

11

Oven cavity bottom plate

12

Shelf support, removable

13

Shelf positions

When you buy the appliance, at first
the oven cavity bottom plate is
positioned on the accessories.
Before you use the appliance for the
first time, place the bottom plate on
the burner area, as shown in the
general overview.

Accessories

• Wire shelf

For cookware, cake tins, roasts.

• Baking tray
For cakes and biscuits.

• Aluminium baking tray
For cakes and biscuits.

• Turnspit
For roasting larger joints of meat and poultry.

Before first use

WARNING!

Refer to Safety chapters.

Oven cavity bottom plate

When you buy the appliance, at first the oven
cavity bottom plate is positioned on the
accessories. Before you use the appliance for
the first time, place the bottom plate on the
burner area, as shown in the "Product
description" chapter.

Initial Cleaning

Remove all accessories and removable shelf
supports from the appliance.

Refer to "Care and cleaning"
chapter.

Clean the appliance before first use.
Put the accessories and the removable shelf
supports back to their initial position.

Setting the time

You must set the time before you operate the
oven.

The indicator for the Time of day function
flashes when you connect the appliance to the
electrical supply, when there was a power cut
or when the timer is not set.

Press the

or button to set the correct

time.

6 www.zanussi.com

After approximately five seconds, the flashing
stops and the display shows the time of day you
set.

Changing the time

You cannot change the time of day if
the Duration or End function

operates.

Press again and again until the indicator for
the Time of Day function flashes.
To set a new time, refer to "Setting the time".

Preheating

Preheat the empty appliance to burn off the
remaining grease.

1. Set the function and the maximum

temperature.

2. Let the appliance operate for 1 hour.

3. Set the function and the maximum

temperature.

4. Let the appliance operate for 15 minutes.

Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow in the room is
sufficient.

Let the oven cool down. Dampen a soft cloth
with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.

Daily use

WARNING!

Refer to Safety chapters.

Oven functions

Oven function Application

Off position The appliance is off.

Light To activate the lamp without a cooking function.

Grill To grill flat food items in small quantities in the middle of the

shelf. To make toasts.

Grill + Turnspit To grill meat, including kebabs and smaller pieces of meat.

Gas oven See the cooking tables.

Gas block warning indicator

This light comes on to indicate gas block and a
burner shutdown. To eliminate the block, turn
the knob for the oven functions and the knob for
the temperature to the Off position "0", wait for
one minute and then repeat the lighting
operation.

Temperature indicator

The temperature indicator comes on when the
oven heats up. It goes off when the oven is at its
correct temperature. It then cycles on and off to
show that the temperature adjusts.

www.zanussi.com 7

Display

A B C

A) Function indicators
B) Time display
C) Function indicator

Buttons

Button Function Description

MINUS To set the time.

CLOCK To set a clock function.

PLUS To set the time.

Ignition of oven gas burner

When you use the oven for the first
time, several lighting attempts are
normally required due to the
presence of air in the gas pipe.

The oven cannot be lit with a naked flame.

1. Turn the knob for the oven functions to .
The oven light comes on.

2. Turn the knob for the temperature to select
the temperature.

The temperature lamp / indicator comes on.
The oven starts the lightning phase after about
5 seconds.

The ignition cycle is 12 - 16
seconds of sparking. It is performed
maximum four times.

In case of ignition failure, after 40 - 45 seconds
of stand-by, the Gas block warning indicator
comes on and the flow of gas is stopped. To try
lighting again, turn the knob for the oven
functions and the knob for the temperature to
the Off position, wait for one minute then repeat
the operations described above.

In case of a power failure during the
gas oven operation, the oven
deactivates and the gas flow is
stopped. When the power is
restored, reset the clock functions
before you use the appliance again.

The flame is visible through the front
holes of the bottom of the oven.
When the temperature indicator is
off, also the burner is off.

When you switch off the oven during
the operation and you turn in on
immediately, it is normal to have a
maximum 60 seconds of stand-by
before the ignition starts.

Grilling

1. To activate only the electric grill, turn the

knob for the oven functions to and set
the maximum temperature.

2. To activate the electric grill with turnspit,
turn the knob for the oven functions to

and set the maximum temperature.

3. Adjust the grill and the deep pan runner
position to allow for different thickness of
food.

8 www.zanussi.com