Zanussi ZOG10311XK User Manual

GETTING
STARTED?

EASY.

User Manual

ZOG10311XK

EN User Manual

Oven

EG

SAFETY INFORMATION

Before the installation and use of the appliance, carefully read the
supplied instructions. The manufacturer is not responsible for any
injuries or damages that are the result of incorrect installation or
usage. Always keep the instructions in a safe and accessible
location for future reference.

CHILDREN AND VULNERABLE PEOPLE SAFETY

• This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards involved.

• Children between 3 and 8 years of age and persons with very

extensive and complex disabilities shall be kept away unless
continuously supervised.

• Children of less than 3 years of age should be kept away

unless continuously supervised.

• Do not let children play with the appliance.

• Keep all packaging away from children and dispose of it

appropriately.

• Keep children and pets away from the appliance when it

operates or when it cools down. Accessible parts are hot.

• If the appliance has a child safety device, it should be activated.

• Children shall not carry out cleaning and user maintenance of

the appliance without supervision.

GENERAL SAFETY

• Only a qualified person must install this appliance and replace

the cable.

• WARNING: The appliance and its accessible parts become hot

during use. Care should be taken to avoid touching heating
elements.

• Always use oven gloves to remove or put in accessories or

ovenware.

2

• Before carrying out any maintenance, disconnect the appliance

from the power supply.

• Ensure that the appliance is switched off before replacing the

lamp to avoid the possibility of electric shock.

• Do not use a steam cleaner to clean the appliance.

• Do not use harsh abrasive cleaners or sharp metal scrapers to

clean the glass door since they can scratch the surface, which
may result in shattering of the glass.

• If the mains power supply cable is damaged, it must be

replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.

• To remove the shelf supports first pull the front of the shelf

support and then the rear end away from the side walls. Install
the shelf supports in the opposite sequence.

SAFETY INSTRUCTIONS

This appliance is suitable for the following markets:

EG

INSTALLATION

WARNING! Only a qualified person

must install this appliance.

• Remove all the packaging.

• Do not install or use a damaged appliance.

• Follow the installation instructions supplied with
the appliance.

• Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.

• Do not pull the appliance by the handle.

• Keep the minimum distance from other
appliances and units.

• Install the appliance in a safe and suitable place
that meets installation requirements.

• Do not operate the appliance without the cavity
bottom cover. It is a functional safety
component.

• The appliance is equipped with an electric
cooling system. It must be operated with the
electric power supply.

ELECTRICAL CONNECTION

WARNING! Risk of fire and electric

shock.

• All electrical connections should be made by a
qualified electrician.

• The appliance must be earthed.

• Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.

• Always use a correctly installed shockproof
socket.

• Do not use multi-plug adapters and extension
cables.

• Make sure not to cause damage to the mains
plug and to the mains cable. Should the mains
cable need to be replaced, this must be carried
out by our Authorised Service Centre.

• Do not let mains cables touch or come near the
appliance door, especially when the door is hot.

• The shock protection of live and insulated parts
must be fastened in such a way that it cannot be
removed without tools.

• Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.

• If the mains socket is loose, do not connect the
mains plug.

• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.

3

• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.

• The electrical installation must have an isolation
device which lets you disconnect the appliance
from the mains at all poles. The isolation device
must have a contact opening width of minimum
3 mm.

• This appliance complies with the E.E.C.
Directives.

GAS CONNECTION

• All gas connections must be made by a qualified
person.

• Before installation, make sure that the local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.

• Make sure that there is air circulation around the
appliance.

• The information about the gas supply is on the
rating plate.

• This appliance is not connected to a device,
which evacuates the products of combustion.
Make sure to connect the appliance according
to current installation regulations. Pay attention
to requirements regarding adequate ventilation.

USE

WARNING! Risk of injury, burns and

electric shock or explosion.

• Do not change the specification of this
appliance.

• Make sure that the ventilation openings are not
blocked.

• Do not let the appliance stay unattended during
operation.

• Deactivate the appliance after each use.

• Be careful when you open the appliance door
while the appliance is in operation. Hot air can
release.

• Do not operate the appliance with wet hands or
when it has contact with water.

• Do not apply pressure on the open door.

• Do not use the appliance as a work surface or
as a storage surface.

• Open the appliance door carefully. The use of
ingredients with alcohol can cause a mixture of
alcohol and air.

• Do not let sparks or open flames to come in
contact with the appliance when you open the
door.

• Do not put flammable products or items that are
wet with flammable products in, near or on the
appliance.

WARNING! Risk of damage to the
appliance.

• To prevent damage or discoloration to the
enamel:

– do not put aluminium foil directly on the

bottom of cavity of the appliance.

– do not put water directly into the hot

appliance.

– do not keep moist dishes and food in the

appliance after you finish the cooking.

– be careful when you remove or install the

accessories.

• Discoloration of the enamel or stainless steel
has no effect on the performance of the
appliance.

• Use a deep pan for moist cakes. Fruit juices
cause stains that can be permanent.

• This appliance is for cooking purposes only. It
must not be used for other purposes, for
example room heating.

• Always cook with the oven door closed.

• If the appliance is installed behind a furniture
panel (e.g. a door) make sure the door is never
closed when the appliance is in operation. Heat
and moisture can build up behind a closed
furniture panel and cause subsequent damage
to the appliance, the housing unit or the floor.
Do not close the furniture panel until the
appliance has cooled down completely after
use.

CARE AND CLEANING

WARNING! Risk of injury, fire, or

damage to the appliance.

• Before maintenance, deactivate the appliance
and disconnect the mains plug from the mains
socket.

• Make sure the appliance is cold. There is the
risk that the glass panels can break.

• Replace immediately the door glass panels
when they are damaged. Contact the
Authorised Service Centre.

• Be careful when you remove the door from the
appliance. The door is heavy!

• Clean regularly the appliance to prevent the
deterioration of the surface material.

• Clean the appliance with a moist soft cloth. Only
use neutral detergents. Do not use any abrasive
products, abrasive cleaning pads, solvents or
metal objects.

4

• If you use an oven spray, follow the safety
instruction on it's packaging.

• Do not clean the catalytic enamel (if applicable)
with any kind of detergent.

INTERNAL LIGHTING

WARNING! Risk of electric shock.

• The type of light bulb or halogen lamp used for
this appliance is for household appliances only.
Do not use it for house lighting.

• Before replacing the lamp, disconnect the
appliance from the power supply.

• Only use lamps with the same specifications.

SERVICE

• To repair the appliance contact an Authorised
Service Centre.

• Use original spare parts only.

DISPOSAL

WARNING! Risk of injury or

suffocation.

• Contact your municipal authority for information
on how to discard the appliance correctly.

• Disconnect the appliance from the mains
supply.

• Cut off the mains electrical cable close to the
appliance and dispose of it.

• Flat the external gas pipes.

PRODUCT DESCRIPTION

GENERAL OVERVIEW

1

52 3 4

1

11

5

4

3

2

1

6

7

8

10

9

1

Control panel

2

Knob for the heating functions

3

Knob for the Minute Minder

4

Knob for the gas control

5

Power indicator

6

Air vents for the cooling fan

7

Heating element

8

Lamp

9

Turnspit hole

10

Oven cavity bottom plate

11

Shelf positions

ACCESSORIES

• Wire shelf
For cookware, cake tins, roasts.

• Baking tray
For cakes and biscuits.

• Aluminium baking tray
For cakes and biscuits.

• Turnspit
For roasting larger joints of meat and poultry.

BEFORE FIRST USE

WARNING! Refer to Safety chapters.

OVEN CAVITY BOTTOM PLATE

When you buy the oven, at first the oven cavity
bottom plate is together with the accessories.
Before you use the oven for the first time, put the
bottom plate with the hole on its front part in the

5

burner area, as shown in "Product description"
chapter.

INITIAL CLEANING

Remove all accessories and removable shelf
supports from the oven.

Refer to "Care and cleaning" chapter.

Clean the oven and the accessories before first
use.

Put the accessories and the removable shelf
supports back to their initial position.

PREHEATING

Preheat the empty appliance before first use.

1. Set the maximum temperature.

2. Let the appliance operate for 1 hour.

3. Set the function .

4. Let the appliance operate for 15 minutes.

Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.

Let the oven cool down. Dampen a soft cloth with
warm water and a little mild washing-up liquid and
use this to clean the oven cavity.

DAILY USE

WARNING! Refer to Safety chapters.

IGNITION OF OVEN GAS BURNER

Oven safety device:

The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.

1. Press the knob for the gas control and turn it to
.

2. Keep the knob for the gas control pushed for

15 seconds or less to let the thermocouple
warm up. Do not release the knob until the

flame ignites, otherwise the gas flow is
interrupted.

Do not keep the knob for the gas control pushed
for more than 15 seconds. If the oven burner does
not ignite after 15 seconds, release the knob for the
gas control, turn it into off position, open the oven
door. Wait minimum 1 minute, close the oven door
and try to ignite the oven burner again.

AFTER IGNITING THE OVEN GAS BURNER

1. Release the knob for the gas control.

2. Turn the knob for the gas control to set the

temperature.

Control the flame through the holes in the cavity
bottom plate.

KNOB FOR THE GAS CONTROL

Symbol Function

Conventional Cooking

Heat from the bottom of the oven. Range of temperature adjustment
(150 °C - 250 °C).

Grilling

Heats from the top.

6

OVEN FUNCTIONS

Oven function Application

Off position

The oven is off.

Light

To turn on the lamp without a cooking function.

Turnspit

To roast larger pieces of meat on the turnspit.

USING THE GRILL

Oven safety device:

The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.

1. Press the knob for the gas control and turn it to
. Keep the knob for the gas control pushed

for 15 seconds or less. Do not release the
knob until the flame ignites.

2. Release the knob for the gas control.
Do not keep the knob for the gas control pushed

for more than 15 seconds. If the grill burner does
not ignite after 15 seconds, release the knob for the
gas control, turn it into off position, open the oven
door. Wait minimum 1 minute, close the oven door
and try to ignite the grill burner again.

Refer to "Hints and Tips" chapter, Grilling.

CLOCK FUNCTIONS

MINUTE MINDER

Use it to set a countdown time for an oven function.

This function has no effect on the
operation of the appliance.

Turn the knob for the timer as far as it goes, then
turn it to necessary time period.

After the time period is completed, an acoustic
signal sounds.

USING THE ACCESSORIES

WARNING! Refer to Safety chapters.

USING THE TURNSPIT

WARNING! Be careful when you use

the turnspit. The forks and the spit are
sharp. There is a risk of injury.

WARNING! Use oven gloves when
you remove the turnspit. The turnspit
and the grill are hot. There is a risk of
burns.

A B

D

C

7

A. Turnspit frame
B. Forks
C. Spit
D. Handle

1. Put the turnspit handle into the spit.

2. Put the deep pan on the lowest shelf position.

3. Put the spit frame on the third shelf position

from the bottom.

4. Install the first fork on the spit, then put the
meat on the turnspit and install the second fork.

5. Use the screws to tighten the forks.

6. Put the tip of the spit into the turnspit hole.

7. Lay the back side of the spit on the turnspit

frame.
Refer to "Product description" chapter.

8. Remove the turnspit handle.

9. Select a function with the turnspit position. The

turnspit rotates.

10. Ignite the grill burner. Refer to the cooking
tables.

INSERTING THE ACCESSORIES

Wire shelf:
Push the shelf between the guide bars of the shelf

support and make sure that the feet point down.

Baking tray:
Push the baking tray between the guide bars of the

shelf support.

Wire shelf and baking tray together:
Push the baking tray between the guide bars of the

shelf support and the wire shelf on the guide bars
above.

Small indentation at the top increase
safety. The indentations are also anti­tip devices. The high rim around the
shelf prevents cookware from slipping
of the shelf.

8