Zanussi ZOG10311 User Manual
EN
ZOG10311XK
User Manual
Oven
EG
Contents
Safety information 2
Safety instructions 3
Product description 5
Before first use 6
Daily use 6
Clock functions
7
Using the accessories
7
Additional functions 9
Hints and tips 9
Care and cleaning 14
Troubleshooting 16
Installation 17
Technical data
21
Subject to change without notice.
Safety information
Before the installation and use of the appliance, carefully read the
supplied instructions. The manufacturer is not responsible for any
injuries or damages that are the result of incorrect installation or
usage. Always keep the instructions in a safe and accessible
location for future reference.
Children and vulnerable people safety
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards involved.
• Do not let children play with the appliance.
• Keep all packaging away from children and dispose of it
appropriately.
• Keep children and pets away from the appliance when it
operates or when it cools down. Accessible parts are hot.
• If the appliance has a child safety device, this should be
activated.
• Children shall not carry out cleaning and user maintenance of
the appliance without supervision.
• Children aged 3 years and under must be kept away from this
appliance when it is in operation at all times.
General Safety
• Only a qualified person must install this appliance and replace
the cable.
2 www.zanussi.com
• WARNING: The appliance and its accessible parts become hot
during use. Care should be taken to avoid touching heating
elements. Children less than 8 years of age shall be kept away
unless continuously supervised.
• Always use oven gloves to remove or put in accessories or
ovenware.
• Before maintenance cut the power supply.
• Ensure that the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.
• Do not use a steam cleaner to clean the appliance.
• Do not use harsh abrasive cleaners or sharp metal scrapers to
clean the glass door since they can scratch the surface, which
may result in shattering of the glass.
• If the mains power supply cable is damaged, it must be
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
• To remove the shelf supports first pull the front of the shelf
support and then the rear end away from the side walls. Install
the shelf supports in the opposite sequence.
Safety instructions
This appliance is suitable for the following
markets: EG
Installation
WARNING!
Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Follow the installation instruction supplied
with the appliance.
• Always take care when moving the appliance
as it is heavy. Always use safety gloves and
enclosed footwear.
• Do not pull the appliance by the handle.
• Keep the minimum distance from the other
appliances and units.
• Make sure that the appliance is installed
below and adjacent safe structures.
• The sides of the appliance must stay
adjacent to appliances or to units with the
same height.
• Do not operate the appliance without the
cavity bottom cover. It is a functional safety
component.
• The appliance is equipped with an electric
cooling system. It must be operated with the
electric power supply.
Electrical connection
WARNING!
Risk of fire and electrical shock.
• All electrical connections should be made by
a qualified electrician.
• The appliance must be earthed.
• Make sure that the electrical information on
the rating plate agrees with the power
supply. If not, contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable. Should
the mains cable need to be replaced, this
www.zanussi.com 3
must be carried out by our Authorised
Service Centre.
• Do not let mains cables touch or come near
the appliance door, especially when the door
is hot.
• The shock protection of live and insulated
parts must be fastened in such a way that it
cannot be removed without tools.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
• If the mains socket is loose, do not connect
the mains plug.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.
• The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.
• This appliance complies with the E.E.C.
Directives.
Gas connection
• All gas connections must be made by a
qualified person.
• Before installation, make sure that the local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.
• Make sure that there is air circulation around
the appliance.
• The information about the gas supply is on
the rating plate.
• This appliance is not connected to a device,
which evacuates the products of
combustion. Make sure to connect the
appliance according to current installation
regulations. Pay attention to requirements
regarding adequate ventilation.
Use
WARNING!
Risk of injury, burns and electrical
shock or explosion.
• This appliance is for household use only.
• Do not change the specification of this
appliance.
• Make sure that the ventilation openings are
not blocked.
• Do not let the appliance stay unattended
during operation.
• Deactivate the appliance after each use.
• Be careful when you open the appliance
door while the appliance is in operation. Hot
air can release.
• Do not operate the appliance with wet hands
or when it has contact with water.
• Do not apply pressure on the open door.
• Do not use the appliance as a work surface
or as a storage surface.
• Open the appliance door carefully. The use
of ingredients with alcohol can cause a
mixture of alcohol and air.
• Do not let sparks or open flames to come in
contact with the appliance when you open
the door.
• Do not put flammable products or items that
are wet with flammable products in, near or
on the appliance.
WARNING!
Risk of damage to the appliance.
• To prevent damage or discoloration to the
enamel:
– do not put aluminium foil directly on the
bottom of the appliance.
– do not put water directly into the hot
appliance.
– do not keep moist dishes and food in the
appliance after you finish the cooking.
– be careful when you remove or install
the accessories.
• Discoloration of the enamel has no effect on
the performance of the appliance.
• Use a deep pan for moist cakes. Fruit juices
cause stains that can be permanent.
• This appliance is for cooking purposes only.
It must not be used for other purposes, for
example room heating.
• Always cook with the oven door closed.
• If the appliance is installed behind a furniture
panel (e.g. a door) make sure the door is
never closed when the appliance is in
operation. Heat and moisture can build up
behind a closed furniture panel and cause
subsequent damage to the appliance, the
housing unit or the floor. Do not close the
furniture panel until the appliance has cooled
down completely after use.
4 www.zanussi.com
Care and cleaning
WARNING!
Risk of injury, fire, or damage to the
appliance.
• Before maintenance, deactivate the
appliance and disconnect the mains plug
from the mains socket.
• Make sure the appliance is cold. There is the
risk that the glass panels can break.
• Replace immediately the door glass panels
when they are damaged. Contact the
Authorised Service Centre.
• Be careful when you remove the door from
the appliance. The door is heavy!
• Clean regularly the appliance to prevent the
deterioration of the surface material.
• Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use any
abrasive products, abrasive cleaning pads,
solvents or metal objects.
• If you use an oven spray, obey the safety
instructions on the packaging.
• Do not clean the catalytic enamel (if
applicable) with any kind of detergent.
Internal light
• The type of light bulb or halogen lamp used
for this appliance is only for household
appliances. Do not use it for house lighting.
WARNING!
Risk of electrical shock.
• Before replacing the lamp, disconnect the
appliance from the power supply.
• Only use lamps with the same specifications.
Disposal
WARNING!
Risk of injury or suffocation.
• Contact your municipal authority for
information on how to discard the appliance
correctly.
• Disconnect the appliance from the mains
supply.
• Cut off the mains electrical cable close to
the appliance and dispose of it.
• Flat the external gas pipes.
Service
• To repair the appliance contact an
Authorised Service Centre.
• Use original spare parts only.
Product description
General overview
1
52 3 4
1
11
5
4
3
2
1
6
7
8
10
9
1
Control panel
2
Knob for the oven functions
3
Knob for the Minute Minder
4
Knob for the gas control
5
Power indicator
6
Air vents for the cooling fan
7
Heating element
8
Lamp
9
Turnspit hole
10
Oven cavity bottom plate
11
Shelf positions
Accessories
• Wire shelf
For cookware, cake tins, roasts.
• Baking tray
For cakes and biscuits.
www.zanussi.com 5
• Aluminium baking tray
For cakes and biscuits.
• Turnspit
For roasting larger joints of meat and poultry.
Before first use
WARNING!
Refer to Safety chapters.
Oven cavity bottom plate
When you buy the appliance, at first the oven
cavity bottom plate is positioned on the
accessories. Before you use the appliance for
the first time, place the bottom plate on the
burner area, as shown in the "Product
description" chapter.
Initial Cleaning
Remove all accessories and removable shelf
supports from the appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance and the accessories before
first use.
Put the accessories and the removable shelf
supports back to their initial position.
Preheating
Preheat the empty appliance before first use.
1. Set the maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function .
4. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
Let the oven cool down. Dampen a soft cloth
with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.
Daily use
WARNING!
Refer to Safety chapters.
Oven functions
Oven function Application
Off position The appliance is off.
Light To activate the lamp without a cooking function.
Turnspit To roast larger pieces of meat on the spit rod.
Power indicator
The power indicator comes on when you turn
the knob for the oven functions.
6 www.zanussi.com
Knob for the gas control
Symbol Function
Heat only from the bottom of the oven. Range of temperature adjustment (150 °C 250 °C).
Heats from the top.
Ignition of oven gas burner
Oven safety device:
The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.
1. Press the knob for the gas control and turn
it to .
2. Keep the knob for the gas control pushed
for 15 seconds or less to let the
thermocouple warm up. If not, the gas flow
is interrupted.
Do not release the knob until the flame
comes on.
Do not keep the knob for the oven
functions pushed for more than 15
seconds. If the oven burner does not
light after 15 seconds, release the
knob for the oven functions, turn it
into off position, open the oven door
and try to light the oven burner again
after minimum 1 minute.
After igniting the oven gas burner
1. Release the knob for the gas control.
2. Turn the knob for the gas control to set the
necessary heat setting.
Control the flame trough the holes in the bottom
of the oven.
Using the grill
Oven safety device:
The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.
1. Open the oven door.
2. Press the knob for the gas control and turn
it to . Keep the knob for the gas control
pushed for 15 seconds or less.
Do not release the knob until the flame
comes on.
If the grill burner does not come
on or if it accidentally goes out,
release the knob for the gas
control and turn it to the Off
position. Leave the oven door
open. After one minute, try to
light the grill again.
3. Release the knob for the gas control.
4. Close the oven door.
Clock functions
Minute Minder
Use it to set a countdown time for an oven
function.
This function has no effect on the
operation of the appliance.
Turn the knob for the timer as far as it goes,
then turn it to necessary time period.
After the time period is completed, an acoustic
signal sounds.
Using the accessories
WARNING!
Refer to Safety chapters.
www.zanussi.com 7
Using the turnspit
WARNING!
Be careful when you use the
turnspit. The forks and the spit are
sharp. There is a risk of injury.
WARNING!
Use oven gloves when you remove
the turnspit. The turnspit and the grill
are hot. There is a risk of burns.
A B
C
D
A. Turnspit frame
B. Forks
C. Spit
D. Handle
1. Put the turnspit handle into the spit.
2. Put the deep pan on the lowest shelf
position.
3. Put the spit frame on the third shelf position
from the bottom.
4. Install the first fork on the spit, then put the
meat on the turnspit and install the second
fork.
5.
Use the screws to tighten the forks.
6. Put the tip of the spit into the turnspit hole.
7. Lay the back side of the spit on the turnspit
frame.
Refer to "Product description" chapter.
8. Remove the turnspit handle.
9. Select a function with the turnspit position.
The turnspit rotates.
10. Ignite the grill burner. Refer to the cooking
tables.
Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of the
shelf support and make sure that the feet point
down.
Baking tray:
Push the baking tray between the guide bars of
the shelf support.
8 www.zanussi.com
Loading...