Zanussi ZOB30601WU, ZOB30601XU User Manual

GETTING STARTED?
EASY.
User Manual
ZOB30601WU ZOB30601XU
EN User Manual

SAFETY INFORMATION

Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.

CHILDREN AND VULNERABLE PEOPLE SAFETY

This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children between 3 and 8 years of age and persons with very
extensive and complex disabilities shall be kept away from the appliance unless continuously supervised.
Children of less than 3 years of age should be kept away from
the appliance unless continuously supervised.
Do not let children play with the appliance.
Keep all packaging away from children and dispose of it
appropriately.
Keep children and pets away from the appliance when it
operates or when it cools down. Accessible parts may become hot during use.
If the appliance has a child safety device, it should be activated.
Children shall not carry out cleaning and user maintenance of
the appliance without supervision.

GENERAL SAFETY

Only a qualified person must install this appliance and replace
the cable.
WARNING: The appliance and its accessible parts become hot
during use. Care should be taken to avoid touching heating elements.
Always use oven gloves to remove or put in accessories or
ovenware.
2
Before carrying out any maintenance, disconnect the appliance
from the power supply.
WARNING: Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric shock.
Do not use the appliance before installing it in the built-in
structure.
Do not use a steam cleaner to clean the appliance.
Do not use harsh abrasive cleaners or sharp metal scrapers to
clean the glass door since they can scratch the surface, which may result in shattering of the glass.
If the mains power supply cable is damaged, it must be
replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
To remove the shelf supports first pull the front of the shelf
support and then the rear end away from the side walls. Install the shelf supports in the opposite sequence.

SAFETY INSTRUCTIONS

INSTALLATION

WARNING! Only a qualified person
must install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied with the appliance.
• Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear.
• Do not pull the appliance by the handle.
• Keep the minimum distance from other appliances and units.
• Install the appliance in a safe and suitable place that meets installation requirements.
• The appliance is equipped with an electric cooling system. It must be operated with the electric power supply.
Cabinet minimum height (Cabinet under the worktop minimum height)
Cabinet width 560 mm Cabinet depth 550 (550) mm
590 (600) mm
Height of the front of the appliance
Height of the back of the appliance
Width of the front of the appliance
Width of the back of the appliance
Depth of the appliance 569 mm Built in depth of the
appliance Depth with open door 1022 mm Ventilation opening
minimum size. Opening placed on the bottom rear side
Mains supply cable length. Cable is placed in the right corner of the back side
Mounting screws 4x25 mm
594 mm
576 mm
595 mm
559 mm
548 mm
560x20 mm
1500 mm
3

ELECTRICAL CONNECTION

WARNING! Risk of fire and electric
shock.
Total power (W)
Section of the cable
(mm²)
• All electrical connections should be made by a qualified electrician.
• The appliance must be earthed.
• Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the mains plug and to the mains cable. Should the mains cable need to be replaced, this must be carried out by our Authorised Service Centre.
• Do not let mains cables touch or come near the appliance door or the niche below the appliance, especially when it operates or the door is hot.
• The shock protection of live and insulated parts must be fastened in such a way that it cannot be removed without tools.
• Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation.
• If the mains socket is loose, do not connect the mains plug.
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
• Use only correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors.
• The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm.
• This appliance is supplied with a main plug and a main cable.
Cable types applicable for installation or re-
placement for Europe:
H07 RN-F, H05 RN-F, H05 RRF, H05 VV-F, H05 V2V2-F (T90), H05 BB-F
For the section of the cable refer to the total power on the rating plate. You can also refer to the table:
maximum 1380 3 x 0.75 maximum 2300 3 x 1 maximum 3680 3 x 1.5
The earth cord (green / yellow cable) must be 2 cm longer than phase and neutral cables (blue and brown cables).
USE
WARNING! Risk of injury, burns and
electric shock or explosion.
• This appliance is for household use only.
• Do not change the specification of this appliance.
• Make sure that the ventilation openings are not blocked.
• Do not let the appliance stay unattended during operation.
• Deactivate the appliance after each use.
• Be careful when you open the appliance door while the appliance is in operation. Hot air can release.
• Do not operate the appliance with wet hands or when it has contact with water.
• Do not apply pressure on the open door.
• Do not use the appliance as a work surface or as a storage surface.
• Open the appliance door carefully. The use of ingredients with alcohol can cause a mixture of alcohol and air.
• Do not let sparks or open flames to come in contact with the appliance when you open the door.
• Do not put flammable products or items that are wet with flammable products in, near or on the appliance.
WARNING! Risk of damage to the appliance.
• To prevent damage or discoloration to the enamel:
– do not put ovenware or other objects in the
appliance directly on the bottom.
– do not put aluminium foil directly on the
bottom of cavity of the appliance.
– do not put water directly into the hot
appliance.
4
– do not keep moist dishes and food in the
appliance after you finish the cooking.
– be careful when you remove or install the
accessories.
• Discoloration of the enamel or stainless steel has no effect on the performance of the appliance.
• Use a deep pan for moist cakes. Fruit juices cause stains that can be permanent.
• This appliance is for cooking purposes only. It must not be used for other purposes, for example room heating.
• Always cook with the oven door closed.
• If the appliance is installed behind a furniture panel (e.g. a door) make sure the door is never closed when the appliance is in operation. Heat and moisture can build up behind a closed furniture panel and cause subsequent damage to the appliance, the housing unit or the floor. Do not close the furniture panel until the appliance has cooled down completely after use.

CARE AND CLEANING

WARNING! Risk of injury, fire, or
damage to the appliance.
• Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket.
• Make sure the appliance is cold. There is the risk that the glass panels can break.
• Replace immediately the door glass panels when they are damaged. Contact the Authorised Service Centre.
• Clean regularly the appliance to prevent the deterioration of the surface material.
• Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use any abrasive products, abrasive cleaning pads, solvents or metal objects.
• If you use an oven spray, follow the safety instruction on it's packaging.
• Do not clean the catalytic enamel (if applicable) with any kind of detergent.

INTERNAL LIGHTING

WARNING! Risk of electric shock.
• The type of light bulb or halogen lamp used for this appliance is for household appliances only. Do not use it for house lighting.
• Before replacing the lamp, disconnect the appliance from the power supply.
• Only use lamps with the same specifications.

SERVICE

• To repair the appliance contact the Authorised Service Centre.
• Use original spare parts only.

DISPOSAL

WARNING! Risk of injury or
suffocation.
• Disconnect the appliance from the mains supply.
• Cut off the mains electrical cable close to the appliance and dispose of it.
• Remove the door catch to prevent children or pets from becoming trapped in the appliance.

INSTALLATION

WARNING! Refer to Safety chapters.
5

BUILDING IN

18
594
589
114
21548
595
+-1
min. 550
20
600
min. 560
3
5
60
20
80
520
60
198
523
min. 550
20
595
+-1
18
590
min. 560
594
589
114
21548
3
5
70
60
520
60
20
198
523

SECURING THE OVEN TO THE CABINET ELECTRICAL INSTALLATION

The manufacturer is not responsible if you do not follow the safety
This appliance is supplied with a main plug and a main cable.

CABLE

Cable types applicable for installation or replacement:
H07 RN-F, H05 RN-F, H05 RRF, H05 VV-F, H05
6
V2V2-F (T90), H05 BB-F For the section of the cable refer to the total power
on the rating plate. You can also refer to the table:
precautions from the Safety chapters.
Total power (W)
21 43
6
5
7
8
9
5 4
3 2
1
10
maximum 1380 3 x 0.75 maximum 2300 3 x 1 maximum 3680 3 x 1.5
Section of the cable

PRODUCT DESCRIPTION

GENERAL OVERVIEW

(mm²)
The earth cord (green / yellow cable) must be 2 cm longer than phase and neutral cables (blue and brown cables).
Control panel
1
Knob for the heating functions
2
Control knob (for the temperature)
3
Temperature indicator / symbol
4
Heating element
5
Lamp
6
Fan
7
Aqua cleaning container
8
Shelf support, removable
9
Shelf positions
10

ACCESSORIES

Wire shelf For cookware, cake tins, roasts.
Baking tray

BEFORE FIRST USE

WARNING! Refer to Safety chapters.

INITIAL CLEANING

Remove all accessories and removable shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories before first use.
For cakes and biscuits.
Grill- / Roasting pan To bake and roast or as pan to collect fat.
Put the accessories and the removable shelf supports back to their initial position.

PREHEATING

Preheat the empty oven before first use.
1. Set the function .Set the maximum
temperature.
2. Let the oven operate for 1 hour.
3. Set the function . Set the maximum
temperature.
4. Let the oven operate for 15 minutes.
5. Set the function . Set the maximum
temperature.
7
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool down.

DAILY USE

Accessories can become hotter than usual. The oven can emit an odour and smoke. Make sure that the airflow in the room is sufficient.
WARNING! Refer to Safety chapters.

SETTING A HEATING FUNCTION

1. Turn the knob for the heating functions to
select a heating function.
2. Turn the control knob to select the temperature.
The lamp turns on when the oven operates.
3. To turn off the oven, turn the knob for the heating functions to the off position.

HEATING FUNCTIONS

Oven function Application
The oven is off.
Off position
To bake on up to three shelf positions at the same
True Fan Cooking
time and to dry food. Set the temperature 20 ­40 °C lower than for Con­ventional Cooking.
Oven function Application
This function is designed to save energy during cook-
Moist Fan Bak-
ing
Defrost
Grilling
Fast Grilling
Pizza Setting
ing. For the cooking in­structions refer to "Hints and tips" chapter, Moist Fan Baking. The oven door should be closed during cooking so that the function is not interrupted and to en­sure that the oven operates with the highest energy effi­ciency possible. When you use this function, the tem­perature in the cavity may differ from the set tempera­ture. The heating power may be reduced. For gener­al energy saving recom­mendations refer to "Energy Efficiency" chapter, Energy Saving.This function was used to comply with the en­ergy efficiency class ac­cording to EN 60350-1.
To defrost food (vegetables and fruit). The defrosting time depends on the amount and size of the fro­zen food.
To grill flat food and to toast bread.
To grill flat food in large quantities and to toast bread.
To bake pizza. To make in­tensive browning and a crispy bottom. Set the tem­perature 230°C.
8
Loading...
+ 16 hidden pages