Zanussi ZK26/11AT, ZK23/11AT User Manual

Warnings for your safety. Carefully read these instructions before installing and using the machine.

m This freezer is designed to be operated by adults

only. Children should not be allowed to tamper with the controls or play with the product.

m Any electrical work required to install the applian-

ce should be carried out by a qualified electrician or competent person.

m This appliance is heavy. Care should be taken

when moving it.

m Make sure that the cable is not trapped underne-

ath the appliance, nor touches the motor.

m Repairs carried out by inexperienced persons

may cause injuries or serious malfunctioning. Refer to the nearest Authorized Dealer.

m Make sure the rear part of the appliance stands

against a wall as there are working parts which heat up and should not be of easy access.

m Make sure that there is a continous and adequate

ventilation as a failure to do so may result in damage to the appliance or deterioration of the food.

m The appliance should be left for at least 4 hours

after installation before it is turned on ill order to allow the refrigerant to settle.

m This product must be serviced only by an AUT-

HORIZED DEALER, and only GENUINE SPARE PARTS must be employed.

m Before cleaning or reparing the appliance, make

sure it is unplugged.

m It is dangerous to alter the specifications or modify

this product in any way.

m These domestic refrigerators are designed to be

used specifically for the storage and conservation of food.

m DO NOT USE SHARP INSTRUMENTS to scrap

off frost or ice. Frost may be removed by using a plastic scraper. (See defrosting instructions).

m Frozen food must not be re-frozen once it has

been thawed out. Manufacturer’s storage recommendations should be strictly complied with.

m Lollies can cause frost burns if consumed right

away from the freezer.

m Do not place carbonate or fizzy drinks in the free-

zer as these may explode.

m When an old freezer is to be discarded make sure

to:

m Dismount the doors in order to prevent children

from getting trapped inside.

Have the gas from the cooling system with-

drawn before making it to scrap iron.

m Warnings for your Safety

Index

Warnings for your safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Installation Positioning/Cleaning the interior/Electrical connection/Starting up. . . . . . . . . . . . . . . . . . . . . . 12

Changing the opening directions of the doors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

Control and Use Control panel/Interior Light/Dinamic Refrigeration. . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Control and Use Inner Door Compartments Position/Shelves Position/Freezer Compartment. . . . . . . . . 15

Control and Use Refrigerator Compartment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Maintenance Defrosting of the freezer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Maintenance Defrosting of the fridge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Something not working . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17-18

Normal noises when functioning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Guarantee, Service and Spare Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Tecnical Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20

Installation

Positioning

• Place the refrigerator away from direct sunlight and heat sources.

• Maintain recommended ventilation - see Fig. 1.

• Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises, Fig. 2.

• This is a built in design to be aligned with other furniture

• The appliance must be located in places of maximum temperature as follows:

If the temperature are higher than these both above mentioned, the functions of appliance coudl result reduced.

• With the freezer door wide-open, assemble the socle provided inside the appliance, following the instructions stuck on it.

Cleaning the interior

• Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet.

• Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brand-new product arid then dry thoroughly.

• Do not use detergents or abrasive powders as these will damage the finish.

• Remove security used for transportation.

Electrical connection

mBefore plugging the appliance make sure that the

voltage and frequency shown on the «Technical Features» correspond to your home supply. It is essential that the appliance be efficiently earthed.

mFor this purpose the supply cable plug incorpora-

tes a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED».

Starting – up

• Plug the appliance into the mains.

• Make sure the inner light turns on when opening the door.

• Turn to intermediate position the knobs of the «temperature regulators»: «A» for refrigerating compartment and «C» for freezing compartment (See knobs in the Control and Use paragraph).

Fig. 1

Fig. 2

SN +10 to +32ºC N +16 to +32ºC ST +18 to +38ºC T +18 to +43ºC

Changing the opening direction of doors

If you wish to change the opening side of the doors proceed as follows:

1... Take off the plinth (A) pressed onto cabinet. Take out the lid (B) and put it into the opposite hole.

2... Remove the lower hinge (C) taking care for the lower door not to fall off.

3... Lift the lower door off the central hinge (D).

4... Remove the central hinge (D) taking care for the upper door not to fall off and not to lose the plastic washer.

5... Take the upper door off the upper hinge (E). Be carefull not to lose the plastic washer.

6... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge.

7… Unscrew the axle of the upper hing and screw it

into the hinge on the opposite side. Make sure to fit in the metal washer for blocking.

8… Place upper door.

9... Put the central hinge (D) in the opposite side from original position. Leave the hinge loose.

10...Place the lower door next to the lower hinge (C) in the opposite side from original and fix all the hinges. Before it, using a 10mm spanner, unscrew the hinge pin and reassemble it on the opposite side.

11...Dismantle the vertical handles and assemble them in the opposite side. Cover the holes with the plastic lids that were situated where the handles are presently.

12...Replace the plinth (A) well fixed.

Once finished make sure that all joints close

perfectly well all around the door and chek that the internal light turns of when the fridge door closes.

PR1

PR220

+ 7 hidden pages