Zanussi ZK22/11EL3 USER MANUAL
31
scrap off frost or ice. Frost may be removed
by using a plastic scraper. (See defrosting
instructions).
m Frozen food must not be re-frozen once it
has been thawed out.
m Manufacturer’s storage recommendations
should be strictly complied with.
m Lollies can cause frost burns if consumed
right away from the freezer.
m Do not place carbonate or fizzy drinks in the
freezer as these may explode.
m When an old freezer is to be discarded
make sure to:
m Dismount the doors in order to prevent
children from getting trapped inside.
Have the gas from the cooling system
withdrawn before making it to scrap iron.
m
Warnings for your safety
Warnings for your safety. Carefully read these instructions before installing and using the machine.
m This freezer is designed to be operated by
adults only. Children should not be allowed to
tamper with the controls or play with the product.
m Any electrical work required to install the
appliance should be carried out by a qualified
electrician or competent person.
m This appliance is heavy. Care should be taken
when moving it.
m Make sure that the cable is not trapped under-
neath the appliance, nor touches the motor.
m Repairs carried out by inexperienced persons
may cause injuries or serious malfunctioning.
Refer to the nearest Authorized Dealer.
m Make sure the rear part of the appliance stands
against a wall as there are working parts which
heat up and should not be of easy access.
m Make sure that there is a continous and ade-
quate ventilation as a failure to do so may
result in damage to the appliance or deterioration of the food.
m The appliance should be left for at least 4 hours
after installation before it is turned on ill order
to allow the refrigerant to settle.
m This product must be serviced only by an AUT-
HORIZED DEALER, and only GENUINE
SPARE PARTS must be employed.
m Before cleaning or reparing the appliance,
make sure it is unplugged.
m It is dangerous to alter the specifications or
modify this product in any way.
m These domestic refrigerators are designed to
be used specifically for the storage and conservation of food.
m DO NOT USE SHARP INSTRUMENTS to
32
Índex
Warnings for your safety pag. 29
Installation pag. 31
Changing the opening directions
of the doors and Panelling pag. 32
Regulation and Control pag. 33
How to use your
Refrigerator-Freezer pag. 34
Maintenance of your
Refrigerator-Freezer pag. 36
Something not working pag. 38
Normal noises when
functioning pag. 40
Guarantee, Service
and Spare Parts pag. 41
Tecnical Features pag. 42
33
Installation
PPoossiittiioonniinngg
• Place the refrigerator away from direct sunlight and
heat sources.
• Maintain recommended ventilation - see Fig. 1.
• Make sure the refrigerator is accurately levelled turning
the adjustable feet in order to avoid vibrations and noises.
• This is a built in design to be aligned with other furniture
CClleeaanniinngg tthhee iinntteerriioorr
• Do not use alcohol or any cleanig product containing
alcohol because it can damage the cabinet.
• Before using the appliance for the first time wash the
interior whith luke warm water and some neutral soap
so as to remove the typical smell of a brand-new product arid then dry thoroughly.
• Do not use detergents or abrasive powders as these
will damage the finish.
• Remove security used for transportation.
EElleeccttrriiccaall ccoonnnneeccttiioonn
mBefore plugging the appliance make sure that the vol-
tage and frequency shown on the «Technical
Features» correspond to your home supply.
mIt is essential that the appliance be efficiently eart-
hed.
For this purpose the supply cable plug incorporates a
special earth contact. If the sockets of your domestic
wiring system are not grounded, have the appliance
connected to a separate ground wire in accordance
with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
SSttaarrttiinngg –– uupp
• Plug the appliance into the mains.
• Make sure the inner light «H» turns on when
opening the door.
• Press the power switch «a» on the panel to turn on the
power.
• If the temperature is too high in the cabinet, the temperature alarm sounds. Turn off the alarm by pressing
the alarm shut-off button «h». The light can be switched until the appliance obtains an appropiate temperature.
Fig. 2
Fig. 1
34
Changing the opening direction
of doors
If you wish to change the opening side of the doors
proceed as follows:
1... Dismantle the vertical handles (in some models)
and assemble them in the opposite side. Cover the
holes with the plastic lids that were situated where
the handles are presently.
2... Remove the lower hinge taking care for the lower
door not to fall off. Using a 10mm spanner, unscrew
the hinge pin and reassemble it on the opposite
side.
3... Lift the lower door off the central hinge.
4... Remove the central hinge taking care for the upper
door not to fall off and not to lose the plastic washer.
5... Take the upper door off the upper hinge. Be care-
full not to lose the plastic washer.
6... Unscrew the plastic plugs located on the opposite
side of the central hinge and introduce them in the
holes occupied before by the hinge.
7…Unscrew the axle of the upper hing and screw it
into the hinge on the opposite side. Make sure to fit
in the metal washer for blocking.
8…Place upper door.
For the remaining parts proceed the other way
round.
Once finished make sure that all joints close
perfectly well all around the door and chek that the
internal light turns of when the fridge door closes.
35
PPoowweerr sswwiittcchh ((aa))
Switches the appliance on and off.
To switch off, keep the button pressed for about 1
second.
FFrriiddggee::
Fig.5
TTeemmppeerraattuurree aaddjjuussttmmeenntt
bbuuttttoonnss//tthheemmoossttaatt ((bb))
Setting range: +2°C to + 8°C.
Press: the top button «+» to set a higher tempe-
rature or disconnect the fridge part. (in the
display you can see OF)
the lower button «-» to set a lower tempe-
rature.
Keep pressing until the desired temperature flashes in the temperature display. The display will
then stop flashing.
TTeemmppeerraattuurraa ddiissppllaayy ((cc))
Shows temperatures between 0°C and +9°C. When it is
warmer than + 9°C, «OF» is displayed.
The temperatura display starts flashing when the refrigerator temperature is set.
The temperature varies in different parts of the cabinet.
The temperature display shows the average temperature inside the cabinet.
If the temperature is measured using a standard, single
thermometer, this should be put in a glass of water centrally placed inside the cabinet. This will reflect the temperature inside the food produts. Do not place the thermometer hanging or lying directly on the shelf.
SSHHOOPPPPIINNGG ((dd))
Use Shopping to refrigerate a large quantity of products.
When Shopping is switched on, the temperature is auto-
matically set to + 2°C.
«A» is then displayed in the temperature display and
the yellow indicator lamp lights. After about 6 hours,
Action Cool is switched off and the temperature gradually returns to the previously set temperature. It is
possible to switch off Action Cool manually by pressing the Action Cool button once more.
DDoooorr ooppeenn aallaarrmm ((hh))
If the door remains open for more than 5 minutes, the red warning lamp starts flashing and
an audible alarm sounds.
To switch off the alarm:
Press the «alarm shut-off button». The red
warning lamp goes out when the door is closed.
IInnssiiddee LLiigghhtt::
(H) Fig. 4
This comes on when you open the refrigerator
door and goes off when you close it.
If you need get the bulb (see «IF SOMETHING
FAILS TO OPERATE») remove the protective
cover X, pulling its clip horizontally.
Fig. 4
Regulation and Control
Fig. 5
a
b bc d e
f
fg h
Loading...