Zanussi ZK22/11DL3, ZK22/11R3 User Manual

m DO NOT USE SHARP INSTRUMENTS to

scrap off frost or ice. Frost may be removed by using a plastic scraper. (See defrosting instructions).

m Frozen food must not be re-frozen once it

has been thawed out.

m Manufacturer’s storage recommendations

should be strictly complied with.

m Lollies can cause frost burns if consumed

right away from the freezer.

m Do not place carbonate or fizzy drinks in the

freezer as these may explode.

m When an old freezer is to be discarded

make sure to:

m Dismount the doors in order to prevent

children from getting trapped inside. Have the gas from the cooling system

withdrawn before making it to scrap iron.

Warnings for your safety

Warnings for your safety. Carefully read these instructions before installing and using the machine.

m This freezer is designed to be operated by

adults only. Children should not be allowed to tamper with the controls or play with the product.

m Any electrical work required to install the

appliance should be carried out by a qualified electrician or competent person.

m This appliance is heavy. Care should be taken

when moving it.

m Make sure that the cable is not trapped under-

neath the appliance, nor touches the motor.

m Repairs carried out by inexperienced persons

may cause injuries or serious malfunctioning. Refer to the nearest Authorized Dealer.

m Make sure the rear part of the appliance stands

against a wall as there are working parts which heat up and should not be of easy access.

m Make sure that there is a continous and ade-

quate ventilation as a failure to do so may result in damage to the appliance or deterioration of the food.

m The appliance should be left for at least 4 hours

after installation before it is turned on ill order to allow the refrigerant to settle.

m This product must be serviced only by an AUT-

HORIZED DEALER, and only GENUINE SPARE PARTS must be employed.

m Before cleaning or reparing the appliance,

make sure it is unplugged.

m It is dangerous to alter the specifications or

modify this product in any way.

m These domestic refrigerators are designed to

be used specifically for the storage and conservation of food.

Índex

Warnings for your safety pag. 15

Installation pag. 17

Changing the opening directions of the doors and Panelling pag. 18

Regulation and Control pag. 19

How to use your Refrigerator-Freezer pag. 20 - 21

Maintenance of your Refrigerator-Freezer pag. 22 - 23

Something not working pag. 24 - 25

Normal noises when functioning pag. 26

Guarantee, Service and Spare Parts pag. 27

Tecnical Features pag. 28

Installation

PPoossiittiioonniinngg

• Place the refrigerator away from direct sunlight and heat sources.

• Maintain recommended ventilation - see Fig. 1.

• Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises, Fig. 2.

• This is a built in design to be aligned with other furniture

CClleeaanniinngg tthhee iinntteerriioorr

• Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet.

• Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brand-new product arid then dry thoroughly.

• Do not use detergents or abrasive powders as these will damage the finish.

• Remove security used for transportation.

EElleeccttrriiccaall ccoonnnneeccttiioonn

m Before plugging the appliance make sure that the

voltage and frequency shown on the «Technical

Features» correspond to your home supply. It is essential that the appliance be efficiently earthed.

m For this purpose the supply cable plug incorpora-

tes a special earth contact. If the sockets of your

domestic wiring system are not grounded, have

the appliance connected to a separate ground

wire in accordance with existing safety regula-

tions. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED».

SSttaarrttiinngg –– uupp

• Plug the appliance into the mains.

• Make sure the inner light turns on when opening the door.

• Turn to intermediate position the knobs of the «temperature regulators»: «A» for refrigerating compartment and «C» for freezing compartment.

Fig. 2

Fig. 1

Changing the opening direction of doors and Panelling

If you wish to change the opening side of the doors proceed as follows:

1... Dismantle the vertical handles (in some models) and assemble them in the opposite side. Cover

the holes with the plastic lids that were situated where the handles are presently.

2... Remove the lower hinge taking care for the lower

door not to fall off.

3... Lift the lower door off the central hinge.

4... Remove the central hinge taking care for the

upper door not to fall off and not to lose the plastic washer.

5... Take the upper door off the upper hinge. Be

carefull not to lose the plastic washer.

6... Unscrew the plastic plugs located on the opposi-

te side of the central hinge and introduce them in the holes occupied before by the hinge.

7…Unscrew the axle of the upper hing and screw it

into the hinge on the opposite side. Make sure to fit in the metal washer for blocking.

8…Place upper door.

For the remaining parts proceed the other way round.

Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.

Regulation and Control

TTeemmppeerraattuurree RReegguullaattoorr ffoorr RReeffrriiggee--rraattoorr::

«A» Allows to adjust the temperature inside the refrige-

rator according to use and external conditions.

• Pos. l = Minimum cold.

• Pos. l = Maximum cold.

• Pos. m = Motor disconnected.

TTeemmppeerraattuurree RReegguullaattoorr ffoorr FFrreeeezzeerr::

«C»

Allows to adjust the temperature inside the freezer according to use and external conditions.

• Pos. l = Minimum cold.

• Pos. l = Maximum cold.

• Pos. m = Motor disconnected.

GGrreeeenn lliigghhtt::

«D» (some models only).

Indicates connection to mains when lighted.

OOrraannggee lliigghhtt::

«F» (some models only).

Indicates that the freezer is on freezing mode (S).

RReedd lliigghhtt::

«G» (some models only). Whent lighted indicates abnormal temperature conditions in the freezer, but for the exceptions appearing of Pag «Freezing of Food» and Page «Something not working».

IInntteerriioorr lliigghhtt::

Comes on when opening the door of the refrigerating compartment. When changing the light bulb, first remove the protective cover «X» (see point A-3 «IF SOMETHING DOES NOT WORK»).

SSuuppeerr sswwiittcchh::

«E»

Allows you to choose the freezing type you want in the freezer compartiment. To keep the equipment in good working

order, please consult the «Freezing of food» paragraph.

GGrreeeenn ppiilloott::

«B» (some models only). It is on when the fridge compartiment engines is working.

DDiinnaammiicc RReeffrriiggeerraattiioonn::

(some models only)

The Dynamic Refrigeration System give, in the fridge compartment, extra efficiency showed in:

• Quicker refrigeration.

• More homogeneous temperature. DAC (Dynamic Air Cooling system) has been mainly designed for hot weather (ambient temperature above 25°), and also when the refrigerator is plenty of food. To start working, push the switch. When DAC is switched on, the cold production es higher, thus you should turn the temperature regulator to an adequate position to avoid excesive cold.

ABCDEFG

+ 9 hidden pages