Zanussi ZCR 135R User Manual

REFRIGERATOR

ZCR135R

INSTRUCTION BOOKLET

8181454- -03/7

Important Safety Instructions

These warnings are provided in the interest s of your safety. Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance. If you are insure about any of the meanings or warnings contact the Customer Care Department.

Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody

else.

Prior to Installation

· Check the appliance for transport damage. Under

no circumstances should a damaged appliance be installed. In the event of damage please contact

your retailer.

Installation

· This appliance is heavy. C are should be taken

when moving it.

· It is dangerous to alter the specifications or

attempt to modify this product in any way.

· Ensure that the appliance does not stand on the

electrical supply cable. If the supply cable is damaged, it must be replaced by a cable

avaliable from your local Service Force Centre.

· Any electrical work required to install this

appliance should be carried out by a qualified electrician or competent person.

· Parts which heat up should not be exposed.

Whenever possible, the back of the appliance should be close to a wall, but leaving the required distance for ventilation, as stated in the installation instructions. The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigernat to settle.

Child Safety

· Do not allow children to tamper with the controls

or play with the product.

· There is a risk of suffocation! Keep packaging

material away from children.

During Use

· This appliance is designed for domestic use only,

specifically for the storage of edible foodstuffs only. It is not intended for commercial or industrial use.

· Containers with flammable gases or liquids can

leak at low temperatures. Do not store any

containers with flammable materials, such as spray cans, fire extinguisher refill cartridges etc. in the refrigerator or freezer.

Maintenance and Cleaning

· Before cleaning, always switch off the apppliance

and disconnect from the electrical supply

· When unplugging always pull the plug from the

mains socket, do not pull on the cable

Servicing

· This product should be serviced by an

authorised engineer and only genuine spare parts should be used.

· Under no circumstances should you attempt to

repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre.

At the end of the Appliance Life

· When disposing of your appliance use an

authorised disposal site.

· Remove the plug and ensure that any locks or

catches are removed, to prevent young children being trapped inside.

· Do not let sharp objects come into contact with

the refrigerating system on the back of and inside the cabinet. If the refrigerating system is punctured, the cabinet will be damaged and foodstuff inside may spoil. If the refrigerant circuit should become damaged: avoid open flames and sources of ignition thoroughly ventillate the room in which the appliance is situated The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibillity, which is nevertheless flammable.

Zanussi 818 14 54-03/7

Contents

Instructions for the user

Important Safety Instructions 2.......

Contents 3..........................

Description of the Appliance 4........

Control Panel 4..............................

Use 4...............................

To start the fridge and thermostat control 5........

Measuring the temperature 6...................

Switching off 6..............................

Cabinet interior 6............................

External Cleaning 8..........................

Defrosting the fridge 8........................

To Change the Light Bulb 8....................

When the appliance i s not in use 8...............

Something Not Working 8............

ServiceandSpareParts 9............

Customer Care Department 11.........

Guarantee Conditions 12..............

Standard Guarantee Conditions 12................

Instructions for the installer

Hints and Tips 7.....................

Normal Operating Sounds 7....................

Food Storage 7..............................

Energy Saving Advice 7.......................

Maintenance and Cleaning 7..........

Removing the ventilation grille 7................

Internal Cleaning 7...........................

Technical specification 13.............

Installation 13........................

Unpacking 13................................

Removing the transport supports 13..............

Installing the cabinet 14........................

Electrical connection 14........................

Door Reversal 15.............................

Guide to use the instruction book

The following Symbols will be found in the text to guide you through the instructions

Safety instructions

1, 2, 3 ...

Step by step instructions for an operation

Hints and tips

Zanussi 818 14 54-03/7

Description of the

ppliance GB

Control Panel

Model ZCR135R

1. Wire shelf

2. Bottle shelf

3. Vegetable drawer

4. Egg tray

5. Dairy compartment + butter box

6. Ventilation grille

7. Door shelf

A. Green indicator light

Lights when the fridge is operating.

Use

Operation

This a mestic use only, specifically for the sto

liance isdesignedfo

age of edible foodstuffs.

B. Thermostat control

Usetoswitchonandsetthedesiredtemperaturein the fridge.

This appliance is designed to operate in ambient temperatures (surronding air temperature) between 10_C and 32_C. If these temperatures are exceeded i.e., colder or warmer, the appliance will not operate correctly.

Zanussi 818 14 54-03/7

Before use

·Check that the drain hose at the rear of the cabinet

discharges into the drip tray.

·Remove all securing tapes.

·Wash the inside of the appliance with lukewarm

water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly.

Do not use detergents, abrasive powders,

highly perfumed cleaning products, wax, polishes or products containing alcohol.

·Before inserting the power plug into the outlet and

switching on the cabinet for the first time, leave it standing upright for about 30 minutes, or for 2 hours if it was transported horizontally. Otherwise the compressor may sustain damage. This time will allow the oil sufficient time to return to the compressor.

To start the fridge and thermostat control

Turn the thermostat control to the desired position. 1 : The lowest position of the thermostat control results in the highest temperature inside the cabinet. 6 : The highest position of the thermostat control results in the lowest temperature inside the cabinet. 0 : Off. Allow the cabinet to run for a period of 24 hours whenever the temperature setting is changed. This will allow the temperature to stabilise inside the cabinet.

A suitable temperature inside the fridge is approx. 5°C. If the thermostat control is set too cold, food with a high water content may start to freeze if it has been placed in the coldest places in the fridge. The picture shows the coldest and warmest places inside the fridge. (+ warm, - cold) Meat, fish and milk should be put in the coldest part of the cabinet. The temperature will be affected by:

· How often the door is opened

· How much food is stored

· Position of the appliance (See chapter

Installation)

Zanussi 818 14 54-03/7

Measuring the temperature

If the temperature is measured using a standard, single thermometer, this should be put in a glass of water centrally placed inside the cabinet. This will reflect the temperature inside the food products. Do not place the thermometer hanging or lying directly on the shelf.

· Distribute foodstuffs to allow cold air to

circulate freel y between the products.

· Do not place food products directly against the

cooling plate on the rear wall since t hey may freeze in this case.

· Also never put warm products into the cabinet.

Wait until they have cooled down.

· Cover all foods properly to avoid odours and

flavours from tainting other food.

Switching off

Set the thermostat control to the "0" position. Unplug the power supply plug from the wall socket or, alternatively, remove the fuse.

Cabinet interior

The shelves and door compartments are removable and can easily be re-arranged. Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the vegetable drawer must not be moved. They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet, and thus prevent food products from touching the cooling plate.

Dividing plate

The dividing plate separates the chiller compartment from the fridge. The dividing plate features a grille that can be opened and closed to control the amount of cold air entering the chiller compartment. When the grille is opened, the chiller compartment will become colder.

Zanussi 818 14 54-03/7

+ 14 hidden pages

Zanussi ZCR 135R User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual