Zanussi CL 50 SI User Manual

REFRIGERATOR

CL 50 SI

2222634-01

INSTRUCTION BOOKLET

Instructions for the User

Important Safety Instructions 3 Description of the Appliance 4 Operation 5

Before use 5 Setting the temperature 5 Fresh food refrigeration 5 Normal Operating Sounds 5

Health and Safety Guidelines 6 Defrosting 6

Maintenance and Cleaning 7

Internal cleaning 7 External cleaning 7 Changing the light bulb 7 When the appliance is not in use 7

Something Not Working? 8 Service and Spare Parts 9 Customer Care Department 9 Guarantee Conditions 10

Instructions for the Installer

Technical Specifications 11 Installation 11

Positioning 11 Door reversal 12

Electrical Connection 13

CONTENTS

must therefore only be carried out by authorised technicians.

■ Take utmost care when handling your

appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages.

■ The appliance must not be located close to

radiators or boilers.

■ Avoid prolonged exposure of the appliance to

direct sunlight.

■ Do not use other electrical appliances (such as

ice cream makers) inside of refrigerating appliances.

During Use

■ This appliance is designed for domestic use only,

specifically for the storage of edible foodstuffs. It is not intended for commercial or industrial use.

■ Attention! The worktop of this appliance is heat

resistant at max 70°C.

■ Containers with flammable gases or liquids can

leak at low temperatures. Do not store any containers with flammable materials, such as spray cans, fire extinguisher refill cartridges etc. in the refrigerator.

Maintenance and Cleaning

■ Before cleaning, always switch off the appliance

and disconnect from the electrical supply.

■ When unplugging always pull the plug from the

mains socket, do not pull on the cable.

Servicing

■ This product should be serviced by an authorised

engineer and only genuine spare parts should be used.

■ Under no circumstances should you attempt to

repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre.

At the end of the Appliance Life

■ When disposing of your appliance use an

authorised disposal site.

■ Remove the plug and ensure that any locks or

catches are removed, to prevent young children being trapped inside.

IMPORTANT SAFETY INSTRUCTIONS

Prior to Installation

■ Check the appliance for transport damage. Under

no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer.

Installation

■ This appliance is heavy. Care should be taken

when moving it.

■ It is dangerous to alter the specifications or

attempt to modify this product in any way.

■ Ensure that the appliance does not stand on the

electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a cable available from the manufacturer or your local Service Force Centre.

■ Any electrical work required to install this

appliance should be carried out by a qualified electrician or competent person.

■ Parts which heat up should not be exposed.

Whenever possible, the back of the appliance should be close to a wall, but leaving the required distance for ventilation, as stated in the installation instructions.

■ The appliance should be left for 2 hours after

installation before it is turned on, in order to allow the refrigerant to settle.

Refrigerant

■ The refrigerant isobutane (R600a) is contained

within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable.

■ During transportation and installation of the

appliance, be certain that none of the components of the refrigerant circuit become damaged.

■ If the refrigerant circuit should become damaged:

- avoid open flames and sources of ignition.

- thoroughly ventilate the room in which the appliance is situated.

Child Safety

■ Do not allow children to tamper with the controls or

play with the product.

■ There is a risk of suffocation! Keep packaging

material away from children!

General Safety

■ This appliance contains hydrocarbons in its

cooling unit; maintenance and recharging

These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department.

DESCRIPTION OF THE APPLIANCE

➀

Dairy compartment

➁

Can storage shelf with

egg tray

➂

Bottle storage shelf

➃

Salad bin

➄

Glass shelf (for storing fresh

meat)

➅

Storage shelves

➆

Thermostat control

➀

➁

➂

➃

➄

➅

➆

Before use

Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.

Setting the temperature

The temperature inside the refrigerator is regulated by a thermostat control knob with 6 temperature positions and one «OFF» (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat control knob to the required position. An intermediate position is usually the most suitable, although the temperature will be affected by:

Room temperature

How often the door is opened

How much food is stored

Position of the appliance

In determining the correct temperature control setting all these factors have to be considered and some experimentation may be necessary. When altering the temperature setting, allow 24 hours for the temperature to stablise before making further changes.

Important During prolonged periods of abnormally hot

weather, if the thermostat is set on too high a number, the cooling system may operate continuously and the fridge cooling plate may not defrost. Turning the knob to a lower number will cause the automatic defrosting to resume. If you wish to return to a lower temperature, turn the thermostat knob to a higher number, however you should turn the setting lower occasionally to allow automatic defrosting.

Fresh food refrigeration

To obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Do not cover the shelves with any protective material, such as paper, cardboard or plastic, which may obstruct the air circulation through them.

OPERATION

To help you use your refrigerator correctly, here are some more useful hints:

Raw meat (beef, pork, lamb & chicken or poultry):

wrap in polythene bags and place on top of the salad bin.

Meat can only be stored safely in this way for one or two days at the most.

Fruit & vegetables: these should be thoroughly

cleaned and placed in the bottom salad bin. Butter & cheese: these should be placed in special

airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible.

Milk bottles: these should have a cap and should be stored in the bottle rack on the door.

The walls of the refrigerator are equipped with runners so that shelves can be positioned as desired.

Normal Operating Sounds

You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate.

When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor.

A thermostat controls the compressor, and you will hear a faint ‘click’ when the thermostat cuts in and out.

D040

+ 11 hidden pages