Zanussi CH6029G User Manual
INSTRUCTION BOOKLET
INTEGRATED
COOKER HOOD
CH 6029 GR
Thank you for buying a Zanussi product.
To enable you to use your appliance effectively and safely, please read this instruction book carefully before using
the appliance and retain for future reference. If you require guidance in the use of the appliance or require further
information on Zanussi Products, please contact our Customer Care Department. For general enquiries concerning
your Zanussi appliance or for further information, visit our website at http:\\www.zanussi.co.uk
Customer Care Department
Zanussi
55-77 High Street
Slough
Berkshire Tel: 08705 727727(*)
SL1 1DZ Fax: 01753 538972
* calls to this number may be recorded for training purposes.
To register ownership, please ensure you complete and return the guarantee card supplied with the appliance.
For the User
Important Safety Information
Your Appliance
Cooker Hood Controls
To Operate
Recirculation
Extraction
Maintenance and Cleaning
External Cleaning
Charcoal Filters
To Remove the Charcoal Filters
Synthetic Grease Filter
To Remove the Grease Filter
Changing the Light Bulb
Something Not Working
Service and Spare Parts
Peace of Mind for Twenty Four Months
Standard Guarantee Conditions
For the Installer
Installation Instructions
Technical Information
Electrical Connections
Electrical Requirements
Electrical Connection
Installing the Cooker Hood
Installation Requirements
Ducting
Clearance Height
Unpacking
Fixing the Cooker Hood into the Housing Canopy
Positioning of the Cooker Hood
Venting
Recirculation Mode
Inserting The Charcoal Filters
Extraction Mode
Ducting
Guide to use the instruction book
The following Symbols will be found in the text to guide you through the instruction book
Safety instructions Step by step instructions
2
3
IMPORTANT SAFETY INFORMATION
These warnings are provided in the interests of your safety. Ensure that you understand them
all before installing or using this appliance. Your safety is of paramount importance. If you are
unsure about any of the meanings of these warnings contact the Customer Care Department.
■ Installation
• Any installation work must be undertaken by
a qualified electrician or a competent
person.
• This hood must be installed in accordance
with the installation instructions and all
measurements must be adhered to.
• If the cooker hood is installed for use above
a gas appliance then the provision for
ventilation must be in accordance with the
Gas Safety Codes of Practice BS.6172,
BS.5440 and BS.6891 (Natural Gas) and
BS.5482 (LP Gas) 1994, the Gas Safety
(Installation & Use) Regulations, the Building
Regulations issued by the Department of the
Environment, the Building standards
(Scotland) (Consolidated) Regulations
issued by the Scottish Development
Department.
• The fan motor of this cooker hood
incorporates a cut-out device which will
operate if the cooker hood is installed below
the minimum height recommended under
section ‘Clearance Height’, or if the motor
becomes overheated. If the cut-out device is
activated, switch off the fan motor and allow
the cooker hood to cool. The cut-out device
will reset itself when the fan motor has
cooled significantly.
• It is dangerous to alter the specifications or
modify this product in any way.
• When installed between adjoining wall
cabinets the wall cabinets must not overhang
the hob.
• If the room where the hood is to be used
contains a fuel burning appliance such as a
central heating boiler then its flue must be of
the room sealed or balanced flue type.
• If other types of flue or appliances are fitted
ensure that there is an adequate supply of air
to the room.
• The ducting system for this appliance must
not be connected to any existing ventilation
system which is being used for any other
purpose.
• Do not install above a cooker with a high
level grill.
■ Child Safety
• This appliance is designed to be operated by
adults. Children should not be allowed to
tamper with the controls or play with the
appliance.
■ During Use
• This product is for domestic use only.
• Never leave frying pans unattended during
use as over-heated fats and oils might catch
fire.
• Never do flambé cooking under this cooker
hood.
• Do not leave naked flames under the hood.
■ Maintenance and Service
• This appliance can be a hazard if the
synthetic paper and charcoal filters are not
replaced as recommended.
• Under no circumstances should you attempt
to repair the appliance yourself. Repairs
carried out by inexperienced persons may
cause injury or more serious malfunction.
Refer to your local Zanussi Service Force
Centre. Always insist on genuine spare
parts.
4
YOUR APPLIANCE
OPERATING INSTRUCTIONS
The cooker hood is designed to extract
unpleasant odours from the kitchen, it will not
extract steam.
To obtain the best performance it is advisable
to switch on the hood a few minutes before
you start cooking and leave it running for
approximately 15 minutes after finishing.
Cooker Hood Controls
The cooker hood functions are controlled by
two slide switches, located centrally in the
front edge of the metal grille panel.
L. Light ON/OFF control
V. Fan Speed Control
Position 0 - Off
Position 1 - Low
Position 2 - Normal
Position 3 - Boost
To Operate
Select the required functions.
5
The appliance can be installed to recirculate
or extract contaminated air. The cooker hood
is more effective when used in the extraction
mode.
Extraction
In the extraction mode the contaminated air
enters the cooker hood, passes through the
grease filter and out through the ducting to the
atmosphere.
Recirculation
In the recirculation mode contaminated air is
passed through the charcoal filter to be
purified and recirculated into the kitchen
through a recirculation grille. Ensure the
charcoal filters are in position.
When the ducting position is selected
the charcoal filters are not required.
Never do flambé cooking under this
cooker hood.
Never leave frying pans unattended
during use as over-heated fats and oils
can catch fire.
Do not leave naked flames under the
cooker hood.
Ensure heating areas on your hob are
covered with pots and pans when using
the hob and cooker hood
simultaneously.
6
MAINTENANCE AND CLEANING
Before carrying out any maintenance or cleaning
isolate the cooker hood from the mains supply.
The cooker hood must be kept clean, as a
build up of grease or fat can be a fire hazard
The external surfaces of the hood should be
cleaned regularly. Wipe the cooker hood
frequently with warm soapy water using a mild
detergent. Dry thoroughly after cleaning.
Always wear protective gloves when
cleaning the hood.
Never use scouring pads or abrasive
cleaners.
Never use excessive amounts of water
when cleaning particularly around the
control panel.
To obtain the best results from your cooker
hood, replacement of the grease filter(s) will
ensure good performance and reliability, while
extending the working life of the hood.
Charcoal Filter
The charcoal filters absorb the odours from
cooking. They will slowly become saturated
and gradually less effective.
The charcoal filters cannot be cleaned, we
recommend they are replaced every 3-6
months or more often if the hood is used for
more than 3 hours per day.
K
To Remove the Charcoal Filter
1. Remove the lower grille, supporting the
grille with one hand and draw down
on the two grey handles (located on
each side of the grille).
2. The charcoal filters are handed
and should be fitted one at a time.
3. Insert one end of the filter into the
slots in the fan housing then lower
the other end until the tab engages
the slot in the casing.
7
Synthetic Grease Filter
The grease filter has saturation indicators,
which are small squares made from a series of
dots. When the white paper inside the squares
becomes saturated with grease the coloured
dots start to run and spread across the paper,
indicating that the filter has reached saturation
point and must be replaced.
The synthetic grease filter
cannot be cleaned.
It must not be washed.
K
To Replace the Synthetic
Grease Filter
1. Remove the lower grille.
2. Push the wire retaining clips to the
side and remove.
3. Clean the metal grille and clips before
replacing the paper grease filter.
The clips have sharp points, handle with
care and keep away from children.
This appliance is a possible fire
hazard if the grease and charcoal
filters are not replaced as
recommended.
Changing the Light Bulb
The bulb should be replaced with a 220-240
volt 40 watt clear cylindrical shape bulb with a
small Edison (E14) screw thread.
Replacement filters, and light bulbs can be
obtained from your local Service Force Centre.
Loading...