Mobile Power user manual
BT-03
Bluetooth headset function specification
Product specification：
The bluetooth specification：2.0+EDR
一：Charging instructions
Charging instructions when the light is red
Fully charged when the red light, bright blue light
二：Switch machine (button function: switch machine, answer, disconnect,
resisted）：
Long press Boot button for about 5 seconds, until the red and blue
flashing, enter into the state of pairing.
Long press Button for about 5 seconds to turn it off.
三：Bluetooth headset and phone connection：
1. Long press Boot button for about 5 seconds, until the red and blue
flashing, enter into the state of pairing.
1. Open the phone bluetooth search for bluetooth devices。
2. When the mobile phone search to BT - 03 equipment, selected the
headphones.
3. If the match is not successful, repeated operation, only need to match at a
time.
If the pairing is successful, the headset will flash blue lights, at this time to
enter standby mode, you can press dial/answered the phone
四：Answering the phone:
Click on the headset Button realize answer function.
五：Hang up the phone:
Press on the phone hang up or press on the headset The key end
call
六：Refuse to answer：
1. According to the phone Hang up the key
2. When the phone rang up and continue to hold on the headset The
button about 1 second, realize hang up function.
七：call：
1． Use a mobile phone keyboard input dial number, and then click
The key, the call is automatically transferred to the headset.
Mobile power supply part of the electrical parameters
1. Charging input DC5V 1.5A
2. The output DC5V 2.1A
3. Insert the bluetooth headset charging automatically and display power
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any
other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...