ZAIXING ELECTRONIC 82007 Users Manual

Congratulations! You're the proud owner of a Gemmy Incredible
Light Show. Please read over the directions carefully before
using your Gemmy Incredible Light Show.

CAUTION: Do not attempt to assemble or operate your Incredible
Light Show during unusually strong winds. If it becomes too
windy for safe operation, please disassemble your Incredible
Light Show and bring indoors until conditions improve.

Remove all plastic fasteners and tags. These are part of the
packaging and should be discarded.

Contents: [SHOW DIAGRAMS OF EACH ITEM]
Base 1pc
Base Screws 4pcs
Incredible Light Show (collapsed) 1pc
Inner Poles - separated 3pcs
Control Box / Speaker Hook 1pc
Base Anchor Stakes 4pcs
Control Box 1pc
Speaker 1pc
Nylon Tethers 4pcs
Tether Stakes 4pcs
Wireless Remote 1pc
AAA Batteries 3pcs
AC Adapter 1pc
Input: 120V – 60Hz 270mA
Output: 24V – 20VA

Assembly Instructions:

1. Remove contents from packaging. Lay out Base in a clear

and flat area.

2. Insert the small Base Anchor Stakes through the holes

within the bottom of the Base and into the ground.

3. Assemble Inner Poles by sliding the ends into the provided

shafts to create one long Inner Pole.

4. Turn the collapsed Incredible Light Show on its side and

insert the Inner Pole through all three center holes and
into slot under the star at the top of the tree.

5. Place the Inner Poles thru the Incredible Light Show to

extend it to full height. Carefully lift the Incredible
Light Show upright and set into anchored Base. Please note
this action may require 2 persons.

6. Secure Inner Pole to base by inserting Base Screws into the

provided holes. Tighten Base Screws to create a tight, snug
fit so that the Incredible Light Show stands upright and
does not lean.

1

7. Attach the Hook onto the center pole. We recommend you

place the Control Box/Speaker Hook at the top of the lowest
pole. Tighten screws to secure the hook on the pole.

8. Attach the Speaker by hanging it to the Inner Pole facing

out. Close the clasp on the back which secures the speaker
onto the Inner Pole.

9. Attach the Control Box by hanging it to the Inner Pole,

opposite the speaker. Close the clasp on the back which
secures the Control box onto the Inner Pole.

10. Connect the Speaker cable to the cable coming from the

Control box.

11. Attach the hooks located at the end of the Nylon Tethers to

the ridge of the plastic Star mount at the top of the
Incredible Light Show. Attach other end of Nylon Tethers to
the Tether Stakes. Drive Tether Stakes into ground so that
the Nylon Tethers are taut.

12. Attached the AC adapter cord as shown. Then plug the UL

Listed adapter into the power source. This power unit is
Intended to be correctly oriented in vertical or floor mount
position.

13. Place the 3xAAA batteries inside the remote control.

14. Resetting the Remote Control -Before activating your

Incredible Light show you must reset both the Control box
and the Remote Control. Follow the easy steps listed below.

a. Press the reset button on the Control Box. This will

activate a flashing LED for approximately 2 minutes.

b. During this time period, use a ball point pen or other

blunt object to press the reset button located on the back
of the remote control.

c. Once these actions have been taken, you may now proceed to

play your Incredible Light Show.

Do not attempt to operate your Incredible Light show in the
following conditions:

1 During inclement weather conditions such as heavy

rains and wind storms, store the product indoors.

2 Operation of your Incredible Light Show during extreme

weather conditions is not recommended.

2