Zagg I10REU-BBU User Manual

Rugged Messenger

Keyboard Instructions

See the important Health and Safety information on page 8 before using this product.

Warranty Registration
Your ZAGG Rugged Messenger™ comes with a one-year manufacturer’s warranty. In order to
activate the warranty, you must register your Rugged Messenger as well as keep your purchase
receipt. If you purchased your Rugged Messenger from ZAGG.com, ZAGG has already registered it
and has a copy of your proof of purchase.

NEED MORE HELP? PLEASE SEE OUR FAQ SECTION AT: www.zagg.com/faq

INSERTING/REMOVING YOUR DEVICE

Because the power and volume control buttons on your
device sit higher than on other devices, please take extra
care when inserting it into the Rugged Messenger cover.
To do this, follow these instructions:

1. Insert your device at an angle such that the power
and volume control buttons fit into their respective
cutouts on the Rugged Messenger cover.

2. Set the rest of your device into the cover and press
it in. Press all around your device to ensure it has
seated properly.

3. To easily remove your device from the case, separate
the case from the keyboard, and then gently roll the
rubber overmold away from the edges while pressing
the tablet from behind. Grasp your tablet’s exposed
side and lift/pull away from the Rugged Messenger.

USING THE STAND

1. To use the magnetic, built-in kickstand, lift the cover
o the keyboard and lay it flat.

1

2. Place your device in the magnetic recessed groove located in the
middle of your Rugged Messenger where you will feel it connect
with the magnets.

3. While holding your device in place, fold the cover toward your device.
Let the cover fold in along the groove to create the built-in stand.

4. Place the end of the cover close to the top
of your device and you will feel the magnets
connect, securing the stand in place. You
can now rest your device against the stand
for a convenient viewing angle.

ADJUSTING THE VIEWING ANGLE

Your Rugged Messenger case features built-in magnets that work
together with the built-in stand to create multiple viewing angles. To
adjust the viewing angle on your Rugged Messenger, simply slide the
built-in stand up or down along your Rugged Messenger case until you
feel the magnets connect.

Caution: sliding the stand to the very top of the device may result in an unstable position.

POWERING ON AND OFF

1. To turn your Rugged Messenger on, press the Power button located at
the top right corner of the keyboard. The keyboard backlights will turn
on and begin pulsing for about two seconds while the keyboard powers up.

2. To turn your Rugged Messenger o, press and hold the Power button
for three seconds. The keyboard backlights will pulse for about two
seconds and then turn o, indicating your Rugged Messenger has
turned o.

2