Zadro ULT111 User Manual

Z

adro

Zadro

Operating Instructions

Care Instructions

90 Day Limited Warranty

From date of purchase against defects in material

and workmanship. This warranty does not include

damage to the product as a result of misuse or

accident.

Thank you for choosing Zadro Products, Inc.
Visit us on our website.

Huntington Beach, CA 92649
[phone] FAX [phone]
Email: [e-mail]
www.zadroinc.com

ULT111

LED LIGHTED
ULTIMATE MAKE-UP MIRROR

Important Safety Instructions

Should your product become defective during the
warranty period, package the item securely and
return it, prepaid/insured, along with proof of
purchase to: Zadro Products, Inc., Attn: Customer
Service, 5422 Argosy Ave., Huntington Beach, CA

92649. To insure prompt repair, be sure that you
provide complete legible information and a note
indicating the nature of the product defect.

We will repair or replace (at our sole discretion)
your product at no charge.

Please include a $10
(check or money order) to cover return postage and
handling charges. Zadro Products Inc. shall not be
liable for any incidental or consequential damages
arising out of defects in this product, whether or
not caused by its negligence.

Some states do not allow the exclusion or limitation
of incidental or consequential damages or allow
limitations on how long an implied warranty lasts,
so the above limitations or exclusions may not
apply to you. This warranty gives you specic legal
rights and you may also have other rights, which
vary from st

ate to state.

Your ZADRO™ lighted Vanity Mirror is designed for
maximum illumination and performance. Combines

This innovative combination results in a better,
brighter illumination that is both glare and shadow
free.

Your ZADRO™ Lighted Mirror is designed to give you
optimum performance and convenience, if properly
used and cared for.

• Use only a soft, damp cloth to clean product.

•

Always store mirror in the cloth pouch provided with

your purchase.

•

Store out of reach of children in a safe dry location

•

To protect the mirror from dust or dirt, store it in its

original box.

Features

• LED lighted Mirrors provide a 10x -1x Magnication

• Lifetime LED bulb

• Instant on switch

• 360° degree swivel design for easy viewing

• Powered by four (4) AA batteries (not included)

• Optional wall mount

• Includes LCD digital clock alarm

• FREE Travel pouch included

• Sleek design for optimal use of space and easily folds

for travel

Rev. 03012011

Z

adro

Zadro

Important Safety Instructions

DANGER/WARNING

User Operating Instructions

Clock Operation

Clock Battery Replacement

Clock battery is located in the extension arm behind clock display
beneath cover held in place by two screws.

To replace the 3 volt lithium battery, rst remove the screws
holding the outer cover and inner contact bar using an
appropriate size Phillips head screwdriver.

Slightly lift the contact bar and carefully remove and replace the
3 volt lithium battery. Replace the contact bar and outer cover
using the respective screws previously removed.

How To Set Clock

To set clock, rst select a function from above list by pressing
the bottom button the number of times described.

To make a change to the selected function, press the top button
until desired value is displayed.

To save the values, press the bottom button to move to the next
function.

After completing all desired changes, press the bottom button
until it is back to where the time is displayed. All changes will be
saved.

Alarm and Chime ON/OFF

Press bottom button once : alarm time will display
Press top button once : alarm and chime on or o

MODE (bottom key)

Press Bottom Button
once : Alarm Mode
twice : Alarm Set Hours (am/pm)
3 times : Alarm Set Minutes (1– 60)
4 times : Date Set Month
5 times : Date Set Day
6 times : Time Set Hours (am/pm & Military)
7 times : Time Set Minutes (1– 60)
8 times : Back to Normal Time Display

Setting (top key)

(In Normal Time Display)
Press Top Button
once : Alarm Time Displays
twice : Date Displays
3 times : Seconds Displays
4 times : Returns to Time Display

Activate Clock

Remove the battery contact insulator by pulling tab protruding
from battery compartment cover.

You will now be able to see both the clock and the light switch. To
operate the light, press the light switch to turn on and o the
surround light. To set or change the clock, use the two buttons
provided. For specic instructions, refer to “How to set the clock”.

To use the mirrors; after extending the unit, lift the top mirror by
placing your thumb or nger on the lower portion of the round
part and lift. Once fully lifted, you are ready to use the magnifying
mirror.

You may use the 1X mirror in its present position, or you may turn
this mirror 180 degrees and lower it back on top of the magnifying
mirror for convenience of use.

This mirror comes with an LED surround light and clock. Both
of these features are best used when the mirror assembly has
been fully extended.

Instructions for extending the mirror:

1. Place the unit on a at, level surface with a minimum 10 inches
of surface area.

2. Locate the tension knob on the base portion of the unit.

3. Position the unit so that the tension knob is nearest to you.

4. The round portion of the unit contains the 10X magnifying
mirror and the 1X-at mirror. At this point the round portion
should be facing upward.

5. Place one hand on the unit’s base at a point farthest from you
and then use the other hand to rmly grasp the round portion
of the unit near the base.

6. Lift the round portion upward and toward you until you have
attained the desired angle and height you desire.

7. While continuing to hold the base unit with one hand, grasp
the lowest position of the round portion of the unit with your
other hand and pull upward to extend the support arm to the
desired height.

8. You may lock the extension arm in place by tightening the
tension knob located in the base unit.

When using an electrical appliance, basic precautions should
always be followed.

To reduce the risk of electric shock never immerse the mirror in
water when cleaning. To reduce the risk of burns, re, electric
shock, or injury to persons be sure to:

PLEASE READ ALL INSTRUCTIONS

BEFORE USING THIS MIRROR

Z

adro

Zadro

CAUTION: DO NOT OVER TIGHTEN THIS KNOB

Rev. 03012011

1. Provide close supervision when this mirror is being used near
children or disabled persons.

2. Use this mirror only for its intended use as described within this
manual. Do not use attachments not recommended by
manufacturer.

3. Never operate this mirror if it is not working properly, if it has
been dropped or otherwise damaged, or submersed in water.
Return unit to manufacturer for examination and repair.

4. Never drop or insert any objects into any opening.

5. Do not use outdoors.

6. Never operate where aerosol (spray) products are being used, or
where oxygen is administered.

7. Be sure mirror is not in a position where it can reect sunlight.
Reected sunlight can cause re.

1. Use only fresh batteries of the required type and size.

2. Do not mix old and new batteries, dierent types of batteries, or
rechargeable batteries of dierent capacities. *(If more than one
is required.)

3. The batteries may explode if mistreated. Do not attempt to
recharge or disassemble the batteries.

4. Depleted batteries are to be removed from the item.

5. Dispose of the old batteries properly, and according to your
local regulations.

6. Ensure that batteries are kept out of reach of young children.

The battery compartment is located on the underneath side of the
mirror. To replace the batteries, use the following instructions:

1. Before attempting to replace batteries, return the mirror to
its compact position.

2. Turn mirror upside-down.

3. Locate battery compartment cover.

4. You will notice an indentation at one edge of the cover, by
placing your thumb in this indentation, pressing forward and
lifting up at the same time, the cover will be released.

5. The compartment holds four (4) AA batteries. All four batteries
must be present and properly positioned for the unit to operate.

6. Once the batteries have been inserted, replace the battery
compartment cover.

7. The mirror is now ready for use.

BATTERY REPLACEMENT

BATTERY SAFETY