YUSUNG C and C UNC 800T User Manual

Mouse

UNC-800 User s Manual

Wireless Wheel & Ball

Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

2

Spaceball Mouse

Low/Hi Power : (Low : 2~3M, Hi : 6~7M) Select, Power Button
Button1 : enter key Button2 : shift key
Wheel : scroll & zoom, page up/down Trackball : move cursor
Battery Holder(Back) : AAA type x 2 Channel Select Button
ID Button : It will be change ID when every short press on it

Receiver

Spaceball operation has verify range depend on the receiver position
because of radio frequency.

Caution : Leave alone in the place where it does not have the metal
material or the interference of the electric wave.

Battery lamp : It will be lighting when the battery low Condition.
Receive condition lamp : It will be lighting when the SPACEBALL work

normally.
ID & Channel Lock lamp : It will be green lighting when the Receiver is
locked by lock button.
ID & Channel lock button : It make lock and unlock ID & Channel.
Button locate Receiver back side. It is useful function when the other
mouse conflict.

Antenna.

NAME OF PARTS

Battery lamp
Receive condition lamp
ID & Channel Lock lamp

3

Install driver in ‘Windows 98/ ME and Windows 2000’

If your computer uses USB port first time, it requires new hardware
information. When a message pops up saying it needs Windows CD for an
update, insert Window Installation CD that comes with your computer
when it was purchased. Then start installing Windows CD, according to the
instruction displayed on your computer. After the installation, check for
‘HID-compatible mouse’ from the mouse icon in the control panel. ‘HID­compatible mouse’ indicates that USB port is activated. Keep ‘Wireless
Mouse Spaceball Installation CD’ handy for installation.

First, hook up Spaceball receiver to USB port.
Insert “Wireless Mouse Spaceball Installation CD” in the CD-ROM

drive. (Upon inserting, the program starts installing itself through
Autorun function.)
Choose between ‘Windows98/ME driver installer’ and ‘Windows 2000
driver installer’ button from the menu bar on the right side of installation
window, depending on your operating system and then click.
Read the explanation on the window, while proceeding the installation.
Reboot your system, when installation is complete.
(After Install finish, you must restart PC)
Once the installation is normally completed, “Spaceball” icon similar to a
dot & battery should be on the left side of the task bar and starting

menu.

HOW TO INSTALL SPACEBALL PROGRAM

Our program CD put on CD driver.
It will start auto-run, you can see Install panel on
monitor
You could click ‘DRIVER SETUP’ and progress
Install

NOTE

- First, check the operating system of your computer
(i.e. \windows 98/ ME/ 2000)

- If your computer uses a USB port first time, it will require hardware information,
when the spaceball receiver connect to USB port to make computer accept
USB port, get the ‘WINDOWS Installation CD’ that came with your computer
ready to activate USB port and then install Spaceball program.