YUNJI INTELLIGENT TECHNOLOGY S1 User Manual
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications or change to this equipment. Such
modifications or change could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Place directly in contact
with transmitter
Place directly in contact
with transmitter
Place directly in contact
with transmitter
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Operation Frequency:
0.112~0.205MHz
Hardware Version: JXW V8 1.1
Software Version: 8709
Environmental Conditions:
Working Temperature 0 ~ 45℃
Hereby, SHENZHEN YUNJI INTELLIGENT TECHNOLOGY CO.,LTD,
declares that this S Wireless Charger / S1, is In compliance with the essential
Requirements and other relevant provisions of RE Directive 2014/53/EU.
Loading...