Yuneec Technology ST16 User Manual
ST16 USER MANUAL
INTRODUCTION
The ST16 is equipped with a touchscreen display that allows for changing
various sengs and viewing real-me telemetry data and streaming video during
flight. The ST16 seamlessly integrates control of the camera so you can easily
take sll photos and start/stop video recording using the corresponding
buons.
OPERATING INSTRUCTIONS:
ST16 AND RECEIVER BINDING
STEP 1): Power on the ST16 and tap “RC” on the main interface
STEP 2): Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.
STEP 3): Tap to create a new model and if required press “OK” to bypass any pop up warnings/alerts.
STEP 4): Tap Flight Sengs and if required press “OK” to bypass any pop up warnings/alerts.
STEP 5): Li the H920 back end upward approximately 45° , then back down to “level” twice ll the
main LED indicator blinks yellow.
STEP 6): Tap the Refresh icon. Select the code of the H920 listed in the column under ”Model” and
tap Bind ,then tap “OK” aer the connecon has been established
STEP 7): When tapping, you will hear two long beeps from the aircra. That means the ST16 is
bound to the H920 successfully.
STEP 8): Tap [ ] twice to return to the main screen and the model /receiver should automacally
connect to ST16
NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS signal
/lock. The H920 main LED indicator will be solid color of the current mode if the GPS signal/lock is
acquired.
ST16 INSTRUCTIONS
CHARGING THE LI-ION ST16 BATTERY
You can charge the ST16 baery by using supplied USB cable and inserng it
into the USB port on the charger. A green blinking LED indicates the charger
is powered on and ready to charge, and a red blinking LED indicates the
baery is charging. It will take approximately 5 hours to charge a fully
discharged (not over-discharged) baery. A solid green LED indicates the
baery is fully charged.
NOTE: The AC plug type will vary depending on the region in which the
product was imported/purchased (AU = Australian; EU = European; UK =
United Kingdom; US = United States).
TAKING PHOTOS AND RECORDING VIDEO
TO TAKE A STILL PHOTO
Press the buon located near the top le corner of the ST16. You’ll hear
an audible ‘shuer’ sound from the ST16 and the LED indicator on the
front of the camera will change from glowing solid green to glowing solid
blue. It will take approximately 1-2 seconds to capture the photo and
before you can take another sll photo.
TO START/STOP RECORDING VIDEO
Press the buon located near the top right corner of the ST16. You’ll hear
an audible indicaon from the ST16 each me the recording starts/stops.
And while video is recording the LED indicator on the front of the camera
will flash blue and green, and there will be a red dot next to the me length
of the recording near the upper right-hand corner on the screen of the
ST16.
Loading...