YULIN TECH WTS 1MSKSERIES User Manual

● Use manufacturer-approved chargers and

accessories.

● Do not touch the device with wet hands.

● Do not slide the charger or device, or cause a

collision.

● Please use the product within the recommended

temperature range if use beyond the

recommended temperature,it will damage the

recommended the life of the product.

● Avoid touching the conductive material, such as

liquid, metal,metal powder, dust and pencil lead

etc.

● Do not allow children or animals to chew or

swallow the charger.

● Do not disassemble, modify, or repair the charger.

● Do not place the Magnetic stripe cards near the

charger, including credit cards,phone cards,bank

card and registration card etc.,magnetic field may

damage the magnetic stripe cards.

Wireless Charger

WTS-1MSK series

User Manual

FCC ID: 2AKDFWTS-1MSKSERIES

14

Input:DC 5V/2000mA

Operation frequency:110KHz～205KHz

Efficiency:>75%

Effective charging distance:2～10mm

Compatible with Qi

Operating temperature:0℃～+40℃

Storage temperature:-20℃～+60℃

ManualUSB cable

Note

● 5V/2000mA adapter is sold seperately.

①:LED

①

②

②:Charging area

③

③:Bracket

④

④:Power Input Port

23

①②

③

④

1.Connect USB cable to wireless charger；

2.Then connect to 5V/2000mA adapter；

3.Take out bracket and instert it to the

rectangular slot；

4.Place the mobile device which supports

wireless charging on the proper charging

area of wireless charger.

● Only using the adapter which output

Note

is 5V/2000mA or higher.

● When charging fully, remove the mobile

device from wireless charger.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

This device complies with Part

15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

The EUT meets the RF Exposure requirement.