Yukon Advanced Optics 26041 User Manual

* Maximum distance at which a human figure can be recognized under ideal viewing conditions; defined as
clear conditions (no fog, dust, etc.) under the light of 1/4 moon (5x10-2 lux minimum).

OVERVIEW

NVMT 5 Riflescope Kit - is a device that can be used as a night vision monocular or a riflescope. A
dot of a laser pointer is used as an aiming reticle of the device. With the laser pointer installed on the night
vision or the rifle can be used independently during the day. Night vision monocular has high illuminative and
high magnification power. With rifle eyepiece and rifle mount in place, the device can be used as a night vision
riflescope. The kit allows NVMT to be used in many situations and for a range of purposes. The NVMT 5
scope is ideal for a wide variety of professional and recreational uses including:

• Wild life observation

• Search and rescue

• Night hunting and fishing

• Nighttime photo / video

• Equipment Maintenance

WARNINGS AND PRECAUTIONS

The NVMT 5 night vision scope was designed to provide many years of reliable service. To ensure
that you get the most enjoyment out of your NVMT 5 always obey the following Warnings and Precautions:

• Do not point the NVMT 5 towards any light source greater than 1 lux. (car headlights, sun,

bright lamp, etc.) for an extended period of time. The NVMT 5 utilizes an internal flash protection system,
which minimizes potential damage, but long-term exposure to bright lights can damage the unit. Any damage
from user mistreatment will void the warranty.

• The NVMT 5 was designed to be self-contained. Do not open the body of the scope or

otherwise attempt to service this device.

• Always store the NVMT 5 in a dry, well-ventilated room.

• Keep the NVMT 5 away from any heating and air conditioning vents or other heating devices.

• Keep the NVMT 5 out of direct sunlight, dust and moisture. Additional precautions include

avoiding any sudden or extreme temperature changes.

• Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, the

NVMT 5 incorporates a sophisticated optical system, which can be damaged if misused.

Damage to this device from failure to observe these warnings may void the warranty!

BATTERY INSTALLATION

Your NVMT 5 runs on one battery - 3V Lithium CR123A. To install, unscrew the battery
compartment cover, insert the battery into the battery compartment so that the positive (+) and negative (-)
terminals of the battery match the markings inside the compartment. Replace the battery cover carefully. Do
not over tighten.

Unscrew the Laser Pointer battery compartment cover (6), insert the PX28L battery into the battery
compartment so that the positive (+) and negative (-) terminals of the battery match the markings inside the
compartment. Replace the battery cover carefully. Do not over tighten.

USE AND TESTING

A. Monocular (See Figure 1)

Your NVMT 5 operates using one CR123A battery. Make sure it has been installed according to
instructions found in the Battery Installation section of this manual.

• If you wish to test your night vision device in a lighted area, be sure the lens cap is in place prior

to pressing the “ON” button. The lens cap has a pinhole opening to admit a small amount of light for testing
purposes.

• Move into a dark area before activating the NVMT amplifier.

• Remove the lens cap (1) and store in pocket provided.

• Activate the device by pushing the “ON” button (2).

• If the subject to be viewed is in a completely dark area, including low light shadow areas, activate

the infrared illuminator by pressing the “IR” Button (3) located next to the “ON” button.