· Observation in natural environment
· Tourism
· Sporting events
· Search and rescue
· Equipment maintenance and repair
Your NVMT SPARTAN night vision scope was designed to provide many years of reliable service. To
ensure that you
get the most enjoyment out of your NVMT SPARTAN always obey the following Warnings and
Precautions:
· Do not direct a unit in the “on” position at intense sources of light, such as car's headlights or
burning fire. This may disable the unit for an unknown length of time or cause a dark spot in
the center of the field of view. Do not turn the unit on in daylight without the protective cap
firmly secured over the objective lens, as this may damage the unit. Any such damage may void
your warranty.
· Never leave the unit in the “on” position over an extended length of time in an area with a light
level exceeding 1-10 lux (twilight - 10 lux, deep twilight - 1 lux). Please keep the protective cap
on the objective under greater light level.
· Your NVMT SPARTAN was designed to be self-contained. Do not open the body of the scope
or otherwise attempt to service this device. If such need arises return the unit for replacement
or repair.
· Keep the NVMT SPARTAN away from dust, moisture and sudden temperature drop.
· Do not subject the unit to water drops and splashes, do not put water reservoirs on the device.
· Avoid dropping or otherwise shocking the unit. NVMT SPARTAN incorporates a sophisticated
optical system which could be damaged in extreme cases of misuse.
Damage to this device from failure to observe these warnings may void the NVMT SPARTAN's warranty!
BATTERY INSTALLATION
Your NVMT SPARTAN runs on a single CR123A battery. To install, unscrew the battery compartment
cover, insert the battery into the battery compartment observing the marking on the cover of the
battery compartment, replace the battery cover carefully. Do not overtighten.
USE AND TESTING
Make sure the battery has been installed according to instructions found in the battery installation
section of this manual.
· If you wish to test your night vision device in a lighted area, be sure the lens cap is in place
prior to pressing the “ON” button. The lens cap has a pinhole opening to admit a small
amount of light for testing purposes.
· Move into a dark area before activating the NVMT SPARTAN light amplifier.
· Remove the lens cap (1) and fasten it to the body as shown in the picture.
· Activate the device by pushing the "ON" button (3).
· Direct the turned on unit at an object at a distance of around 30m. Rotating the eyepiece (4),
focus on the tube's screen — rough surface or tiny dark dots are visible. Rotate the objective
lens (5) until the image quality is optimal. Re-focus the eyepiece, if necessary. After this
adjustment you may not rotate the eyepiece irrespective of the distance and objective lens.
· Direct your NVMT Spartan at an object to be viewed and adjust the final focus by rotating the