Youngshin Electronics JR200AMEN Users Manual
USER’S GUIDE
By Youngshin Electronics Co., Ltd.
www.magicar.com
FCC ID : O44JR200AMEN
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION :
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this device.
User’s GUIDE
TABLE OF CONTENTS
Safety Information
Remote : R200
Remote Button Functions
Remote Learning Routine
Keyless Entry
Alarm Mode
Trunk Release
Panic Mode
Valet Mode
Optional Programmable Features
Ignition Lock
Passive Locking
Optional Installation Features
Door pulse Duration
Flashing Signal Light
Anti-jacking
Page 4
Page 4
Page 5
Page 5
Page 6
Page 6
Page 7
Page 7
Page 7
Page 8
Page
8
Page
8
Page
8
Page 8
Page 8
Page 8
Page 3
User’s GUIDE
The model name, R200 stands for
One Way AM 4 Button Remote.
Safety Information
Please take these safety precautions into consideration, under the following conditions :
Page 4
1. Servicing the vehicle
When servicing your automobile (i.e. changing the oil, washing your car), the
Magicar system should be in Valet Mode.
2. Loaning your vehicle to others
Whenever you loan your vehicle to an individual who is not familiar with Magicar,
please put the vehicle in Valet mode. This will prevent the vehicle barrower from
accidentally activating the Magicar auto-security system.
Remote
Page 5
Remote Button Functions
1
2
3
4
5
6
7
8
9
10
Lock0.5 sec
0.5 sec
0.5 sec
0.5 sec
Unlock
Button Press Function
2 sec
Panic, Press Lock to shut off Siren
Valet Mode - on/off
Siren Chirps for Lock /Unlock - on/off
0.5 sec
Ignition Lock - on/off
0.5 sec
Passive Arming - on/off
0.5 sec
Shock Sensor - on/off
2 sec
Trunk Release
2 sec
Programming Menu - Installer Only
Note : ""
Means pressing the button for 2 seconds.
"
()"Means simultaneously pressing the buttons.
"
()"Means simultaneously pressing the buttons for 2 seconds.
Remote Learning Routine
The Magicar will allow up to three remotes to be programmed to one vehicle.
Please perform the following procedure to add or reprogram additional remotes.
Step1:
Activate Valet/ Programming mode by manually
turning the ignition on and off three times
(between Acc and
On)
with the key within a 7 second period.
The parking lights will flash once with successful completion of
this step.
Loading...