York 69-1659 UV100A User Manual
UV100A Ultraviolet
Air Treatment System
OWNER’S GUIDE
® U.S. Registered Trademark
Copyright © 2002
All Rights Reserved
69-1659
UV100A ULTRAVIOLET AIR TREATMENT SYSTEM
HOW YOUR ULTRAVIOLET AIR TREATMENT SYSTEM WORKS
When installed in forced air heating and cooling systems, your UV100A Ultraviolet Air
Treatment System kills a high percentage of micro-organism contaminants in the air
passing over it. Individual results depend on how carefully all installation and
maintenance requirements are followed and on the actual amount of time your air
delivery fan operates.
You can capture and minimize micro-organism pass-through in your heating,
ventilation and air conditioning (HVAC) system when you combine your Ultraviolet Air
Treatment System with a high-efficiency air filtration system that includes an electronic
air cleaner. Talk to your installer about adding an electronic air cleaner to complement
your air treatment system and provide added protection for you and your family.
Your UV100A Ultraviolet Air Treatment System unit is one of these three models: a
single-lamp, medium-efficiency return air unit; a dual-lamp high-efficiency return air
unit; or an air conditioner coil irradiation unit.
• The UV100A coil irradiation unit is mounted in your supply side air duct or
downstream from the air conditioner cooling coils in your HVAC system. The single
lamp reduces mold and spores on duct surfaces, coils and drain pans.
69-1659 2
UV100A ULTRAVIOLET AIR TREATMENT SYSTEM
HOW YOU CAN CHECK YOUR ULTRAVIOLET AIR TREATMENT SYSTEM OPERATION
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated.
Only view illumination by way of the light indicator located on the lamp knob.
To prevent exposure to ultraviolet light, disconnect power to the ultraviolet air
treatment system before servicing any part of the heating/air conditioning
system.
Do not mount device in location that allows ultraviolet light to be seen after
installation.
Do not attempt to bypass the duct mount switch.
Do not attempt to open housing; unit is sealed to prevent ultraviolet light
exposure.
Your Ultraviolet Air Treatment System has a power cord that plugs into a 120 Vac
electrical outlet. Your unit is designed to prevent accidental contact with the voltage
and with the ultraviolet rays in the sealed unitthe ultraviolet lamps do not illuminate
unless the base is mounted on the HVAC duct.
It is recommended that every month you verify that your ultraviolet lamp(s) are
operating only by viewing through the lamp light indicator on the lamp knob. Do not
attempt to look into the duct at the illuminated lamp(s).
3 69-1659
Loading...