Yetter 2910 Series Spring Cushioned Plow Coulter User Manual

Loading...

2900 SERIES RIGID PLOW COULTER

PARTS & INSTALLATION

INSTALLATION AND OPERATING INSTRUCTIONS

Caution: COULTER BLADE HAS SHARP EDGE.

!USE CARE WHEN WORKING WITH OR CLOSE TO BLADES

The 2900 series coulter comes to you partially assembled. Remove any burrs from the lower end of your round shank and install any sleeves needed to fit shank tube into shank. (Shank tube is designed to fit 1-1/2” SHANK. Sleeve number 2900-111 is to be used for 1-3/8” shanks and numbers 2900-110 and 2900-111 both must be used on 1-1/4” shanks. Shank sleeves are not included in the units above. Please order sleeves separately.)

NOTE: Sleeves or shank tube must fit above retainer pin or cotter key in your shank. If none exists in your shank, drill a 5/16” or larger hole in your shank to accommodate a cotter key.

Place the coulter and locking collar over the shank (and sleeves, if used) then insert pin through the retainer hole. After aligning coulter for proper position, tighten setscrew in locking collar in center of slot in hinge casting for maximum swivel.

The Yetter coulter is equipped with automotive type tapered bearings; and are pre-lubricated during assembly. Grease the hub assembly periodically during use.

PERIODICALLY CHECK NUTS TO BE SURE THEY ARE TIGHT.

2910 AND 2900 SERIES HUB ASSEMBLIES

+ 1 hidden pages