Yerasov OD-10B User Manual

YERASOV MUSIC CORPORATION

www.yerasov.ru e-mail: [e-mail]

Guitar pedal

BASS
OVERDRIVE OD-10B

5

LEVEL

BLEND

CONTOUR TONE

GAIN

FAT BOOST

OFF ON

User manual

FOR NOTES

PACKAGE CONTENTS

Guitar pedal OD-10B, pcs.................................................1

User Manual, pcs..............................................................1

SPECIFICATIONS

Power supply (battery / DC), V...........................…............9

Current Draw, mA..........................................................6,5

Dimensions, mm...........……...…......................112õ62õ50

Weight, kg...................................................................0,25

LEVEL

BLEND

CONTOUR TONE

GAIN

FAT BOOST

OFF ON

21

44

3

OD-10B is a bass overdrive effect. Its thick and

punchy tone goes well together with different bass
guitars, letting to tint the sound a little bit, or to overdrive
the channel significantly, and that will be useful for
modern extreme music players. Pedal is designed for a
variety of music styles and can be used with any bass
guitar, up to 5 and 6 string instruments.
OD-10B is assembled of the newest electronic
components: high-precision resistors, low leakage
current electrolytic capacitors.
The pedal is applied foot switch ALPHA real TRUE
BYPASS.

1 - output Jack

- dry/overdrive balance control

3 - LEVEL - output level control

- mid freq. control

5 - DC in

- on/off indication

7 - - low boost switch
8 - GAIN -
9 - tone control
10 - input Jack

11 - on off button effect

2 - BLEND

4 -

6

FAT BOOST

TONE -

CONTOUR

distortion level control

/

>

>

74

5

6

10

11

8

3

9

2

DC 9V

?When you turn on the pedal led indicator illuminates.

Obtain the needed sound turning the TONE, BLEND,
CONTOUR and GAIN knobs, and then adjust overall
volume with a dedicated knob with the effect turned on.
CONTOUR knob is used to scoop mid-frequencies for a

warmer tone. CONTOUR also affects the level of low
frequencies – if you feel lack of those, just use the function
FAT BOOST to raise them up.
Attention! Due to the circuit design if a GAIN or VOLUME
knob is set to zero position, no sound goes from the pedal.

1

OD-10B

AD9-100

>

The power of guitar pedals OD-10B : a battery of type
6F-22, which is installed under the bottom cover pedal, or
from an external source of stabilized voltage 9V.
In order to avoid the background, use only adapters
AD9-100 or AD9-500 firms YERASOV.
Turn on the power from the battery when joining plug
type Jack (mono) input Jack, so for extended battery life,
do not leave the Jack in the input connector, if you are not
using the device.

?Connect the AC adapter to the Jack or install the

battery.

?Connect the pedal according to the picture. Connect the

output of the pedal to the entrance combo-amplifier.

?Turn on the combo-amplifier.
?For the effective operation of the product, set the control

of the output signal of Your guitar at maximum.

USE THE PEDAL WITH SCS PEDAL BOARD

The pedal is compatible with SCS Pedal Board.
Connector for SCS is located on the bottom cover of the
pedal body. Connect the pedal to the Pedal Board is a
special cable that comes with the SCS Pedal Board. For
more deta iled instruction s, pl ease visit to site
www.yerasov.ru.

The battery compartment is located underneath the
pedal cover. To replace the battery, remove the cover by
unscrewing the 4 screws. Replace the battery and replace
the cover.

REPLACEMENT BATTERY

?Avoid storing or operating the unit in humid conditions

(not above 80%).

?After storage or transportation at a low temperature

before turning on unit shall be stored at room temperature
for at least 2 hours.

?Protect the device from falls, bumps, to get into foreign

objects, liquids, dirt and rain.

PANEL DESCRIPTION