Yeoman ELEGANCE BY HAAS & SOHN 210, ELEGANCE BY HAAS & SOHN 200, ELEGANCE BY HAAS & SOHN 220, ELEGANCE BY HAAS & SOHN 240, ELEGANCE BY HAAS & SOHN 250 Installation, Service And User Instructions Manual
...
Elegance by Haas & Sohn
This product is for use only in Great Britain and Ireland (GB, IE)
These instructions are to be left with the customer, should be read
carefully and kept in a safe place.
They will be necessary when servicing the appliance.
PM173 Issue 4 (February 2009)
2
Welcome to Yeoman 3
Commissioning Data 4
Technical Specification 5
SITE REQUIREMENTS
Stove Dimensions 6
Hearth Dimensions 8
Walls adjacent to Hearths 8
PRE-INSTALLATION CHECKS
Flue or Chimney 9
Additional Ventilation 10
INST A L L ATION INSTRUCTIONS
Installing the Stove 11
Commissioning 12
OPERATING INSTRUCTIONS
General 13
Using the stove for the first time 13
Burning Wood 13
Burning Solid Fuel 14
Ash Removal 14
Recommended Fuels 15
MAINTENANCE AND SERVICING
General Cleaning 16
Cleaning Glass 16
Chimney Sweeping 16
Annual Service 16
Contents
3
Welcome to Yeoman
Your new Elegance multi-fuel stove is perhaps the most
advanced design of modern stoves. Owning such a stove
shows appreciation for exceptional quality.
Please read your manual thoroughly, its purpose is to
familiarise you with your stove, and give guidelines for its
installation, operation and maintenance. If after reading this
manual you need further information, please do not hesitate
to contact your Yeoman dealer.
IMPORTANT NOTICE
If your stove is installed correctly, it will give you many years
of excellent service for which it was designed. This appliance
must be installed by a HETAS registered installer (GB only).
WARNING
All types of heating appliance can be potentially dangerous.
Correct installation and operating procedures must be
observed when fitting this stove. Some parts of your stove are
protected on their surface with heat proof paint. When the
stove is first used it is normal for it to emit some light smoke,
with an unpleasant smell. Though unpleasant, this is non
toxic and is produced only whilst the stove paint fully cures.
We recommend that you ventilate the room until this
disappears.
FOR YOUR RECORDS
YEOMAN DEALER APPLIANCE WAS PURCHASED FROM
Name: ..................................................................................................................................................................................................
Address:...............................................................................................................................................................................................
.............................................................................................................................................................................................................
Telephone number:
....................................................................................................................................................
INSTALLATION ENGINEER
Company name:...................................................................................................................................................................................
Address:...............................................................................................................................................................................................
.............................................................................................................................................................................................................
Telephone number:
....................................................................................................................................................................
ESSENTIAL INFORMATION - MUST BE COMPLETED
Date installed:......................................................................................................................................................................................
Model Description:..............................................................................................................................................................................
Serial number:
..........................................................................................................................................................
COMMISSIONING CHECKS (TO BE COMPLETED AND SIGNED)
Is flue system correct for the appliance YES NO
Flue swept and soundness test complete YES NO
Smoke test completed on installed appliance YES NO
Spillage test completed YES NO
Use of appliance and operation of controls explained YES NO
Instruction books handed to customer YES NO
Signature: ........................................................................................................ Print name:
......................................................
To assist us in any Guarantee claim please complete the following information:-
4
5
4.9 4.9 7 4.9 6 6 8
1.5 1.5 1.5 1.5 1.5 1.5 1.5
0.06 0.06 0.06 0.06 0.06 0.06 0.06
6.3 6.3 6.3 6.8 6.8 6.8 7.4
290 290 290 290 290 290 270
150 150 150 150 150 150 150
6 6 6 6 6 6 6
Top
Only
Top
Only
Top
Only
Top
Only
Top
Only
Top
Only
Top
Only
76 81 85 75 90 103 155
Seasoned wood (less than 20% moisture content).
Briquette smokeless fuel suitable for closed appliances.
(Ancit - Phurnacite - Taybrite - Homere Ovals).
79.1%
79.1% 79.7% 80.7%
80.7%
80.7% 81%
SITE REQUIREMENTS
Before installation of this product please read these
instructions fully.
It is very important to also understand the requirements
of the UK Building Regulations (England and Wales Document J / Scotland - Part F), along with any local
regulations and working practices that may apply. Should
any conflict occur between these instructions and the
regulations then the regulations shall apply.
All electrical connections should meet the requirements
of UK Building Regulations (England and Wales Document P / Scotland - Part N).
Your local Building Control Office would be happy to
advise, should questions arise regarding the requirements
of the regulations.
The Elegance Stove should be fitted by a HETAS (GB
only) registered installer, or approved by your local
building control officer. Your Yeoman dealer should be
able to arrange this service for you.
Your building insurance company may also require you to
inform them that you have installed a new heating
appliance, so check with your insurers that your cover is
still valid after installing the Elegance Stove.
When completing the installation and building works you
should comply with your responsibilities under the Health
and Safety at Work Acts, and any new regulations, which
may be introduced during the lifetime of these
instructions.
A faulty installation could cause danger to the
inhabitants and structure of the building.
6
ELEGANCE STOVE DIMENSIONS
Elegance 200
Elegance 210
Elegance 220
Elegance 240
SITE REQUIREMENTS
7
Elegance 250
Elegance 270
Elegance 280
SITE REQUIREMENTS
8
Additional information covering the installation of the
Elegance stove may be found in the British Standard:
BS8303.
HEARTH DIMENSIONS
The appliance must stand on either a constructional
hearth with the minimum dimensions as shown in
diagram below.
Or a 12mm thick non-combustible board/sheet material
or tiles, of the minimum dimensions shown.
If you are fitting the appliance into an existing hearth
setting, check that it complies with the current
construction regulations and is at least the minimum sizes
shown.
If you have no existing fireplace or chimney, it is possible
to construct a suitable non-combustible housing and
hearth setting. However this should be constructed to
comply with the requirements of both current national
and local regulations with the design approved by your
local building control officer, masonry chimney systems
built with clay or concrete liners or pre-fabricated block
systems should be constructed in accordance with BS
6461 : Part 1. Factory made insulated systems should
comply with BS 4543 : Part 2 and be installed to BS 7566
: Parts 1 to 4.
Remember that any new chimney added to your property
may also require planning permission.
WALLS ADJACENT TO HEARTHS
Location of hearth
or Elegance Stove
Where the hearth
touches a wall and
the Elegance Stove
is not more than
50mm from the
wall
Where the hearth
touches a wall and
the Elegance Stove
is more than 50mm
but not more than
300mm from the
wall
Where the hearth
does not touch a
wall and is no more
than 150mm from
the wall
Thickness (W)
200mm
75mm
75mm
Height (A)
At least 300mm
above the
Elegance Stove
and 1200mm
above the hearth
At least 300mm
above the
Elegance Stove
and 1200mm
above the hearth
At least 1200mm
above the hearth
Solid, non-combustible material
Note: there is no requirement for protection of
the wall where C is more than 150mm
Yeoman Elegance
Wall Thickness W
Solid, non combustable
material e.g concrete or
masonry
150mm
minimum
150mm
minimum
A
C
C
150mm minimum
Constructional
hearth 840mm
minimum
Constructional
hearth 840mm
minimum
Change in level to
mark safe perimeter
225mm
minimum
150mm
minimum
150mm minimum
Loading...